Answered: The step response of a system is shown…

The step response of a system is shown below whose input was 5u(t), find the steady state error constant of the system c(t) + 5 0.12 4 3+ 2+ 1+ 0 A 40.45 B 40.55 C 40.66 1 2.5 2 3 t(sec)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: (B)- Select the correct answer for the alternatives given. 1- A d.c. shunt motor is running with…

A: Q.1 Ans. -- Increase the motor speed. Explanation == According to field control method by adding…

Q: Use Norton Theorem to solve for the current and voltage at 40 ohm resistor. 1 20 Ω 2 10 Ω 3 www 120…

A: In this question, We need to determine the current in the 40ohm resistance using the Norton…

Q: AB AB JO Present state Input Next State Output ABC X ABC X 010 000 O 000 1 100 001 010 010 011 011…

A: State diagram indicates the picturorial representation of behaviour of sequential circuit Whereas…

Q: Where does Wye-Delta circuit used in industry application? What specific application and explain

A: Given We need to enumerate where does Wye-Delta circuit is used in industrial application. Please…

Q: Which of the characteristics, given in the figure, is of a series DC motor?*

Q: Using ones' complement, a) 6510-2310 Add/Subtract the following. b) 2310 - 6510

A: It is given that: a) 6510-2310b) 2310-6510

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: Transfer function is the ratio of Laplace transform of output to the Laplace transform of input.…

Q: A motor with inductance L and resistance R uses 5.0 W of power when connected to a 10-V battery and…

Q: AJFET PN junction is between the (A) gate and channel B) drain and channel C) source and channel…

Q: Where did the 101 came from as the given only provided 10k ohms and 5k ohms

A: Brief description: In the above given solution they have made a mistake of taking 101 term. Hence by…

Q: 2. For the network of Fig. 5.162 : a. Determine re and pre. b. Find Zi and Zo. c. Calculate Av. 16 V…

A: A closed path, where electric current can flow defined as an electric circuit. It is various…

Q: If a non-inverting amplifier has Ri of 1000 ohms and an Rf of 2.5 kilohms, what is the Ri voltage…

Q: D13.9. A TE mode in a parallel-plate guide is observed to have three maxima in its electric field…

A: We need to find out the number of mode for given waveguide

Q: repy Qzll find IR through resistor RE2K ohm using The venins. theorem 2 IR ↓ 5.6 Kj التاريخ www RE…

A: In this question we need to find a current through resistor R by using Thevenin theorem.

Q: coordinate system at (2,8,9). A ystem 2844Qug. Determine the value of its ene i

A: We need to find out the x component of rectangular coordinate system

Q: Design a second order low pass filter at a cutoff frequency of 2kHz with a pass band gain of 20.…

A: Types of filter Low pass filter High pass filter Band pass filter Band stop filter

Q: Given the vector field in cylindrical coordinate system: A = 2psinócospa, + (rcos2o-rsin²o)a, + pcos…

Q: A 110 kV, three-phase, 50 Hz, 150 km long overhead line consists of three 1.8 cm diameter stranded…

A: As per Bartleby policy we can answer only three subpart at a time. As you have not mentioned so I…

Q: Consider a carrier signal which is amplitude modulated by a single-tone sinusoidal message signal…

A: We know that if carrier and one side of side band are supressed, then percentage of power saved is…

Q: 5- An instrument is used for lowering the value of voltage for measuring and protection is a.…

A: The objective is to determine the correct option for the given statements.

Q: 3) Solve the meshes and order the matrix of the following way: Then, what is the value of B, C and…

A: The required parameters can be calculated by using the kirchhoff's voltage law to the meshes.

Q: R₁ www R₂ 16 V 36 kQ 12 ΚΩ RD www 2 ΚΩ O oVD = 10 V IDSS = 12 mA Vp=-8 V Rs

A: We need to find out the value of source resistance

Q: Solve the following problem using Kirchhoff's Rule. Show the equivalent circuit when solving for the…

A: Brief description: For the above given question we need to calculate the value of current flowing in…

Q: Use Thevenin to determine the current and voltage at the 10 ohm resistor. 20 Ω 2 1 10 Ω www 3 Μ 120…

A: We will find out current and voltage for given circuit

Q: Sendent current s pute 100 mH Sketch the current waveform b. At what instant of time is the current…

A: Given Current source current at t<0, i=0 at t>0 , i=10…

Q: Answer 3 Questions Q1: Choose the correct answer: 1- In an induction motor, no-load slip is…

A: As per Chegg Guidelines I am able to solve only 3 sub question...... Q .1 Ans = a) Less than 1%…

Q: A shunt DC motor is operated at no-load at rated voltage 220 V, speed 1700 rpm and armature current…

A: In this question we need to find a speed of motor when armature current is 43 A

Q: Write the general form of, and determine the exact response of the capacitor voltage for the…

A: A electrical device which stores electrical energy in an electric field, known as a Capacitor.…

Q: Student 11 Values

A: Considering the values given in the row named as student No. 11 in the above given table, the…

Q: 1. Design and implement a loop synchronous counter that counts: 325 Ltd

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: In a frequency modulation system, maximum frequency deviation allowed is 1000 and modulating…

A: Given a frequency modulation system with, Maximum frequency deviation, ∆f=1000 Hz=1 kHz Modulating…

Q: (B)-The winding sequence diagram show below for 4 pole d.c generator, 2-layer simplex progressive…

A: A winding is one or more turns of wire that form a continuous coil via which electric power can…

Q: A 220 V, 60 Hz, supply is connected to 200-turn armature winding of reluctance 1.7×10 At/Wb. Find…

A: Given No of turns ,reluctance of an armature winding connected to a AC supply. We need to…

Q: Two point charges exert force of 0.49 grams on each other. If the charges are 3.2 cm apart and with…

A: We need to find out the value of charge particle

Q: Q1: Design a second order low pass filter at a cutoff frequency of 2kHz with a pass band gain of 20.…

A: Low pass filter Only low-frequency signals pass through a low-pass filter.

Q: Consider Figure 70. Solve for Vo. Use the following values: R1=Rf=100 kohms, R2=R3-17 kohms, V₁=…

A: Brief description: For the above given operational amplifiers circuit we need to calculate its…

Q: The sequential circuit below yields an output sequence of Z=11011111 when you apply the input…

A: The electronic device that perform a Boolean logic function called a Logic gate. Type: AND gate. OR…

Q: 50/Ya X 0 51/Yb X Y1 $2/Yc X 1 Y2

A: Flip flop is constructed by a four NAND and NOR gate. Two type of flip flop first one RS flip flop…

Q: Gven: A(6,4,3) determine the magnitude of the position vector IĄ. O a.7.8 O b. 9.0 O c.9.9

Q: A 500-KVA 1-pahse alternator has an efficiency of 90% at full-load. If the load power factor is 0.85…

Q: solve for the collector saturation current of an emitter stabilized bias circuit with Vcc=18V,…

A: We need to find out saturation current

Q: Reduce the block diagram of the control system below to a single block, and then find ? R R G H₂ H₁

A: Given: The block diagram,

Q: Find the Inverse Laplace Transform of the following functions este 25-3e-35+e -65 1. F(s) =…

Q: Q1: Design a second order low pass filter at a cutoff frequency of 2kHz with a pass band gain of 20.…

Q: Q2: In the figure shown find the power of this circuit if R1-3 KQ, R3-3 KQ, R5=5 ΚΩ , R7=0.5 ΚΩ ,…

Q: Given the vector field in spherical coordinate system: A = 8sindag. Determine the value of its…

A: given the vector field in spherical coordinate system A=8sinϕ aθwe have to find the value of its…

Q: Q5- A)- Select the correct answer for the alternatives given 1- Wave windings are used in d.c…

A: As per bartleby guideline for more than three subpart question asked only first three is to be…

Q: 4. A 300 MVA, 20 kV three-phase generator has a sub transient reactance of 20%. The generator…

Q: Just list, without detailed description. Give at least 5 examples of energy storage systems.

Q: 2. Solve for the line currents, phase currents and the total complex power absorbs by the loads.

A: It is given that:

Question

The step response of a system is shown
below whose input was 5u(t), find
the steady state error constant of the
system
c(t)
5
0.12
4
3-
2
2.5
1+
0
A 40.45
B 40.55
C 40.66
D 40.68
1
2
3
t(sec)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Given the discrete-time sinusoid:x(n)=2cos(nπ/2)+sin(3nπ/4)Ignoring the effects of aliasing, if this was due to sleeping rate Fs = 79 Hz. What are the frequencies of the continuous-time cosine and sine functions?
Given a system with input x(t) and impulse response h(t) given by: x(t) = u(t) , h(t) = u(t) . Let y(t) be the output of the system. a) Find the equation of y(t) b) Sketch / Draw y(t)
A system has transfer function H(s) = 1/(s+2). Given input to system is x(t) = sin(3t) . What is the equation of steady state output y(t).
Given a system with input x(t) and impulse response h(t) given by: x(t) = t ^ 3 u(t) and h(t) = t ^ 2 u(t) . Find the equation of output y(t).
15 - When the unit step function is applied to the system input given the block diagram below, the output response takes the value c (0.2) = 0.11 for t = 0.2 s and c (infinity) = 0.333 for t = infinity. What is the steady-state error of the system? calculate.A) 0.33B) 0C) 0.25D) 0.5E) 0.67
The natural frequency of an undamped second-order system is 40 rad/s. If the system is damped with a damping ratio 0.3, then what will be the damped natural frequency of oscillation?
A continuous time signal is given as x(t)=[sin(pi/4)+jcos(pi/4)]20. Using De Moivre's theorem, find out the value of the signal x(t).
The input to a linear time invariant system is a white Gaussian noise. The impulse response of the LTI system is given by h(t) = e-10t u(t) The output of the LTI system is denoted by Y(t). Find Mean of Y(t) Power spectral density of Y(t) Autocorrelation function of Y(t E[Y(t)2] P[Y(1) > √?0/2]
The input to a linear time invariant system is a white Gaussian noise. The impulse response of the LTI system is given by h(t) = e-10t u(t) The output of the LTI system is denoted by Y(t). Find E[Y(t)2] P[Y(1) > √N0/2]
Find the steady-state difference between the input f (t) and the response x(t), iff (t) = 6t. ẍ + 8ẋ + x = f (t) x(0) = ẋ (0) = 0
Consider the circuit shown in Figure below: 10 FTQ 0,0 G Ej 5H Assuming that the value of vy(t) = 10u(t) V and at t = a current of (—1 4) flows through the inductor and (+5 V) voltage across the capacitor. Using Laplace transform method to find i, The voltage across the capacitor for all time ¢ > 0. ii. The current flows through the inductor for all time ¢t > 0.
The impulse response of a system is given by h(t)=e-t for t>=0. What will be the steady state output of this system for unit impulse input?