The system is released from rest with no slack in the cable and with the spring stretched 290 mm. Determine the distance s traveled by the 17-kg cart before it comes to rest (a) if m approaches zero and (b) if m = 5.9 kg. Assume no mechanical interference. 17 kg 25 k = 214 N/m Answers: (a) With m = 0, m (b) With m = 5.9 kg, S = i

The system is released from rest with no slack in the cable and with the spring stretched 290 mm. Determine the distance s traveled by the 17-kg cart before it comes to rest (a) if m approaches zero and (b) if m = 5.9 kg. Assume no mechanical interference. 17 kg 25 k = 214 N/m Answers: (a) With m = 0, m (b) With m = 5.9 kg, S = i

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.79P: The coefficient of rolling resistance between the 30-kg lawn roller and the ground is r=0.1. (a)...

See similar textbooks

Similar questions

If the system starts from rest, Figure 1. Determine the velocities of each block, and the tension in the rope, when block C has descended 10 meters, on the inclined plane. mB = 75 kg, mC = 400 kg, and the coefficient of friction between block C and the plane is 0.2
(The complete question is in the picture) Consider a 2.0 [kg] box that is attached to two identical springs that are in their relaxed state when the block is centered on the frictionless horizontal floor. The box is pressed to the left and then was released from rest as shown in the figure. If work done by the left spring is Wby spring = 25 [J], what is the speed of the boxas it passes the center x = 0? A. 8.2 [m/s]B. 7.1 [m/s]C. 3.5 [m/s]D. zero
The mass m = 5.0 kg resting on a frictionless horizontal table is connected to a horizontal spring with stiffness constant k = 170 N/m. The mass is pulled a distance to the right so that the spring is stretched a distance x0 = 1.3 mm initially, and then the mass is released from rest. e)? g)?
the 3-kg collar shown has a coefficient of kinetic friction uk=0.22 with the shaft. the spring is unstretched when s=0 and the collar is given an initial velocity of v0=19.5 m/s. the unstretched length of the spring is d=1.5m and the spring constant is k=597 N/m. What is the speed of the collar afer it has moved 1.5m?
A body weighing 445 N is drawn along a rough surface. The force applied in the direction of motion is 135 N while the frictional force is 90 N. if there is an air resistance whose magnitude (in N) is equal to twice the velocity (m/s) at any instant, assume the body to start from rest.Determine the displacement at any time, t.
To apply Newton’s second law and the theorem of conservation of energy to solve kinetic problems. A bungee jumper wants to jump off the edge of a bridge that spans a river below. The jumper has a mass m, and the surface of the bridge is a height h above the water. The bungee cord, which has lengthL when unstretched, will first straighten and then stretch as the jumper falls.Assume the following: The bungee cord behaves as an ideal spring once it begins to stretch and has spring constant k. The jumper does not actually jump but simply steps off the edge of the bridge and falls straight downward. The jumper's height is negligible compared to the length of the bungee cord. Thus, the jumper can be treated as a point particle. Use g for the magnitude of the acceleration due to gravity. How far below the bridge, d, will the jumper eventually be hanging, once the jumper stops oscillating and comes finally to rest? Assume that the jumper does not touch the water. Express your answer in…
The spring constants are k1 = 140N / m, k2 = 240N / m and the unstretched lengths of the springs are 0.3 m. If the 6 kg ring is released from rest from point A, calculate its velocity when it reaches point B. According to the given datum line, the total potential energy (Ve) at point A is A = 1116.86 J and the total elastic potential energy (Ve) at point B is B = 370.8 J. Neglect the dimensions of the bracelet. (L1 = 0.90 m, L2 = 1.80 m, h1 = 1.20 m and h2 = 2.40 m)
URGENT Collar A slides over the smooth vertical bar shown in the figure. The masses Wa = 10lbs and WB = 5lbs. When h = 0.12192m, the spring is unextended. When the system is in equilibrium, h = 0m. Determine the constant k of the spring. Note: The normal of the collar is 100 times its mass (that of the collar), remember that g = 32.16 ft/s2.
The blocks A and B shown in the figure are originally at rest, and all contact surfaces are smooth(frictionless). If a towing force given in the otherfigure, acting horizontally, is applied to block A for 3 s, determine the final velocities of the blocks at time t=3 s.Note: The blocks masses are mA= 5 kg and mB=3 kg.
A 10 kg block A rests on a smooth surface and the spring is compressed 0.1 m. It is attached to an inextensible cord over frictionless, weightless pulleys with a mass B of kg, as shown. If the system is released from rest and B travels 0.1 m, what is A's speed? Consider K = 490N/m (spring) and V₁ = 2 x VB
The 18 000-kg F-35B uses thrust vectoring to allow it to take off vertically. In one maneuver, the pilot reaches the top of her static hover at 200 m. The combined thrust and lift force on the airplane applied at the end of the static hover can be expressed as F = (44t + 2500t2)i + (250t2 + t + 176 580)j, where F and t are expressed in newtons and seconds, respectively. Determine how long it will take the airplane to reach a cruising speed of 1000 km/hr (cruising speed is defined to be in the x-direction only).
consider the mass and pulley system in the attached file. mass m1 = 29 kg and mass m2 = 12kg. the angle of the inclined plane is given and the coefficient of kinetic friction between mass m2 and the inclined plane is uk = 0.12. assume the pulleys are massless and frictionless if the system is released from rest, what is the speed of mass m2 after 2.5 s? v(2.5 s) = ?