Answered: The water in a tank is pressurized by…

Name: The water in a tank is pressurized by air, and the pressure is measure
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The water in a tank is pressurized by air, and the pressure is measured by a multi-fluid manometer, as shown in the figure. Determine the gage pressure of air in the tank. AirWater0.2 m£0.3 mOils = 0.850.46 mMercurys = 13.6

Engineering

Mechanical Engineering

The water in a tank is pressurized by air, and the pressure is measured by a multi-fluid manometer, as shown in the figure. Determine the gage pressure of air in the tank.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 17RQ: Convert 22C to Fahrenheit.

See similar textbooks

Similar questions

ans: 0.01925kg, 0.7123kg, 1.886kPa Use gas laws
8.. An air blower is to deliver 40,000 ft3 /min. Two U-tube gages measure suction and discharge pressures. The suction gage reads a negative 2′′ of water. The discharge gage, located 3 ft above the point to which the suction gage is attached, reads +3′′ of water. The discharge and suction ducts are of equal diameter. What size motor should be used to drive the blower if the overall efficiency is 68% (γ = 0.0750 lb/ft3 for air)? indicate free body diagram
Convert 22C to Fahrenheit.
Dusty air at a fertilizer plant flows through a 70%-efficient cyclone and then through an ESP. The inlet air to the cyclone has a dust loading of 50 grains/cubic foot. in order to meet a control standard of 98.5% collection efficiency for the fertilizer plant as a whole, what is the allowable concentration of dust (in grains/cubic foot) in the air that exits from the ESP?
SN=10 ksi MN=20 ksi
The Gather’s have 2 cars. Last year, one car was driven about 13 500 km and has a fuel consumption rating of 8.1L/100 km and 55 625 km was put on the other car which has a fuel consumption rating of 6.3L/100 km. The average cost of fuel during the year was $0.87/L. Using the following maintenance table, determine how much the Gather’s spent on all relevant variable costs last year.
FN=10 SN=20
Assume that wind turbines are designed such that irreparable damage should occur only during local storms, which occur, on average, once per hundred years. Calculate the annual insurance fee, $/year, in constant dollars for a unit having an initial cost of $300,000 if the worldwide insurance investment pool for wind farms earns a net real inflation-free rate of return of 5%/year compounded continuously.
The coefficient of bend value in the energy loss due to bend in a pipe depends on the radius of curvature of bend, _________________, & angle of bend.
You are to spray an 80-acre field that will be planted to alfalfa with 32 oz/ac Roundup, 1.5 pints/ac of Treflan, and 17lbs AMS/100 gallon spray. If your sprayer is calibrated to apply 10GPA carrier volume and holds 800-gallons how much AMS do you need to add to your sprayer to condition your water, and how many gallons of Roundup and Treflan do you need to add to your sprayer so that you apply the proper rate?
A closed pipe 3 ft long, compute the 6th harmonic if air temperatureis 80°F.a.627.92 Hzb. 1240.42 Hzc. 0d. 672.92 Hz
The following particulars apply to an inclined belt conveyor: Length of conveyor (loading end to discharge end): 100 mSpeed of belt: 1,5 m/sAngle of wrap around driving pulley: 220 degreesCoefficient of friction between belt and driving pulley: 0,3 Mass of rock conveyed (mass flow rate): 300 t/hThe discharge end is 22 m higher than the loading end. The total friction is equivalent to a force of 6,5 kN in the belt at the head pulley. The efficiency of the drive is 90%. 4.2.1 Calculate the power of the motor. 4.2.2 Calculate the minimum tension in the slack side of the belt as it leaves the driving pulley