The transistor in the circuit below has B = 100 and VBE = 0.7 V in forward bias. Ignore the Early effect and use VT = 25 mV. Determine values for Rc and RE So that the transcon- ductance is gm = 80 m2-1 and the amplifier gain is A = 100. What is the purpose of the capacitor connected to the base? + 9 V 9 V RC o Vout Vsig RE 100 k

Q: Three resistors with resistances R1 = 11.1 ohm, R2 = 13.6 ohm, and R3 = 17.9 %D ohm are is series…

A: Given: Three resistors with resistances R1=11.1 ohm, R2=13.6 ohm and R3=17.9 ohm are in series…

Q: Complete the divided difference table and answer the following: 1.75 3.2 4.3 Y 0.50 0.78 1.10 1.35…

A:

Q: ylinder radius = 19 cm and height = 31 cm. Use your calculator’s pi button and round answers to two…

A: Given: Cylinder radius = 19 cm and height = 31 cm.

Q: find the current in the RLC circuit, assuming that E(t) = 0 for t > 0. R= 2 ohms; L= .05 henrys; C =…

A: The second order equation for RLC circuit is, Initially at t=0, V(0)=0, so the above equation…

Q: Let the initial approximation be xº = (§, 4, 7)". (i) Compute r', x², and r³. (i) Compute error err…

A: Given, A=511142124, x=x1x2x3 and b=617.   The system of equations…

Q: Given y'"-2xy'+@y =0 ; y(6) = 48 ( where 4 is the tens digit and 8 is the ones digit, y' (o) > &.…

A:

Q: A 30-volt electromotive force is applied to an LR series circuit in which the inductance is 0.1…

A: Given: A 30 -volt electromotive force is applied to an LR series circuit in which the inductance is…

Q: A jet engine (derived from Moore-Greitzer) can be modelled as the following ODE: (x,00) (-1,00) -…

A: Given initial value problem: x1'(t)x2'(t)=-x2(t)-1.5x12(t)-0.5x13(t)3x1(t)-x2(t)   x1(0)x2(0) = 62-1…

Q: Use the improved Euler's method to obtain a four-decimal approximation of the indicated value. First…

A:

Q: n the figure attached, let E=60 V, R1=2 ohms, R2= 3 ohms, L1= 1 H, L2= 1 H. Determine the currents…

A:

Q: Use improved Euler method to find yo.75) if E= xy +1 take h=0.25

A: Introduction: The formula for improved Euler method is given by,…

Q: Approximate the root of 2r - 11.7r + 17.7x -5 = 0 using three iterations of Newton-Raphson Method.…

A:

Q: At a am, a ther momet er reading 70°F is ta ke outdoors where the bempera turo is 15°7. Ab quoro…

A:

Q: Find the value of (V7) by Newton-Raphson Method, beginning with (1.5) as an initial value. O 1.91294…

A:

Q: Use the RK4 method with h = 0.1 to obtain a four-decimal approximation to the indicated value. У'3…

A: The formula for finding y1 = y0 + 1/6(k1 + 2k2 + 2k3 +k4), and x1 = x0+h

Q: Find the order of the error in Euler's method. .a O(h) .b 0(h*) .C (4)0 .d 이(M) .e None of these

A: To find the order of error in Euler's method.

Q: To illustrate calculations with the unit impulse function, consider evaluation of the following…

A: As per our company guidelines, we can solve first question for you. If you want other questions to…

Q: The next iterative value of the root of x² – 4= 0 using the Newton-Raphson method, if the initial…

A: Newton-Raphson method: It is one of the most widely used numerical methods for the approximate…

Q: Wse the genoral solution of the dfferentrol eguctron gives below to use the poranmeter Exchange…

A:

Q: IF 6J of work is needed to stretch a spring from 10 cm to 12 cm and another 10 J is needed to…

A: Given: 6J work --- 10 cm to 12 cm  10J work -- 12 cm to 14 cm

Q: Let's say there is a 120 volt electromotice force imposed on an RC circuit in which the resistance…

A:

Q: In series RL circuit, L=4 henry, R=100 ohms and E =200 volts, find the value of current when t =2…

A: Given ; L= 4 henry , R=100 ohms and E=200 volts , t= 2 sec

Q: Solve the following system using Newton's Method. The exact results are x = 2.7663 and y = 1.3851.…

A:

Q: Find the value of (V7) by Newton-Raphson Method, beginning with (1.5) as an initial value. O 1.91294…

A:

Q: 1. A current of 1.5A flows through a motor when it is connected to 120V. What is the resistance of…

A: Please follow the next step.

Q: A series RL circuit with R = 10 N and L = 1.5 H has a constant voltage E = 25 V applied at t = 0 by…

A:

Q: Q4) Find the current i(t) for the series RC circuit if the applied voltage is E(t) : = 3e-t given…

A: The solution of the differential equation is defined as the function that satisfies the equation. A…

Q: dE 3D25-8t, where t is the number of hours the operator has been at work dt The rate at which a…

A: Given dEdt=25-8t To find E(t):

Q: In a circuit the resistance is 6 Q and the inductance is 1/4 H. The battery gives a closed when t =…

A: When an ordinary differential equation has the form dydx+Py=Q, where y is dependent on the…

Q: . A 30-volt electromotive force is applied to an LR series circuit in which the inductance is 0.1…

A:

Q: Simplify the following system, then find (x,y,z) the by using invers method. log,(x)' – ex + 2cos2z…

A: Simplify each equation separately.

Q: Three resistors with resistances R1 = 10.7 ohm, R2 = 14.3 ohm, and R3 = 19.4 %3D ohm are is series…

A:

Q: An amplifier with ga = 40 db and BN=20 kHz is found to have N a0 = 10KT. when T;= T. Find T, and…

A: Answer: Using the given data,

Q: Use the Euler method to solve the following equation analytically for five iterations. Given that…

A:

Q: Solve the following problem by using the KKT conditions P : Min er²+y² s.t. 2x – y = 4.

A: To find - Solve the following problem by using the KKT conditions                  P : Min ex2 +…

Q: We have the following DFT results for two 1D signals x and y of length two as x' = [4 - 3i 0], y' =…

A: Given: DFT findings for two 1D signals x and y of length two are as follows: x'= [4 - 3i  0], y' =…

Q: Solve the following system using Newton's Method. The exact results are x = 2 and y = 3. Calculate…

A:

Q: Consider the RL circuit in which R = 4 ohms , L= 0.1 henry, and E(t) = 20 V. If no current is…

A: Let's find.

Q: (5) For the given impedances, z, = 10 + jo N, z, = 0 – j10 N and z, = 10 + j1o N, Determine, z- =…

A: Consider the given impedances, z1=10+j0z2=0-j10z3=10+j10 here, we need to find to find the value of,…

Q: Q4) Find the current i(t) for the series RC circuit if the applied voltage is E(t) = 3e¬t given that…

A: Introduction: The current through a RC circuit is the rate of change of the charge in the circuit.…

Q: Find /(r) for the electrical circuit in Exercise 27 if R = 62, L = 3 H, V(?) = 3 sin: V, and /(0) =…

A:

Q: Perform Gauss-Seidel Method until 5th iteration. Use 4 decimal places for the entire computation.…

A:

Q: Consider a model (Electric RLC series Circuit) find the steady 1.2 henry, x 10-3 farad, E(t)12000…

A: Given: L=1.2 henryR=12 ohms C=203×10-3 faradEt12000 sin 25t volt

Q: 5 V +. 3 2 4 S2 4 V 3 V 13

A: In the question it is asked to calculate the value of currents I1,I2,I3.

Q: An RLC circuit with input voltage E(t) is described. Find the current I(t) using the given initial…

A:

Q: A resistor of 500 ohms and an uncharged 5 x 106 farad capacitor are connected to a 100-volt battery.…

A:

Q: Compute the following, showing all work on the facing page or pages provided for work, and record…

A: Note: It is assumed that Prm(x) is the prime function.   The number that is divisible by 2 is an…

Q: b) Given an RL circuit with the equation UTM UTM IP L+ RI = 900, dt where L is the inductance, R is…

A: