The spectrum of a DSB-SC AM modulated signal is given as follows withcarrier signal c(t) = 5cos2nfct, where carrier frequency fe=1 MHz.UU)2.5998.5f(kH2)-1004.5-1001.5-998.5-995.5995.51001.51004.5(а)Determine the expression for the lower-sideband (LSB) signal ui(t).(b)Determine the expression for the upper-sideband (USB) signal uu(t).(c)Determine the power content of the DSB-SC AM signal.(d)Determine the message signal m(t).

Answered: Image /qna-images/answer/3e14ed86-56a0-4f84-9311-8794c63c9dc2.jpg

The spectrum of a DSB-SC AM modulated signal is given as follows with carrier signal c(t) = 5cos2nfct, where carrier frequency fe= 1 MHz, U() 5 2.5 -1004.5 -995.5 f(kHz) -1001.5 -998.5 995.5 998.5 1001.5 1004.5 Determine the expression for the lower-sideband (LSB) signal uj(t). (b) Determine the expression for the upper-sideband (USB) signal uu(t). (c) Determine the power content of the DSB-SC AM signal. (d). Determine the message signal m(t).

The spectrum of a DSB-SC AM modulated signal is given as follows with carrier signal c(t) = 5cos2nfct, where carrier frequency fe= 1 MHz, U() 5 2.5 -1004.5 -995.5 f(kHz) -1001.5 -998.5 995.5 998.5 1001.5 1004.5 Determine the expression for the lower-sideband (LSB) signal uj(t). (b) Determine the expression for the upper-sideband (USB) signal uu(t). (c) Determine the power content of the DSB-SC AM signal. (d). Determine the message signal m(t).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A. How many numbers of constellation points exist in phase for 3bit ASK? B. What happens to the radio wave propagation when the frequency is below critical angle? C. If the mark frequency and space frequency are same then what happens to FSK? D. What is the Carson’s rule? E. What is the Maximum data rate in a minimum channel bandwidth is ? F. What is radio horizon and where is it used? G. What are the phase angle limitations of a BPSK? H. What is the change in channel capacity when two number of bits are increased?
An SSB signal is generated by modulating a 10-MHz carrier with a 1-KHz sine tone. At the receiver, the carrier is reinserted during demodulation, but its frequency is 10.00015 MHz rather than exactly 10-MHz. How does this affect the recovered signal? How would a voice signal be affected by a carrier that is not exactly the same as the original?
Use Carson’s rule to determine the bandwidth of an FM channel when the maximum deviation allowed is 5 kHz at frequencies up to 3.333 kHz. Sketch the spectrum, showing carrier and sideband values.
- An AM signal has a carrier of 10MHz and modulating signal of 10kHz. It has a modulation index of 0.7. Write its expression an calculate power efficiency?
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
What is the maximum average output power of a single-sideband signal (SSB) transmitter rated at 250 W peak envelope power (PEP)? W
Applying Amplitude Modulation Double Sideband Large Carrier (AM DSB-LC) results in a modulated carrier signal bandwidth approximately two times greater than the baseband signal bandwidth (fm). True False
A 162-MHz carrier is deviated by 12 kHz by a 2-kHz modulating signal. The maximum deviation of an FM carrier with a 2.5-kHz signal is 4 kHz. Compute the bandwidth occupied by the signal, by using the conventional method and Carson’s rule. Sketch the spectrum of each signal, showing all significant sidebands and their exact amplitude.
Type your question here An AM modulation waveform signal: ?(?) = (1 + 0.5 cos 2000?? + 0.5 cos 4000??) cos 20000?? (a) Sketch the amplitude spectrum of ?(?). (b) Find total power, sideband power and power efficiency (c) Find the average power containing of each sideband. (d) What is the modulation index?
A carrier is modulated simultaneously by two baseband signals with modulation indices of 0.3 and 0.4 respectively. If the scheme is AM, then what will the overall modulation index?
2 (AM) A 10 V amplitude sinusoidal signal is used as a modulating signal to generate an AM signal with modulation index 0.8. What is the amplitude of the carrier? What is the power of the side bands? What is the efficiency of the modulated signal?
For double sideband (DSB) signala) Write the time domain equation XDSB(t).b) Write the frequency domain equation XDSB(ω).c) Draw the block diagram for DSB signal Generation.d) Draw the receiver block diagram. e) Explain with drawing the demodulation process of double sideband (DSB) signal using coherent detector.f) What is the difficulty of synchronous demodulation (coherent detection)? g) Compare between the ordinary amplitude modulation (AM), and double sideband (DSB) modulation in terms of transmitted power, complexity of demodulation, receiver cost, and bandwidth