To have two alternators in parallel, which of the following factors should beidentical for both?VoltageFrequencyPhase sequenceO Voltage, frequency, phase sequence and apparent powerVoltage, frequency and phase sequenceVoltage generated per phase in an alternator is proportional toFrequency of waveformNumber of turns in armatureFlux per poleWinding factorsEverything mentioned in the options

Answered: Image /qna-images/answer/352a3d22-5381-4467-85a5-297adb2e9cc4.jpg

Answered: To have two alternators in parallel,

Engineering

Electrical Engineering

To have two alternators in parallel,

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.56P: Three single-phase two-winding transformers, each rated 3kVA,220/110volts,60Hz, with a 0.10 per-unit...

See similar textbooks

Related questions

Q: [1] Draw output waveform for the following circuits if sinusoidal signal of 6V peak-to-peak with…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when…

Q: B- two transformers A and B are connected in parallel to a load of (2+j1.5). Their impedances in…

Q: 4. For the network of Fig. 4.136, determine: a. I B b. Ic C. V CE d. V c 9.1 ΚΩ Ver 12 ΚΩ VCE B-80 •…

Q: Find the output voltage v.(t) using the Fourier transform for the circuit given when v(t) = etu(−t)…

Q: In the parallel circuit, the voltmeter reads 45 volts across the 3 ohm resistor. What is the anmeter…

A: Given circuit, V3Ω=45 V

Q: In THEVENIN'S, it is allowable to set a dependent source to zero in the computation of the…

A: TRUE or FALSE for given statements:

Q: Solve the collector voltage of a voltage-divider bias circuit with Vcc=9V, R1=560k ohms, R2 = 560k…

A: We need to find out the collector voltage for given circuit

Q: Kindly answer this please, thank you! A potential difference of 232 V is applied to a field winding…

Q: Evaluate and sketch the block diagram representation of the Direct Form I and II for the following…

A: Brief description: In the above given question they have mentioned a difference equation. For the…

Q: If φ(x, y, z) = x 2 z + e y/x , evaluate grad φ at the point (1, 0, −1).

Q: 4. Signal conditioning element basically takes the output of the sensing element and converts it…

A: The sampling frequency of a signal can be described as the rate of dividation of a signal at which…

Q: Solve I1, I2, I3

A: The circuit is as shown below,

Q: 1. How many states are there in an 8-bit Johnson counter sequence?

A: A johnson counter can repersent 2N states where N is the number of bits. Here N = 8 Hence number of…

Q: Q10: when press the button if the input convert from high to low what is the type of the resistor:…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Through two parallel wires A and B, 10 A and 2 A currents are passed, respectively, in opposite…

Q: A combination of three resistors R1, R2 and R3 in a series is connected across voltage source VT.…

Q: Briefly explain what is Ampere's circuit law in Magnetostatic Fields.

A: In this question we explain about Ampere's circuit law

Q: find AMe force on a foint charge of So Mc out MC0,0.5) due to a charge of soome that is uniformly_…

A: Force acting on a point charge is equal to the vector addition of all the points charges acting on…

Q: From the transistor collector characteristic shown, determine βac for an operating point of IB =…

A: From the Question From the transistor collector characteristic shown, determine βac for an operating…

Q: Find the Laplace transform of each function.

Q: 6. Determine the currents 11, 12 and lp for the network shown. Find also the voltage drops V1 and…

A: 6) To determine currents i1, i2 and ID for the given diode circuit and also find V1 and V2

Q: a) H(z) Z-¹-32-2 = (10-z-¹)(1+0.5z-¹+0.5z-2)

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: An AM signal has the equation: Find the amplitude of the sidebands v(t) = [15 + 4 sin (44 x 10^3t)]…

Q: y(n) = −0.17y(n − 1) – 0.3y(n − 2) + 0.04x(n) + 0.319x(n − 1) - -

Q: The following information is given in connection with an alternator slot = 144; poles = 8; speed =…

A: Whole Coiled:- When we distribute the all coils over the whole armature periphery, then the armature…

Q: Determine the overall h-parameters of the following network shown below.

A: The given circuit is as shown below,

Q: 8. Three JK flipflops are connected as a synchronous counter that goes through the following…

A: In this question we need to design a given counter

Q: Find the currents using Maxwell's Method

A: Brief description: By the use of mesh analysis we need to calculate the values of all the branch…

Q: transformer has its maximum efficiency of 98% at 20kVA and unity power factor. During the day, it is…

A: In this question we need to find a all day efficiency of the given transformer

Q: A 300 KVA 1-ph transformer is designed to have a resistance of 1.8% and maximum efficiency occurs at…

Q: 03) The equivalent parameters of a transfor . secondary-side are Regs = 20 22 and Xegs = 10 £2…

Q: Find the output voltage vo(t) using the Fourier transform for the circuit given when v(t) = e'u(-t)…

Q: The dc shunt generator given its rated voltage when the field resistance is higher than critical. O…

A: We know that the critical field resistance is the highest allowable shunt field winding resistance…

Q: An amplifier has a Rin = 1.2 kΩ. The coupling capacitor is 1 µF. Determine the approximate lower…

Q: A unity feedback system has the open loop transfer function shown below. Use the Nyquist Path that…

A: In this question we need to find a value of N for large k

Q: 5. A 5 hp, 220 V, 60 Hz, four-pole three-phase induction motor operatesat 1740 r/min when fully…

A: Given information about a three-phase induction motor is, Number of poles P=4. Supply frequency f=60…

Q: 2. Using Kirchhoff's Voltage Law, find the current through the R₂. 8V 3V R3 18 Ω R2 202 R1 302 www

Q: Multiply with the least common factor to remove any fractions. 12/0°V E2 1. Iy 192 www 192 www A…

Q: A 10 – hp, 4 pole, 25Hz 3-phase induction motor is taking 9100 watts from the line. Core loss is 29…

Q: e Am DSBFC wave with a peak

A: Amplitude modulation-When modulation is done by taking amplitude of information signal modulated and…

Q: Let the Fourier transform of the signal x(t) is X(f) shown below, sketch Fourier transform of the…

Q: snown Figure 2, determill 100 V potential difference across AB 102 592 15 02 202 Figure 2 1592 -O A

Q: ndard practice of synchronous generator construction now a days is to ndrical field ating armature…

A: These are the few questions related to the basic understanding of alternators their construction and…

Q: Three JK flipflops are connected as a synchronous counter that goes through the following QcQQA…

Q: Problem 3 Determine inverse z-transform of the following equations: a. b. (2-2)² (2-1)(2-0.5) ܐܕ

A: given here some z transform functions and asked to find inverse z-transform for those functions.…

Q: To measure IR1, the ammeter should be connected at terminals: 4 5 1 2 3 78 R1 10 11, O 4-5 01-2 O…

A: To measure the current IR1 through resistor R1, the ammeter should be connected at terminals 1 - 2…

Q: Usung K-map technique = E (0,2,5, 8, 10, 14) simplify the function F(A, B, C. + d (1, 3, 4, 6, 7, 9,…

Q: Electrical Engineering For a unit feedback system having the following gain functions: G(s) Ks -…

A: Given: For a unity feedback system having the following gain functions: Gs=Ks-4.21s22s+5.7 To find:…

Q: 2. Find the IN and RN of the circuit shown below as seen from the terminals A and B. 10V 212 63 72…

Q: 5. Determine the currents 11, 12 and 13 for the network shown. Find also the D₁ ½2 3.3 ΚΩ voltage…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

To have two alternators in parallel, which of the following factors should be
identical for both?
Voltage
Frequency
Phase sequence
O Voltage, frequency, phase sequence and apparent power
Voltage, frequency and phase sequence
Voltage generated per phase in an alternator is proportional to
Frequency of waveform
Number of turns in armature
Flux per pole
Winding factors
Everything mentioned in the options

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three single-phase two-winding transformers, each rated 3kVA,220/110volts,60Hz, with a 0.10 per-unit leakage reactance, are connected as a three-phase extended autotransformer bank, as shown in Figure 3.36(c). The low-voltage winding has a 110 volt rating. (a) Draw the positive-sequence phasor diagram and show that the high-voltage winding has a 479.5 volt rating. (b) A three-phase load connected to the low-voltage terminals absorbs 6 kW at 110 volts and at 0.8 power factor lagging. Draw the per-unit impedance diagram and calculate the voltage and current at the high-voltage terminals. Assume positive-sequence operation.
What conditions must be met before two alternators can be paralleled together?
Assume that Alternator A is supplying power to a load and that Alternator B is to be paralleled to A. After the paralleling has been completed, what must be done to permit Alternator B to share the load with Alternator A?
The direct electrical connection of the windings allows transient over voltages to pass through the auto transfonner more easily, and that is an important disadvantage of the autotransformer. (a) True (b) False
The effective resistance of a 2200 V, 50 Hz, 440 KVA, 1 -phase alternator is 0.5 ohm. On short-circuit, a field current of 40 A gives the full load current of 200 AS. The electromotive force on open-circuits with same field excitation is 1160 V. Then the synchronous impedance and reactance is _______ ohm and _______ ohm respectively.
A three-phase Y-connected alternator delivers a unity power-factor load at 230 volts. If the synchronous-reactance voltage drop is 60 volts per phase, calculate the per cent regulation, neglecting the resistance voltage drop.Ans.: 9.77%
Two identical three-phase Alternators A and B share equally a load of 10 MVA at 33 KV and 80% lagging power factor. The synchronous reactance of each generator is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry a25 amperes at lagging power factor. What is the current delivered by Alternator B ?
What is the alternators terminal phase voltage at shorted load condition? Explainand justify your answer in one(1) sentence.Use IA as the reference phasor.
Completely solve and box the final answer. Write legibly A 1200 kVA, 6600 volts, 3-phase Y connected alternator, has an effectiveresistance of 0.4 ohms and a reactance of 6 ohms per phase. It delivers fullload current at 0.8 lagging power factor at rated voltage. What will be theterminal voltage for the same excitation and load current, if the power factoris 0.8 leading? Show the phasor diagram. [ Ans. 7899 V ]
The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
A three-phase Y-connected alternator delivers a unity power-factor load at 220 volts. If the synchronous-reactance voltage drop is 50 volts per phase, neglecting the resistance voltage drop. a. calculate the generated voltage b. calculate the percent regulation
Three of a 15 kVA, 2200:220 V, 50 Hz transformer are connected in ∆-∆ to supply at 220 Voltsline-to-line a three-phase induction motor load of 20 kVA. The power factor of the induction motor is0.85. The load is connected to the transformers by means of a common three-phase feeder whoseimpedance is 0,03+j0,06 Ω/phase. The transformers themselves are supplied from a constant-potentialsource by means of a three-phase feeder whose impedance is 2,5+j6,0 Ω/phase. The equivalentimpedance ((R''1+R2)+j(X''ℓ1+Xℓ2)) of one transformer referred to the low-potential side (secondary) is0,4+j0,5 Ω/phase. The magnetizing inductance and the resistance representing the core loss areneglected. Calculate the required source line voltage (Vs) if the load line voltage is 220 Volts.Hint: ZY = (1/3)Z∆