three transformers, connectd delta on the primary side and wye delta on the secondary side, step the voltage down from 13,200 to 460 volts and deliver a 750kVa, 0.8 pf load. a) calculate the ratio of transformation of each transformer. b) calculate the kVa load of each transformer. c) calculate  the current deliverd to the load in amperes.

Q: A professional center is supplied by a balanced three-phase source. The center has four plants, each…

A:

Q: A 3000/200V ,50hz. , single phase transformer has a cross sectional area of 150 cm2 for the core. If…

A:

Q: ell HW4C2 *S. Using superposition, determine the current I, for the net- work of Fig. 18.116 (u 20;…

A:

Q: If the Q-factor of a coil at resonant frequency of 1.5 MHz is 150 for a series resonant circuit,…

A: Given: Quality factor, Q = 150 Resonant frequency, fr=1.5 MHz

Q: Q1) A. Draw the frequency response |H(w)| of all types of filters. B. Find the Fourier transform of…

A:

Q: Example23/ Two transformers (4) are designed to match a line having a Z, = 3002, Zr = 75N find…

A:

Q: list three (3) advantages and three (3) disadvantages of PLC (Programmable Logic Controller

A:

Q: Shown in the signal below where 0≤t≤20 ms determine the period N   choose one: a.6 b.3 c.2 d.5…

A: We need to find out time period

Q: ind IBq,Icq, VcEq, VB, VE,Vc 16 V Ico 1.8 k2 510 k2 Vc VB VCEQ B= 120 IBQ VE

A:

Q: 3. A Superheterodyne receiver uses high side injection. The receiver is to tune the RF range 500kHz…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: deterptiar the alue to a clese leep Coantael Date. tn a cteed teep Contrel system $s Hal, yte due to…

A:

Q: Why do you think some motor control circuit utilizes single voltage sources for control and power…

A: Types of Motor control based on power supply  Three power supply  Two wire supply  Types of…

Q: Calculate the electric field intensity in millivolts per meter (mV/m) at 30kW from a 5 km source

A: Brief description : In the above given question they are discussing about electric field intensity…

Q: 50. Find the rms value of the periodic waveform in Fig. 101 over one full cycle. I ycle 6 7 $ 9 D 11…

A: We need to find out RMS value for waveform .p

Q: 220Vrms, 3-Ph, Y-connected symmetrical positive sequence source is connected to 21+ J24Q/Ph,…

A: In this question we need to find a average power absorbed by the load

Q: 1 X(z) for the sequence x(n) 2"-3 u(n – 3)is z-3 (1–2z-3)

A:

Q: Question # 1: A 208-V, 10-hp (1 hp=746 W), four-pole, 60-Hz, Y-connected induction motor has a…

A:

Q: 4.5 QUESTIONS 1. What is level sensitive SR latch? 2. Draw D latch and give the outputs of the gates…

A: SR latch: It is a two-input independent device. It contains two NOR gates connected as a cross…

Q: 3 2 1 -1 -2 -3 0.5 1 1.5 t ·10-2 (u)a (4)"x

A:

Q: 1 X(2or the sequence x(n) = 2"-3 u(n - 3)is z-3 (1-2z-3)

A: The solution is given below

Q: Trianqular wine laap given 8 =4T Co,90) C4,0,0) Ca,o,4> wire resistane - Find indurad current…

A: The magnetic field from a system of conductors is always perpendicular to the direction of induced…

Q: 3.30 i (a) Use Maxwell's first equation, V · D = pv, to describe the variation of the electric field…

A:

Q: Example: Determine the current I, in the network in Fig. shown below using nodal analysis, loop…

A:

Q: (b) (i) Discuss THREE advantages of a brushless DC motor over a conventional DC motor, Gi) (ii)…

A: b) i)We need to discuss three advantages of a brassless DC motor over a conventional DC motor.…

Q: A short single phase transmission line consists of two sections AB and BC. AB is 18km in length and…

A: The solution is given below

Q: (d) Bilinear Transformations and Equivalence One approach to realising a digital filter is to…

A: Butterworth filter is a filter used for filtering low frequencies, in the passband as it is Q factor…

Q: What is a resistor and what it’s used  for

A:

Q: Solve the Laplace Transform f(t)= coshωt sinωt

A: In this question,   We need to determine the Laplace Transform Of the given signal.

Q: Given, G(jw) = (-2+3jw). Therefore magnitude at w=1 is, O a. 3.6 O b. 2 Oc2.2 O d. 4.5

A: Given: Transfer function Gjω=-2+3jω And ω=1

Q: A utility offers a capacity-based incentive of $0.07/AC watt. A customer installs a 1 kW PV array…

A:

Q: 2. A TRF receiver is to be designed with a single tuned circuit using a 10µH inductor. The ideal…

A: According to the question,

Q: 3. Determine the Thevenin's and Norton's equivalent circuits across a-b. 122 8A S12

A:

Q: Calculate the resistance of the field coil. Show your calculations results table incase…

A: The given table is as shown below,

Q: A second modulating tone having the same amplitude but a different frequency is added to the first…

A:

Q: Answer following questions: (a) At t = 5 ms, a sinusoidal current i is known to be zero and going…

A:

Q: 1. Calculate v, in the circuit using superposition. 2H 62 ww ell 12 cos 31 V t 4 sin 2t A 10 V

A:

Q: 8(A) For the BJT transistor circuit shown below, determine whether the transistor is biased in: а.…

A: We need to find out current and voltage for given circuit and region of operation

Q: Given, r(t) = 3t^2, therefore its laplace transform is O a 6/s^3 O b. 6/ s^2 Oc 3/ s^2 O d. 8/ s^3

A:

Q: Example25/ T-L with Zo=600 N ,ZR = 100 N. Find the length and location of the single stub terminated…

A:

Q: A multi-loop block diagram is shown in figure shown.

A:

Q: 1. Define stability factor in BJT. 2. What are the Characteristics of an Ideal Op Amp? 3. What are…

A: As per the guidelines of bartleyby I need to answer first three questions only so kindly repost…

Q: The ROC is null for the sequence x(n) = 2" u(n)-)" u(-n – 1)

A:

Q: 3z2-7z X(z) for the sequence x(n) =2 u(n) + 3" u(n) is (z-1)(z-3)

A:

Q: 28. Write the analytical expression for the waveform of Fig. 86 with the phase angle in degrees.

A:

Q: 7. A 3-phase, 400 V synchronous motor having a power consumption of 50 kW is connected in parallel…

A: Given: 3-phase 400V, 50kW synchronous motorInduction motor with 200kW, 0.8 lagging power factor

Q: X(z) for the sequence x(n) = 2n-3 u(n – 3)is z-3. %3D (1-2z-3)

A:

Q: Calculate the cutoff frequency of the LPF section that can be constructed from a capacitor of 120 uF…

A:

Q: Convert delta connected impedances 12<36 deg ohms to balanced wye connected impedances.

A: The solution is given below

Q: Three-phase transmission line 90 km long Line impedance z=(0.4+j0.9) ohm/km, If the power Pr=60 MW…

A: The solution is given below

Q: Let a uniform surface charge density of 5 nC/m² be present at the z = 0 plane, a uniform line charge…

A: a uniform surface charge density of 5 nc/m2 be present at the z=0 plane . a uniform line charge…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.