The volume of the cylindrical body is 0.04 m³ and its total mass is M ... Kg. The base radius of the cylinder is 0.12 m. If the cylinder is thrown in the water, will the body floats or sinks? Explain If the cylinder sinks, what is its weight in the water? If the cylinder floats, what is its submerged depth in the water? Use your last two digits of your ID as the mass of the cylinder

The volume of the cylindrical body is 0.04 m³ and its total mass is M ... Kg. The base radius of the cylinder is 0.12 m. If the cylinder is thrown in the water, will the body floats or sinks? Explain If the cylinder sinks, what is its weight in the water? If the cylinder floats, what is its submerged depth in the water? Use your last two digits of your ID as the mass of the cylinder

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.
A 6-in. diameter hole is drilled in the conical frustum. Calculate the volume and the surface area of the resulting body.
The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.
The weight of the cylindrical tank is negligible in comparison to the weight of water it contains (water weighs 62.4lb/ft3). The coefficient of static friction between the tank and the horizontal surface is s. (a) Assuming a full tank, find the smallest force P required to tip the tank, and the smallest s that would allow tipping to take place. (b) If the force P = 200 lb initiates tipping, determine the depth of water in the tank.
The density of a floating body can be determined by tying weights to the body until both the body and the weights are completely submerged, and then weighing them separately in air. Consider a wood log that weighs 1400 N in air. If it takes 34 kg of lead (? = 11,300 kg/m3) to completely sink the log and the lead in water, determine the average density of the log.
An oil tanker 3m wide 2 m deep and 10 m long contains oil of density 800 kg/m3, if the tanker is closed and completely filled with the oil and accelerated horizontally at 3m/s2. a.) determine the total liquid thrust (hydrostatic force) on the front end. (in kN) b.) determine the total liquid thrust (hydrostatic force) on the rear end. (in kN)
A semicircular 40-ft-diameter tunnel is to be built under a 150-ft-deep, 800-ft-long lake. Determine the total hydrostatic force acting on the roof of the tunnel.
As shown in the illustration, a 6-m-wide, 15-m-long barge is filled with rocks and floats in water. Assume that the rocks' and barge's center of gravity, G, is positioned along the centerline at the barge's surface. What is the metacentric height in meters if the barge carrying the rocks weights 1,765.8 kN? Only round off on the final answer, Use three decimal places.
The gate shown is 3.0 m wide (into the page), hinges around the bottom point, and for the purposes of this analysis can be considered massless. A weight is attached to the top point, and is threaded through a frictionless pulley. For what depth of water (d) will this rectangular gate be in equilibrium at an angle of 60o as shown?
The spherical buoy shown in Fig.1 of the radius R the square gate AB opens when the water rises to the height of the half-buoy. Determine R if the weight of buoy and gate are negligible.
plzzzzzzz help What is the minimum Block mass (kg) that is required to open the gate A-B? The density of water is 1000 kg/m3 and the density of the block is 8000 kg/m3. The specific gravity of oil is 0.9. The depth of the gate is not required. The external force that effects the gate at point A is Fe=3000 N, while the hydrostatic force Fh=9313.8 N