The resistances in Figure (a) and Figure (b) are all 9.0 Q, and the batteries are ideal 38 V batteries. (a) When switch S in Figure (a) belowis closed, what is the change in the electric potential V1 across resistor 1, or does V, remain the same (enter "0")? (b) When switch S inFigure (b) below is closed, what is the change in V1 across resistor 1, or does V1 remain the same (enter "0")?R,3 R2(a)(b)(a) NumberUnits(b) NumberiUnits

Answered: Image /qna-images/answer/0ba757ff-4ca4-49ce-83ee-cdacebff382b.jpg

The resistances in Figure (a) and Figure (b) are all 9.0 0, and the batteries are ideal 38 V batteries. (a) When switch S in Figure (a) below is closed, what is the change in the electric potential V1 across resistor 1, or does V1 remain the same (enter "O")? (b) When switch S in Figure (b) below is closed, what is the change in V1 across resistor 1, or does V1 remain the same (enter "0")? (a) (b) (a) Number Units (b) Number i Units >

The resistances in Figure (a) and Figure (b) are all 9.0 0, and the batteries are ideal 38 V batteries. (a) When switch S in Figure (a) below is closed, what is the change in the electric potential V1 across resistor 1, or does V1 remain the same (enter "O")? (b) When switch S in Figure (b) below is closed, what is the change in V1 across resistor 1, or does V1 remain the same (enter "0")? (a) (b) (a) Number Units (b) Number i Units >

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

In the circuit shown in the figure, the S switch closed at t=0 and the capacitors, which are completely empty, begin to fill. Here ε=10 V, C=5 μF and R=55 Ω. What is the time constant of the circuit, τ, in units of microseconds? When t= τ, what is the total charge, in units of microcoulomb, accumulated in the capacitors?
A capacitor with a capacitance of 3.5 uF is initially uncharged. It is connected in series with a switch of negligible resistance, a resistor with a resistance of 10.5 kOhm, and a battery that has a potential difference of 105V. (a) Immediately after the switch is closed, what is the voltage drop VC, in volts, across the capacitor? (b) Immediately after the switch is closed, what is the voltage drop VR, in volts, across the resistor? (c) Immediately after the switch is closed, what is the current, in amperes, through the resistor? (d) Find an expression for the time after the switch is closed when the current in the resistor equals half its maximum value. (e) What is the charge Q, in microcoulombs, on the capacitor when the current in the resistor equals one half its maximum value.
How many electrons pass through a 20-Ω resistor in 10 min if there is a potential drop of 60.4 volts across it?
In the given circuit, the resistances of each resistor is 5 Ohm. The ideal batteries have EMFS E1= 9V and E2 = 17 V. What is the potential at point P?
Two resistors have resistances R; and Ra, where R; = 4.1R2. When configured in series and connected to a source potential of 31.9 V, they draw 0.780 W of power. If their configuration is changed to be in parallel and the source potential remains the same, what power does the circuit draw?
A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipatedinside the battery? (c) At what rate (in ºC/min ) will itstemperature increase if its mass is 20.0 kg and it has aspecific heat of 0.300 kcal/kg ⋅ ºC , assuming no heatescapes?
Although caution must be used in applying ρ = ρ0(1 + αΔT) and R = R0(1 + αΔT) for temperature changes greater than 100 °C , for tungsten, the equations work reasonably well for very large temperature changes. A tungsten filament at 20 °C has a resistance of 0.350 Ω . What would the resistance be if the temperature is increased to 2850 °C ?
The circuit of the figure below shows a capacitor, two ideal batteries, two resistors, and a switch S. Initially S has been open for a long time. If it is then closed for a long time, what is the change in the charge on the capacitor? Assume C = 11 μF, ℰ1 = 1.0 V, ℰ2 = 5.0 V, R1 = 0.30 Ω, and R2 = 0.30 Ω. __________μC (please show the units when working through the problem so that I can follow it easier)
A certain flashlight is connected to a 6.0-Vemf battery and has an internal resistance of 0.100. What power does the 0.500 M load dissipate? If the internal resistance grows to 0.400 2, what is the new current, terminal voltage, and power dissipated by a 0.500 M load resistance?
In the figure the ideal batteries have emfs ε1 = 150 V and ε2 = 50 V and the resistances are R1 = 3.0 Ω and R2 = 2.0 Ω. If the potential at P is defined to be 95 V, what is the potential at Q?
A capacitor with a capacitance of 3.5 μF is initially uncharged. It is connected in series with a switch of negligible resistance, a resistor with a resistance of 19.5 kΩ, and a battery that has a potential difference of 155 V. Immediately after the switch is closed, what is the current, in amperes, through the resistor?
In the figure R1 = 2.11 Ω, R2 = 5.01 Ω, and the battery is ideal. What value of R3 maximizes the dissipation rate in resistance 3?