The value of k of soil around a sheet pile is 106 m/s. The flow net of this sheet pile consists of 5 flow lines and 11 equipotential lines. Determine the rate of seepage (in cm³/s per m) if the difference in the water level is of 4m.

The value of k of soil around a sheet pile is 106 m/s. The flow net of this sheet pile consists of 5 flow lines and 11 equipotential lines. Determine the rate of seepage (in cm³/s per m) if the difference in the water level is of 4m.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter7: Seepage

Section: Chapter Questions

Problem 7.4P

See similar textbooks

Related questions

Q: A sheet pile has an embedment depth of 12 m in a homogeneous soil stratum. The coefficient of…

Q: The flow net around a sheet pile wall is shown in the sketch. The properties of the soil are…

Q: 5- An earth dam is shown below. Determine the seepage rate, q, in ft/day/ft length. Given: a1=35°,…

Q: The following figure shows the flow net around a sheet pile. Determine: a. Pore water pressure (u)…

A: Given values: Sheet pile given. Difference in level of water between upstream and downstream= 5 m…

Q: The head in m is? Sheet pile 5 m Ground surface 1.67 m II III 10 m 3! 4 5id

A: Given data in question Flownet Sheet pile ground surface Number of flow channels =3 Number of…

Q: The coefficient of permeability of soil around a sheet pile is 10-5 m/s. The flow net of this sheet…

A: Given: The coefficient of permeability is 10-6 m/sec. The number of flow lines is 6. The number of…

Q: 2. For the sheet pile shown below, find the maximum upstream water height when considering the…

A: Given: Flownet No of flow channels = 4 No of equipotential drops = 6

Q: 1) Find the rate of seepage beneath the dam in m/day/m 2) If a standpipe piezometer is installed at…

A: Nf = Number of flow channels= 5 Nd = Number of potential drops= 16 K = hydraulic conductivity =…

Q: A single row of sheet piles is driven into a permeable layer as shown in the figure. Given: H, = 7 m…

Q: In a flow net drown below a sheet pile wall, the number of flow channels and head drops is 4 and 12…

Q: 1. Calculate the rate of flow or seepage flow per meter length of the sheet pile at right angle to…

A: Given data in question Permeability Elevation difference in upstream and downstream end. Number of…

Q: Problem (2) a) Find the quantity of discharge q per meter width for the sheet pile given in the…

Q: Determine the total flow rate through all channels per unit length of the respective Flownet of…

Q: For a given flow net around a sheet pile wall, determine the following How high will the water be…

A: From the given figure.

Q: a) A deposit of soil is 16m deep and overlies an impermeable stratum; the coefficient of…

A: Introduction- The capacity of soil to enable water to flow through it is referred to as soil…

Q: 1.2X 10 cm/sec 1.0m 2.0 m 3.1X 10 cm/sec 4.3X 10 cm/sec 3.0m Figure 4

Q: Sheet pile k= 4 x 10-4 cm/sec Impermeable layer Figure 8.23 8.2 Draw a flow net for the single row…

A: Given:- The value of k = 4×10-4 cm/sec The value of H1 = 3 m The value of H2 = 0.5 m The value of D…

Q: Q-8: The following figure shows the flow net for seepage of water around a single row of sheet piles…

Q: 1. Design a pipe culvert using the following data. culvert. Discharge in the stream: 4 m/s Road top…

Q: The number of flow channels and head drops is 4 and 12 respectively. If the difference in the…

Q: An earth dam is shown in Figure 8.27 Determine the seepage rate, q, in m/day/m length. Given: a =…

Q: A single row of sheet piles is driven into a permeable layer as shown in the figure. Giyert H = 5.5…

A: Given data, H1 = 5.5 m H2 = 4.4 m Nf = 4 Nd = 8 k = 4 x 10^-4 cm/s To find out the seepage loss…

Q: 5. The section of a sheet pile is shown. The coefficient of permeability of the soil is K1 =4.2 x…

Q: 2.10 Refer to Figure P 2.10 and use these values: H = 7 m, • H, = 1.75 m, D =7 m D = 3.5 m Draw a…

Q: The section of a sheet pile is shown in the figure. The coefficient of permeability of the soil is…

Q: The value of k of soil around a sheet pile is 10-6 m/s. The flow net of this sheet pile consists of…

A: Given: Coefficient of permeability, k = 10-6 m/s Number of flow lines = 5 Number of equipotenial…

Q: The section of a sheet pile is shown in the figure. The coefficient of permeability of the soil is…

Q: Example 5.15 A sheet pile wall drove into having silty permeability m/sec. find the quantity of soil…

A: Escapism of gas or liquid through a porous medium at slower rate is termed as seepage. The pressure…

Q: 4. For the system shown in the figure below: Datum 5.0 m 7.0 m 5.0 m a) Flow rate per meter length…

A: Given data in question Flownet Head difference Void ratio Specific gravity To find out Discharge…

Q: PROBLEM 2: A circular pile 0.45m in diameter and 15m long is embedded in a layer of dense sand. The…

Q: Refer to Figure 8.23. Given: • H, = 6 m • H, = 1.5 m Draw a flow net. Calculate the seepage loss per…

Q: An earth dam is shown in the figure below. Determine the seepage rate. Given: a, = 46 degrees, a2 =…

Q: Figure Q4 shows a flow net for flow around a single row of sheet piles in a permeable soil layer.…

Q: For the concrete Dam shown in figure, determine the total average seepage for the given permeable…

A: Given data in question Number of flow lines Nf Number of potential drops Nd Permeability Head…

Q: Refer to Figure 8.23. Given:• H1 = 6m• H2 = 1.5 m• D = 3 m• D1 = 6 mDraw a flow net. Calculate the…

A: Solution

Q: Q3 For the sheet pile shown in figure, find (1) The quantity of seepage (k= 0.5*10 m/sec). e =0.75 m…

A: Solution

Q: Given: H = 7 m H2 = 4.3 m Calculate the seepage loss per meter length of the sheet pile (at right…

Q: Determine the total flow rate through all channels per unit length of the respective Flownet of…

A: Given data ; Coefficient of permeability:- (k) = 5×10^-⁵cm/sec Nf= 3.5 As per given figure, Number…

Q: A single row of sheet piles is driven into a permeable layer as shown in the figure. Given: • H =…

A: Using formula to find seepage loss

Q: A concrete dam of 17.5 m base width retains 5 m of water. A sheet pile cut-off is provided at the…

Q: Given the sheet pile shown in figure : 1. Draw the flow 1.5m 3.0mi net to scale (1:100) and compute…

A: 1 . Following figure show the flow net diagram: Calculate the seepage quantity as follows: Q =…

Q: A single row of sheet piles is driven into a permeable layer as shown in the figure. Given: • H =…

Q: Determine the factor of safety against heave on the downstream side of the single-row sheet pile…

Q: The peak discharge was found to be 0.706 m3 /s. It has been determined that a water flow speed of…

A: Discharge formula will be used in this question.

Q: The dam and flow net shown in the attached picture. The dam is 120 m long and has two 10 m sheet…

A: From diagram above ; Number of flow lines = 2.4 Number of Equipotential drops = 10.4

Q: 4. For the system shown in the figure below: Datum 5.0 m 7.0 m 5.0 m a) Flow rate per meter length…

Q: Question 1/ Longitudinal trench to be excavated across the river with length 40m and depth 5m as…

A: Let us estimate the capacity of pump in step 2.

Q: A double wall sheet pile coffer dam retains a height of water 9 m on one side. A flow net…

Concept explainers

Alloys

An alloy is an admixture of two or more metals or a metal and a non-metal. Since ancient times, man has been using alloys. Alloying helps to retain the properties of the parent matter, such as hardness, strength, toughness, ductility and is corrosion-resistant. Copper alloys such as brass have antimicrobial properties that help to fight against (Coronavirus disease 2019) COVID-19 and other hospital-acquired infections. Some common alloys are brass, bronze, solder steel, etc. Most alloys have a lower melting point than their constituents. This is due to the presence of a nonmetal as one of the constituents that behaves as an impurity and restricts the raise of melting point.

Question

Can you please tell which formula is needed to solve this?

The value of k of soil around a sheet pile is 106 m/s. The flow net of
this sheet pile consists of 5 flow lines and 11 equipotential lines.
Determine the rate of seepage (in cm³/s per m) if the difference in the
water level is of 4m.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The value of k of soil around a sheet pile is 10-6 m/s. The flow net of this sheet pile consists of 5 flow lines and 11 equipotential lines. Determine the rate of seepage (in cm3/s per m) if the difference in the water level is of 4m.
A flownet for flow around a single row of sheet piles in a permeable soil layer is shown in Figure 1 below. Given the hydraulic conductivity is 5 x 10-3 cm/sec. Determine:
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in the Figure below. Given that kx= kz = k= 5.5 x 10-3 cm/sec, H1 = 6.5 m and H2 = 2.3 m determine: i. How high (above the ground surface) the water will rise if piezometers are placed at points a and b ii. The total rate of seepage through the permeable layer per unit length iii. The approximate average hydraulic gradient at c
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in Figure below with a scale as shown. Given that kx = kz=k = 4 x 10-3 cm/sec, determine How high (above the ground surface) the water will rise if piezometers are placed at points a and b The total rate of seepage through the permeable layer per unit length The approximate average hydraulic gradient at c factor of safety against piping x=1.6 y=2.8
For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements
The sheet pile is driven in the Cebu South reclamation area and the area to one side is pumped down as shown in the flow net. The permeability of the sand is 0.001 m/s. below the elevation of 20 m us an impermeable rock layer. Determine the flow per unit length.How high (above the ground surface) the water will rise if a piezometer will be placed at A?
Q#4 : For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements. Use MSpaint or graph paper
Determine the factor of safety against heave on the downstream side of the single-row sheet pile structure shown in Figure 9.30. Use the following soil and design parameters: H1 = 7 m, H2 = 3 m, thickness of permeable layer (T) = 12 m, design depth of penetration of sheet pile (D) = 4.5 m, and γsat = 17 kN/m3
Draw a flow net for a single row of sheet piles driven into a permeable layer as showin Figure Q3 (b) below. Thus, determine the seepage loss per meter length of thesheet pile.H1 = 9.6 m D = 5 mH2 = 3.7 m D1 = 13 m
Q#3 : For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements. Use paint or graph paper
The sheet pile shown on the figure below is driven into a soil with a permeabilityk = 22 × 10-4 cm/s. Calculatea- the seepage loss per metre lengthb- the pore water pressure at the 12 points shown on the figure.
A double wall sheet pile coffer dam retains a height of water 9 m on one side. A flow net constructed for this structure, driven into a pervious deposit overlain by an impervious ledge, consists of five flow channels and fifteen potential drops. The length of the coffer dam is 90 meters. If the coefficient of permeability of the pervious deposit is 10^–2 mm/s.Determine the seepage in cubic meters per day.