Answered: The uniform diving board has a mass of…

The uniform diving board has a mass of 26 kg. Find the force on the support A when a 69 kg diver stands at the end of the diving board. ... 0.9 m 3.6 m A B

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 98A

See similar textbooks

Related questions

Q: A particle travels with velocity v= (8m/s^2) t-7m/s. A.)find the average acceleration for two 1-s in...

A: The acceleration and velocity are related as a = dvdt, where v is the equation of velocity in terms ...

Q: A barge is pulled by two tugboats. If the tension force in the rope T and T. is 3500 lbs BC AB and 2...

Q: How much work is performed by a gas as it expands from 30L to 45L against a constant external pressu...

Q: Four charges are located at the corners of a square, as shown. What are the magnitudes and direction...

A: The formula of the force between the two charges is given as F= kq1q2r2 where q1 and q2 are the cha...

Q: A load of 50 kg is applied to the lower end of a steel rod 80 cm long and 0.60 cm in diameter. How m...

A: Given, Mass of the rod, m = 50 kg length of the rod, L = 80 cm diameter of the rod, d = 0.60 cm Youn...

Q: A ball is thrown vertically upward from the top of a tree which has a height of 112 feet. If it was ...

A: Given that:- A ball is thrown vertically upward from top of tree with speed 96fps.

Q: 7. A particle is moving on a line according to the equation of motion s=3t^2+5t+4 where s is in mete...

A: Introduction: The velocity of the object is equal to the rate change of position with respect to the...

Q: A 70 kg hiker climbed a mountain 1000 m high. Assuming the work was done at a steady rate during 3 h...

Q: A string clamped at two ends is vibrating at a fundamental frequency of 443.8 Hz such that the dista...

A: Given, Fundamental frequency of vibration, f = 443.8 Hz distance between adjacent nodes, d = 45 cm T...

Q: i. A man stands on the roof of a 15.0 m tall building and throws a rock with a speed of 30.0 m/s at ...

A: Motion of projectile can be divided into x component and y component.

Q: An electron moves with constant speed of 1 m/sec in the xy plane in the y direction along the line x...

Q: A horizontal spring with a spring constant of 140 N/m is extended 0.2 m from the equilibrium positio...

A: Given: The spring constant is 140 N/m. The extension in the spring from the equilibrium is 0.2 m.

Q: 4. A vertical wire 5 cm long and 0.0089 cm² cross-sectional area has Y = 200 GPa. A 2.5kg object is ...

A: Write the expression for the stress. Here, F is the force and A is the area. Write the expression f...

Q: 23. Determine the force, F, required to keep the box from sliding down the plane as shown. 250 kN H ...

Q: A magnet has a mass of 5.90 kg. The magnetic force pulling the magnet to the right has a magnitude o...

Q: 3. A gas in a cubical container with side equal to 0.3568 m has a pressure of 0.24 MPa at 24°C. If t...

A: Given: L=0.3568 mP=0.24 MPa = 0.24*106 PaT=24°C=297 KR=212 J/Kg.K

Q: Marks moves with velocity of 6m/s. Lukas move 15 percent faster than markus. A.) At what distance wi...

A: We first find the velocity of Lukas. Velocity of Markus is vm = 6 m/s Velocity of Lucas is 15 % more...

Q: A fly ball is hit to the outfield during a baseball game. Let's neglect the effects of air resistanc...

A: initial x-component velocity = V0x= 20 m/s initial y- component velocity = V0y = 20 m/s angle = ?

Q: 22. An elevator weighing 2000lb (force) attains an upward velocity of 16fps in

A: GivenW=2000 lbv=16 fpst=4 sec

Q: A person with a range of vision from 50 cm to ∞(infinity) uses a 19 cm focal length magnifier. (a) ...

A: GivenA person range of vision of vision=50 cm to ∞ie Near point at distance ,d=50 cmFocal length of ...

Q: Say we drop an object with a mass of 5kg from a helicopter that is hovering 120m above the ground. C...

Q: Identify which of the following is/are example/s of the First Law of Thermodynamics by writing YES...

Q: Classification of forces in physics is Electrical force Gravitational force All Nuclear force

A: In physics, there are contact force like tension and non contact force like gravitational force, ele...

Q: If 100 J of work must be done to move electric charge equal to 4 C from a place where potential is -...

Q: bunch of keys is thrown from the top of a 50 m tall building with an initial velocity of 20 m/s. a) ...

A: Given initial velocity u = 20 m/s Displacement S = - 50 m At highest point velocity v = 0

Q: A man pulls a 50kg box horizontally from rest while exerting a constant horizontal force, displacing...

Q: Four charges (-e, +e, -e, +e) in a row are each separated from neighboring charges by 3.0 × 10- 10 ...

A: Draw the schematic diagram of the system.

Q: 2. It takes 185 kJ of work to accelerate a car from 23.0 m/s to 28.0 m/s. What is the car's mass?

A: Given: The total work done is 185 kJ. The initial speed of the car is 23 m/s. The final speed of the...

Q: A rocket accelerates upward and the thrust of the engines overcome the frictional forces and the gra...

Q: The same forces act on two objects having the same masses. The more massive object will experience t...

A: According to Newton's second law Net force acting on the object is F= m* a Where m is mass of obje...

Q: What is the maximum speed at which a car can round a curve of 25m radius on a level road if the coef...

A: GivenRadius of curve ,r=25 mCoefficient of static friction between tiers and road ,μ=0.8

Q: Aparticle with a mass of 1,81 g and a charge of -2,50 nC. The particle moves with a velocity of 4,00...

A: Determine the force on the particle.

Q: When there is temperature difference between two systems, there will be a transfer of thermal energy...

A: Heat transfer depends on temperature difference between two objects .

Q: If the brakes on a car give the car a constant negative acceleration of 24 m/e2, where k is a positi...

Q: Activity 1 - Electric Fields DRAWING ELECTRIC FIELDS Follow the rules of electric fields and draw wh...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: Which of the following gives the correct x and y components of the force F31 exerted by charge 3 on ...

Q: Say we drop an object with a mass of 5kg from a helicopter that is hovering 120m above the ground. C...

A: Given that:- Mass of object=5kg

Q: If the brakes on a car give the car a constant negative acceleration of 2k m/s2, where k is a positi...

Q: A stone is thrown vertically upward from the top of a house 112 feet high. If it was thrown at 96 fp...

A: Given Data:- Height of the building is H=112 ft Initial speed of the stone is vi=96 fps Required:- T...

Q: If the brakes on a car give the car a constant negative acceleration of 2k m/s2, where k is a positi...

A: We use one of the equations of linear motion to solve this question. v2-u2 = 2as, where v = the fina...

Q: A wingsuit flyer weighing 90 kg (including equipment) climbs at the peak of a mountain. He jumps wit...

A: Before the opening of webbing sleeve there are two forces acting on the wingsuit flyer i.e 1. Gravit...

Q: A. B. An elevator is suspended by a cable and moves uniformly upward. Which of the above free-body d...

A: Given: The motion of the elevator is in upward direction. The velocity of the elevator is uniform.

Q: Sally who is driving a 2200 kg car and rams into John who was stopped in his 1500 kg car. Sally was ...

A: Given: m1=2200 kgm2=1500 kgu1=36 km/h = 10 m/su2=0 m/sv1=18 km/h= 5 m/sF=5*104 N

Q: If the brakes on a car give the car a constant negative acceleration of 2k m/s^2, where k is a posit...

A: the brakes on a car give the car a constant negative acceleration of 2k m/s^2, where k is a positive...

Q: Classification of forces in physics is Electrical force Gravitational force All Nuclear force O

A: Push or pull of an object is called force and types of force area : Frictional force Magnetic force ...

Q: Yong had stopped his cart which has a mass of 500 kg just before a 30degree hill covered in ice. He...

Q: Suppose the baseball is struck from the edge of a cliff such that yo = 30 m and x0 = 0. The componen...

Q: A stone is thrown vertically upward from the top of a house 112 feet high. If it was thrown at 96 fp...

Q: A voltage = 5000 volts is applied across a capacitor C = 70,000 microfarad. The potential energy sto...

A: Given that:- Voltage applied across capacitor=5000volts

Q: The same heat transfer into identical masses of different substances produces different temperature ...

A: Given: Q=1.0 Kcal Q=1.0*4184 JQ=4184 JT1=20.0°Cm=1.0 kg

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

The uniform diving board has a mass of 26 kg. Find the force on the support A when a 69 kg diver stands at the end of the diving
board.
...
0.9 m
3.6 m
A
B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A large advertisement board (W) is held in position by cable F1, with a breaking strength of 1500 N and a wooden strut F2 with a breaking of 750 N. Calculate the maximum weight the board can hold.
A shop sign weighing 215 N hangs from the end of a uniform 180N beam as shown in (Figure 1). a)Find the tension in the supporting wire (at 35.0∘). b)Find the horizontal force exerted by the hinge on the beam at the wall. c)Find the vertical force exerted by the hinge on the beam at the wall.
Juan and pablo carry a load weighing 720 N on a pole between them. (a) if the pole is 2.0 m long and the load is 0.50 m from pablo, what force does each person support? Neglect the weight of the pole. (b) if the weight of the 120-N pole is considered, what force does each person support?
A large advertisement board (W) is held in position by cable F1 , with a breaking strength of 1500 N and a wooden strut F2 with a breaking strength of 750 N. Calculate the maximum weight on the board can hold.
A shop sign weighing 200 NN hangs from the end of a uniform 170-N beam as shown in (Figure 1). Find the tension in the supporting wire (at 35.0). Find the horizontal force exerted by the hinge on the beam at the wall. Find the vertical force exerted by the hinge on the beam at the wall. ROUND ANSWERS TO 3 SIG FIGS
The leg and cast in the figure below weigh 273 N (w1). Determine the weight w2 and the angle α needed so that no force is exerted on the hip joint by the leg plus cast. w2 = ? a = ?
A shop sign weighing 200 N hangs from the end of a uniform 175-N beam as shown in (Figure 1). a. Find the tension in the supporting wire at 35 degrees b. Find the horizontal force exerted by the hinge on the beam at the wall c. find the vertical force exerted by the hinge on the beam at the wall
A glass optical fiber in a communications system has a diameter of 9.0 μm. a. What maximum force could this fiber support without breaking?
Replace the two forces and one couple acting on the rigid pipe frame by their equivalent resultant force R acting at point O and a couple MO. MC = 30 lb-ft, F = 30 lb, and P = 90 lb. Find only the magnitude of MO in lb.in.
A student creates a beam bridge for a project, suspends masses from the bridge, and spans the bridge across two surfaces, as pictured below. What is the best approximation for the normal force applied on the bridge’s surface from PylonA? (A)About 0.8N (B)About 1.2N (C)About 1.4N (D)About 2.0N
What are tbe conditions for an object to be in static equilibrium?
A shop sign weighing 210 N hangs from the end of a uniform 165-N beam as shown in (Figure 1). Find the tension in the supporting wire (at 35.0∘). Find the horizontal force exerted by the hinge on the beam at the wall. Find the vertical force exerted by the hinge on the beam at the wall.