The wrong maintenance procedure followed while performing gib adjustment on a lathe machine is O Adjust the gib to new position by retighting lock on the front screw O On the front face of the tool slide loosen the gib screw O The compound slide is moved over entire length after adjustment O On the rear face of the tool slide loosen the gib screw

The wrong maintenance procedure followed while performing gib adjustment on a lathe machine is O Adjust the gib to new position by retighting lock on the front screw O On the front face of the tool slide loosen the gib screw O The compound slide is moved over entire length after adjustment O On the rear face of the tool slide loosen the gib screw

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter6: Milling

Section6.3: Vertical Milling Machine Operations

Problem 2RQ: Briefly describe the process of aligning a milling vise with the table movement using a dial...

See similar textbooks

Similar questions

6 The copper head hammer is used for releasing hold pin in the chuck. Select one: True False
During operating lathe machine, the tool bit should be fixed as short as possible. Select one: True False
q10 Applying finger pressure on the belt near the pulley end is not the correct method to check the tension of the belt drive of a lathe machine. Select one: True False
4 ___________ tool is used for verifying the flatness of the component. A. Protractor B. Engineer square C. Micrometer D. Spirit leveler
13q The drive belt of the lathe machine is noticed with excessive wear, maintenance step followed is Replaced with same matched set of drive belts Repair the drive belts found with excessive wear Replaced with different matched sets of drive belts No need to repair the drive belt with excessive wear
Drill bit is fixed in the headstock of a lathe during the drilling operation. Select one: True False
A tool make easy work of removing broken threaded ends of pipe, plugs & fittings. A tool make easy work of removing broken threaded ends of pipe, plugs & fittings. Pipe Reamer Pipe Vise Pipe Extractor Flaring tool Pipe tap
Drill bit is fixed in the tailstock of a lathe during the drilling operation. Select one: True False
Cleaning of machine tool should be carried out daily. Select one: True False
Briefly describe the process of aligning a milling vise with the table movement using a dial indicator.
It is a widely use tool for laying out squaring and checking work.It consists is a square head and a steel rule [a)combination square (b)center punch (c) try square (d)center square)
Under staticload or when static load is applied ,most of the machine elements re failed True False