(Can you add a sketch please) A torque of 50 Nm producing a counterclockwise rotation is applied to a wheelabout its axle. A frictional torque of 10 Nm also acts on the axle. If the wheelmoves at a rate of 2 rad/s² under the influence of these torques, what is therotational inertia of this wheel?TuTU - TORR-TO

GivenTorque applied to axle , τapplied=50 NmFrictional torque, τFrictional=10 Nmα=2 rad/s2

Answered: torque of 50 Nm producing a…

torque of 50 Nm producing a counterclockwise rotation is ap bout its axle. A frictional torque of 10 Nm also acts on the axl nyes at a rate of 2 rad/s² under the influence of these torques.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter10: Rotational Motion

Section: Chapter Questions

Problem 39P

See similar textbooks

Related questions

Q: The terminal velocity of a person falling in air depends upon the weight and the area of the person…

Q: A pipe with a diameter of 8 cm narrows to a diameter of 5 cm. If water is moving with a speed of 1.5…

A: Given data as per the question Diameter at one end =8 cm Diameter at another end =5 cm

Q: What gauge pressure is required in the city water mains for a stream from a fire hose connected to…

A: Given data as per the question Vertical height required =20 m 20mm is very less height from the fire…

Q: iv) Assume that two identical cars of mass m drive along a highway. One car approaches a curve of…

A: Given data: Mass for both cars = m First car goes to radius = 2R Speed for first car = v Second…

Q: A 78.0 kg hoop rolls along a horizontal floor so that its center of mass has a speed of 0.0720 m/s.…

A: The given data we have: Mass of the hoop: 78.0kg Velocity of the center of mass: 0.0720 m/s The…

Q: An 8.0 kg sled is initially at rest on a horizontal road. The coefficient of kinetic friction…

Q: ater travels through a pipe at 8.22 m/s. The pipe contracts from a crossectional area of 2.5 m2 to…

Q: What would be the BEN in MeV be for a nucleus with 91 protons, 141 neutrons and an atomic mass of…

A: It is required to find the binding energy per nucleon (BEN) for a nucleus with 91 protons and 141…

Q: voltage V = 20 cos (@t) volt with @= 2000 rad/s the amplitude of the current will be nearest to (a)…

A: Current is the rate at which electrons flow past a point in a complete electrical circuit. Here, we…

Q: 2. A wooden block of mass 20 kg is floating in a pool. This is a fresh water pool, so we can assume…

Q: 37. Touch-Tone Phones On a Touch-Tone phone, each button produces a unique sound. The sound produced…

A: It is given that the sound produced is the sum of y=sin2πt and y=sin2πht. Thus, the expression for…

Q: A heavy ball is swung from a string in a horizontal circle. At the point shown in the diagram to the…

A: To answer this question we need to have some basic understanding about the motion in horizontal…

Q: 9 x 10 B) 7 x 10 the spherical shell. C) 5 x 10 08: 1Volt is equivalent to: (in N/C) at a distance…

A: Part (7):Given: The strength of the electric field is 500 N/C. The initial speed of the proton is 0…

Q: Activity 13.1 Forces Consider a 38-kg traffic light hanged to the post by two wires. You are to…

Q: A battery-driven Percy engine goes around a track (radius 23 cm) in 70 seconds. What is its angular…

Q: The 2nd Law of Thermodynamics claims that the most efficient Carnot engine is achieved with the…

Q: balanced on the edge of a table 0.800 m above the floor. If the bullet embeds itself into the block,…

A: Given: mass of bullet, m1= 25.0 g initial speed of bullet, v1=500 m/s mass of block, m2= 0.750 kg…

Q: computer generated a refracted image of the spoon in the glass of water. Assuming that the spoon…

Q: A uniform disk of mass M and radius R starts from rest at the top of an incline at a vertical…

A: Given: Uniform disk of mass, M radius, R To Find: Velocity of centre of mass of disk at bottom of…

Q: A torque of 0.87 N.m is applied to a bicycle wheel of radius 40 cm and mass 0.70 kg. Part A Treating…

Q: A beam of electrons (of charge de and mass mė) is shot into a region of uniform magnetic field with…

Q: 8. A resistance of 100 , a capacitor of capacitive reactance 20 92, and an inductor of inductive…

Q: Use the following information. Michael Kasha, of Florida State University, used physics and…

Q: A concave mirror has a focal length of 15 cm. What is the magnification if the object's distance is…

A: Given, The focal length of the concave mirror (f) = -15 cm =-0.15 m (Applying the sign convention)…

Q: A beam of light in water (of refractive index of 1.33) enters a glass slab (c refractive index 1.50)…

A: Write the given data Refractive index n1=1.33Refractive index n2=1.50Angle of incidence sin i=60°

Q: Some non-digital scales use springs to determine the mass of interest. A grocery store provides…

A: Given K1=4.5 N/mm (spring constant of spring 1) K2=3.1 n/mm (spring constant of spring 2) Equivalent…

Q: A satellite has a mass of 250 kg. (mEarth = 5.97x1024 kg, rEarth = 6.38x106 m, G = 6.67x10-11…

Q: ▾ Part A If the ball is released from rest at a height of 0.64 m above the bottom of the track on…

Q: Calculate the moment of inertia for a solid sphere with radius 0.050 m and mass 0.79 kg. Express…

Q: A sound of 120 dB is __________.

A: Decibel level (dB) of sound = 10logII0 =I is intensity of sound and I0 is threshold intensity So,…

Q: Express the angular velocity of the second hand on a clock in the following units:

A: Expressing the angular velocity of the second hand on a clock in rad/s , deg/min and rev/hr.

Q: Physical data is often used in the court system. In fact, police officers use radar to determine…

A: Given:- The police officer claimed that the driver was speeding at vobs= 44.7 m/s The driver…

Q: In a hydraulic system, a force of 400 N is exerted on a piston with an area of .001 m². The…

Q: how refractivity is defined.

A: How refractivity is defined.

Q: A child tries to move his toy box by pulling on a rope at an angle θ of 42° with respect to the…

Q: A cube 5.5 cmcm on each side is made of a metal alloy. After you drill a cylindrical hole 3.0 cmcm…

A: Given data:- the given cube size is, 5.5 cm from each side. After you drill a cylinder hole 3.0 cm.…

Q: A 1.40 kg object is placed in 100 L of water. The water level rises to 103.5 L. What is the density…

A: Given: The mass of the object is 1.4 kg. The volume of the water increases from 100 L to 103.5 L.

Q: FF 4. Find the acceleration of the blocks and the tension in the rope. 8 kg u=0.2 Fn T T mg =8 Ff 4…

Q: the polypropylene has a refractive index of 1.5, what the wavelength of the laser light whose…

Q: A wire is made by attaching two segments together, end to end. One segment is made of aluminum and…

Q: A spider hangs from a strand of silk whose radius is 4.0 x 10-6 m. The density of the silk is 1300…

Q: The position vector of a 2.5 kg particle is given by r=4.0 i +3.0² ĵ, where r is in meters and is in…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: C. Work Problems: 4. F = 90 N d=5m W-? 5. F=6N W = 72 J d=? pidori 15w09.0 6. W-120 J d=24 m F=?

A: As per the bartleby guidelines only the first 3 questions has been solved please re-post the other…

Q: An 89 mm diameter platter in a computer hard drive spins at 7200 rpm (revolutions per minute). What…

A: Given:- The diameter of the plater in a computer hard drive d = 89 mm The hard drive spins with the…

Q: As an engineer, you must also be mindful of the plumbing system of the house. In a house you are…

Q: Steven is flying at 250 knots in his Spitfire. He knows that he can withstand a maximum acceleration…

Q: source with frequency 1.50 [kHz]. What is the impedance of this circuit and the relationship of its…

Q: Help

Q: Newton block slides down an inclined plane that has an angle of 60.0° If the coefficient of kinetic…

A: θ = 60o μk = 0.15 Let the mass = m

Q: The light beam shown in the figure below makes an angle of = 24.0° with the normal line NN' in the…

A: Given data as per question Refractive index of linseed oil =1.48

Concept explainers

Angular speed, acceleration and displacement

Angular acceleration is defined as the rate of change in angular velocity with respect to time. It has both magnitude and direction. So, it is a vector quantity.

Angular Position

Before diving into angular position, one should understand the basics of position and its importance along with usage in day-to-day life. When one talks of position, it’s always relative with respect to some other object. For example, position of earth with respect to sun, position of school with respect to house, etc. Angular position is the rotational analogue of linear position.

Question

(Can you add a sketch please)

A torque of 50 Nm producing a counterclockwise rotation is applied to a wheel
about its axle. A frictional torque of 10 Nm also acts on the axle. If the wheel
moves at a rate of 2 rad/s² under the influence of these torques, what is the
rotational inertia of this wheel?
Tu
TU - TORR-TO

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Angular speed, acceleration and displacement

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Calculate the rotational kinetic energy of a 12-kg motorcycle wheel if its angular velocity is 120 rad/s and its inner radius is 0.280 m and outer radius 0.330 m.
A constant torque is applied to a rigid body whose moment of inertia is 4.0kgm2 around the axis of rotation. If the wheel starts from rest and attains an angular velocity of 20.0 rad/s in 10.0 s, what is the applied torque?
A potters wheela thick stone disk of radius 0.500 in and mass 100 kgis freely rotating at 50.0 rev/min. The potter can stop the wheel in 6.00 s by pressing a wet rag against the rim and exerting a radially inward force of 70.0 N. Find the effective coefficient of kinetic friction between wheel and rag.
A turntable (disk) of radius r = 26.0 cm and rotational inertia0.400 kg m2 rotates with an angular speed of 3.00 rad/s arounda frictionless, vertical axle. A wad of clay of mass m =0.250 kg drops onto and sticks to the edge of the turntable.What is the new angular speed of the turntable?
A baseball pitcher throws the ball in a motion where there is rotation of the forearm about the elbow joint as well as other movements. If the linear velocity of the ball relative to the elbow joint is 20.0 m/s at a distance of 0.480 m from the joint and the moment of inertia of the forearm is 0.500kg-m2 , what is the rotational kinetic energy of the forearm?
A man stands on a merry-go-round that is rotating at 2.5 rad/s. If the coefficient of static friction between the man’s shoes and the merry-go-round is s=0.5 , how far from the axis of rotation can he stand without sliding?
A 12.0-kg solid sphere of radius 1.50 m is being rotated by applying a constant tangential force of 10.0 N at a perpendicular distance of 1.50 m from the rotation axis through the center of the sphere. If the sphere is initially at rest, how many revolutions must the sphere go through while this force is applied before it reaches an angular speed of 30.0 rad/s?
A grindstone with a mass of 50 kg and radius 0.8 m maintains a constant rotation rate of 4.0 rev/s by a motor while a knife is pressed against the edge with a force of 5.0 N. The coefficient of kinetic friction between the grindstone and the blade is 0.8. What is the power provided by the motor to keep the grindstone at the constant rotation rate?
A solid cylinder of radius 10.0 cm rolls down an incline with slipping. The angle of the incline is 30 . The coefficient of kinetic friction on the surface is 0.400. What is the angular acceleration of the solid cylinder? What is the linear acceleration?
A constant net torque is applied to an object. Which one of the following will not be constant? (a) angular acceleration, (b) angular velocity, (c) moment of inertia, or (d) center of gravity.
A 10.0-kg disk of radius 2.0 m rotates from rest as a result of a 20.0-N tangential forceapplied at the edge of the disk. What is the kinetic energy of thedisk 4.00 s after the force is applied?
A flywheel (I=100.0kgm2) rotating at 500.0 rev/min is brought to rest by friction in 2.0 min. What is the frictional torque on the flywheel?