The surface tension of a liquid is to be measured using a liquid film suspended on a U-shaped wire frame with an 8-cm-long movable side. If the force needed to move the wire is 0.030 N, determine the surface tension of this liquid

The surface tension of a liquid is to be measured using a liquid film suspended on a U-shaped wire frame with an 8-cm-long movable side. If the force needed to move the wire is 0.030 N, determine the surface tension of this liquid

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 17RQ: At a constant pressure, how does a volume of gas vary with respect to the absolute temperature?

See similar textbooks

Related questions

Q: The temperature and pressure at the surface of Mars during a Martian spring day were determined to…

A: Given data: TM=-50°C=223 KPM=900 PaTA=18°C=291 KPA=101.6 kPa Need to determine the density of the…

Q: For a substance, what is the difference between mass and molar mass? How are these two related?

A: The amount of matter contained in the substance is known as the mass of the substance. It is the…

Q: (a) A 3-kg plastic tank that has a volume of 0.2 m³ is filled with liquid water. Assuming the…

A: Given that the volume of the plastic tank=0.2m3, That is filled with water, water has…

Q: Determine the pressure and specific volume of water at 20 C that has an internal enegy of 1200…

Q: A cylinder with a height of 5 centimeter of liquid water and 120 centimeters of vapor. Determine the…

A: Given data, P= 310 KPa hg= 120 cm = 1.2 m hf= 5 cm = 0.05 m Let A be the C.S area of cylinder

Q: A vertical piston-cylinder device contains a gas at a pressure of 105 kPa absolute. The piston has a…

A: Given , pressure of the gas P=105kPaPressure inside the cylinder by gas is balanced by the local…

Q: A volume of 8 m3 of oxygen initially at 80 kPa of absolute pressure and 15∘C is subjected to an…

A: Calculated density of oxygen and the new volume of the oxygen.

Q: The gage pressure in a liquid at a depth of 2.5 m is read to be 28 kPa. Determine the gage pressure…

A: Given data; The height h1 is 3 m The height h2 is 9 m The gauge pressure P1 is 28 kPa The gauge…

Q: Determine the height of the fluid inside a manometer that is attached to a CO2-filled tank. The…

Q: A roller with a diameter of D=84 cm, unit width up to a quarter of the volume was filled with…

A: Given data: The radius of the roller is calculated as,

Q: Consider a U-tube whose arms are open to the atmosphere. Now water is poured into the U-tube from…

Q: Determine the atmospheric pressure at a location where barometric reading is 730 mm Hg and…

Q: Using average specific heats, explain how internal energy changes of ideal gases and incompressible…

A: At the low temperature, the specific heat capacity is nearly constant but at the high temperature,…

Q: For a rectangular closed vessel partially containing a liquid, with air space at the top portion, is…

A: No we can't assume the pressure acting at the uppermost portion of the air space is equal to the…

Q: Consider a 1.73-m-tall man standing vertically in water and completely submerged in a pool.…

A: Given data: height of man (h) = 1.73 m

Q: Q4. Balloons are often filled with helium gas (Figure 4) because it weighs only about one-seventh of…

Q: Determine the specific mass in kg/m3 of oil, if the specific volume of the oil is 11.04 x 10-4…

Q: 8. The weight density of a soil is given by y = 15+ 0.75h, where y is in KN/m³, and h is in meters.…

A: Given: Weight density of the soil, y= 15 + 0.75h, where y is in kN/m^3 and h is in meters. Depth, h=…

Q: A 15 cm diameter, 50 cm high vertical cylindrical container is partially filled with 30 cm high…

A: The pressure difference between the center and the edge of the container at the base of the surface…

Q: The analysis of a propeller that operates in water at 60°F shows that the pressure at the tips of…

A: cavitation –it is a phenomenon due to which a rapid change in the pressure of the liquid leads to…

Q: The gage pressure in a liquid at a depth of 3 m is read to be 42 kPa. Determine the gage pressure in…

A: Given, Depth1 = h1 = 3 m Gage pressure at depth 1 = Pg1 = 42 kPa Depth 2 = h2 = 9 m Gage pressure…

Q: The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and…

Q: In a closed container of 2 liters, there is 1 kg of wet water vapor at a temperature of 25 degrees…

Q: A 1.6-mm-diameter tube is inserted into an unknown liquid whose density is 960 kg/m3, and it is…

A: Given data: The diameter of the tube, d = 1.6 mm. The density of the liquid, ρ = 960 kg/m3. The…

Q: 1.) A cylindrical tank having 0.2 m in radius and 40 cm high is filled with a iquid. The empty tank…

A: This is a basic problem of Fluid Mechanics. The concept of hydrostatics is used here. The steps…

Q: Consider a 8-m-long, 8-m-wide, and 2-m-high aboveground swimming pool that is filled with water to…

Q: A fish tank that contains 60 cm high water is moved in the cabin of elevator. Determine the pressure…

Q: An antique coin is a mixture of silver and copper. The coin has a mass of 1.105 10-2 kg and in…

A: Given: The weight of coin under water, The weight of coin,

Q: How do you calculate the force exerted by a liquid against a portion of a flat vertical wall? Give…

A: The force exerted by liquid against portion in vertical wall

Q: A manometer containing oil (p = 850 kg/m3) is attached to a tank filled with air. If the oil-level…

A: As per given question Density of oil =850 kg/m3 oil level difference =80 cm Atmosphere pressure =98…

Q: Freshwater and seawater flowing in parallel horizontal pipelines aro connected to each other by a…

Q: The water in a tank is pressurized by air, and the pressure is measured by a mulitifluid manometer…

A: Given Data :Patm = 85.6 kPah1 = 0.1 m Sw = 1000 kg /m3h2 = 0.2 m…

Q: Consider a 1.75-m-tall man standing vertically in water and completely submerged in a pool.…

A: Given data: The height of the man, h = 1.75 m. Write the expression for the pressure difference.…

Q: H.W.1/: The water in a tank is pressurized by air, and the pressure is measured by a multifluid…

A: The gage pressure of air is 97.8057 kPa.

Q: Taking the coefficient of compressibility of water to be 7 × 105 psia, determine the pressure…

A: Given data: The compressibility of water, k = 7 × 105 psia. (a) When volume of water is reduced by…

Q: The gage pressure in a liquid at a depth of 3 m is read to be 42 kPa. Determine the gage pressure in…

A: Given: The gage pressure at the initial depth is P1=42 kPa. The initial depth of the liquid is H1=3…

Q: Determine the pressure, specific volume, and internal energy of water at 25 C and a quality of 70%

Q: The lower half of a 10 m high cylindrical container is filled with water and the upper half with oil…

Q: 2. An aerostat balloon is filled with hydrogen. It has a volume of 1000m3 at constant air…

A: The Answer is Below

Q: The helium-filled blimp shown in the figure below is used at various athletic events. Determine the…

A: Given data: p=14.2 psiaT=80°FR=1.242×104 ft·lbf/slug·R Need to determine the number of pounds of…

Q: A vertical piston–cylinder device contains a gas at a pressure of 100 kPa. The piston has a mass of…

A: Given: The initial pressure of gas is P1=100 kPa. The mass of piston is m=10 kg. The diameter of…

Q: Consider a U-tube filled with mercury as shown in Figure 2. The diameter of the right arm of the…

A: Given data as per the question Diameter of the right arm =2cmDiameter of left arm =4cm

Q: A 30-cm-diameter, 90-cm-high vertical cylindrical container is partially filled with 60-cm-high…

A: The diameter of the tank, D=30 cm=0.3 m Height of the tank, H=90 cm=0.9 m Height of water in the…

Q: The volume of an ideal gas is to be reduced by half by compressing it isothermally. Determine the…

A: Given Data⇒Isothermal compression ProcessVolume of an ideal gas is to be reduced by halfV2=0.5×V1We…

Q: Describe incompressible substances and determine the changes in their internal energy and enthalpy.

A: given: Describe incompressible substances and determine the changes in their internal energy and…

Q: The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and…

Q: A 1.2 mm diameter glass tube is inserted into water at 20°C in a tank. Determine the capillary rise…

Concept explainers

Thermodynamic Relations

Thermodynamics is the division of physics that deals with the transfer of any kind of energy, whether it be heat, temperature, or work, from one object to another.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 1.6-mm-diameter tube is inserted into an unknown liquid whose density is 960 kg/m3, and it is observed that the liquid rises 5 mm in the tube, making a contact angle of 15°. Determine the surface tension of the liquid.
A cylinder with a height of 5 centimeter of liquid water and 120 centimeters of vapor. Determine the quality if the P = 310 kPa
Determine the height of the fluid inside a manometer that is attached to a CO2-filled tank. The height of the gas is 1.76 m and the diameter of the cylindrical tank is 50cm. The local atmospheric pressure is 1.37 kPa. The densitiy of the fluid (oil) is 0.96 g/mL, and the density of CO2 is 0.001977 g/mL.
The gage pressure in a liquid at a depth of 3 m is read to be 42 kPa. Determine the gage pressure in the same liquid at a depth of 9 m
The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and the U-tube contains 20-cm-high alcohol in both arms. Now the U-tube is rotated about the left arm at 3.5 rad/s. Determine the elevation difference between the fluid surfaces in the two arms.
Determine the pressure difference between the inside and outside of the 0.17 mm diameter air bublle in a liquid if the surface tension at the air-liquid interface is 0.109 N/m. Express your answer in 3 decimal places and in kPa.
Determine the pressure, specific volume, and internal energy of water at 25 C and a quality of 70%
Consider a U-tube whose arms are open to the atmosphere. Now equal volume of water and light oil (ρ=790 kg/m3) are poured from different arms. A person blows from the oil side of the U-tube until the contact surface of the two fluids moves to the bottom of the U-tube, and thus the liquid levels in the two arms are the same. If the fluid height in each arm is 102 cm, determine the gage pressure the person exerts on the oil by blowing.
A vertical piston–cylinder device contains a gas at a pressure of 100 kPa. The piston has a mass of 10 kg and a diameter of 14 cm. Pressure of the gas is to be increased by placing some weights on the piston. Determine the local atmospheric pressure and the mass of the weights that will double the pressure of the gas inside the cylinder.
How do you calculate the force exerted by a liquid against a portion of a flat vertical wall? Give an example
The diameter of one arm of a U-tube is 12 mm while the other arm is large. If the U-tube contains some water and both surfaces are exposed to atmospheric pressure, determine the difference between the water levels in the two arms. The surface tension and density of water at 20°C are σs = 0.073 N/m and ρ = 1000 kg/m3. What is the difference between the water levels in the two arms (in mm.)
For a substance, what is the difference between mass and molar mass? How are these two related?