The switch in the circuit has been closed for a long time, and it is opened at t = 0. Find the initial capacitor voltage, v(0). Calculate the initial energy stored in the capacitor, wc(0). Find the time constant, t and the capacitor voltage v(t) for t 2 0. t = 0 (X+5) Q SIX+2) n (X+8) V (Y+5)0 C=(Y+2) F X= 3, Y=2

The switch in the circuit has been closed for a long time, and it is opened at t = 0. Find the initial capacitor voltage, v(0). Calculate the initial energy stored in the capacitor, wc(0). Find the time constant, t and the capacitor voltage v(t) for t 2 0. t = 0 (X+5) Q SIX+2) n (X+8) V (Y+5)0 C=(Y+2) F X= 3, Y=2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The circuit elements in the circuit L=50 mH, and C=0.2 μF. The initial inductor current is−45 mA and the initial capacitor voltage is 15 V. The resistance is increased to250 Ω. Find the expression for v(t) for t≥0.
Consider the RLC circuit shown where the initial current flowing through the circuit at time t = 0 is I_0 = 5 and the initial charge on the capacitor at time t = 0 is Q_0 = 2. The components have values of R = 100 ohms, L = 5 H, and C = 1/450,500 F. Write the differential equation for Q(t), the charge across the capacitor, assuming the voltage source V(t) = 0
2. 7.22 The switch in the circuit has been in the left positionfor a long time. At t=0 it moves to the right position and stays there. 1. a) Write the expression for the capacitor voltage, v(t), for t≥0
The switch in the circuit shown in the figure below has been open for a long time. It closes at t = 0s, then 1-Calculate the initial stored energy in the capacitor 2- Find the current iR(t) for t >= 0. 3- Plot the current iR(t) for t >= 0.
Consider the circuit on the left. DC voltage u1(t ≥ 0) = U is applied at time t = 0. Both meshes must include the input voltage. At time t = 0, the capacitors are free of energy. The following applies: τ = R*C. Derive the 2nd order differential equation for the capacitor voltage u2(t).
Consider the given circuit. The switch has been closed for a very long time before opening at t=0s. Determine the capacitor voltage (in volts) right before the switch has been opened, the time constant of the circuit for t>0 (in ms), and the expression for the capacitor voltage for t≥0.
A resistor (R = 1 Ω), inductor (L = 0.1 H) and capacitor (C = 0.1 F) are connected in series, and the current I(t) through the circuit is measured as shown in the image below Assuming that the capacitor is uncharged at t = 0, and that the circuit is electrically small (such that propagation times between components can be neglected), find (or approximate where necessary) for times t = [0 : 0.1 : 0.4] (i.e. do not calculate at t = 0.5) : (shown in the image below)
Why is the following situation impossible? The LC circuit as shown has L = 30.0 μH and C = 50.0 μF. The capacitor has an initial charge of 200 μC. The switch is closed, and the circuit undergoes undamped LC oscillations. At periodic instants, the energies stored by the capacitor and the inductor are equal, with each of the two components storing 250 μJ.
*Assume that at the instant the 2 A dc current source is applied to the circuit in (Figure 1), the initial current in the 25 mH inductor is 1 A, and the initial voltage on the capacitor is 50 V (positive at the upper terminal).* Pt A. Find the expression for iL(t) for t≥0 if R equals 12.5 Ω
A 20μF capacitor is subjected to a voltage pulse having a duration of 1 s. The pulse is described by the following equations: vc(t)={30t2 V,0≤t≤0.5 s;30(t−1)2 V,0.5 s≤t≤1 s;0elsewhere. Sketch the current pulse that exists in the capacitor during the 1 s interval.
A 10μ F capacitor is connected in series with a 0.7 MΩresistor across a 200 V d.c. supply. If the p.d. across the capacitor continued increasing at the initial rate, it would be represented by OA, the tangent drawn to the initial part of the curve. If T is the time constant in seconds, namely the time required for the p.d. across C to increase from zero to its ﬁnal value if it continued increasing at its initial rate. This result is really obvious from the fact that at the instant of switching on there is no charge on C and therefore no p.d. across it. Consequently the whole of the applied voltage must momentarily be absorbed by R. (a) Find the time constant and the initial charging current. (b) Calculate the time taken for the p.d. across the capacitor to grow to 150 V.…
For the circuit shown below, which of the following is equal to the current ic(t) flowing through the capacitor at time t < 0?