Two blocks on two inclines are attached by a string over a pulley where the two inclines meet. When the blocks are released from rest, the 25 kg block on the 67° incline slides down the incline, pulling the 32 kg block on the 24° incline up its incline. In both cases the coefficient of friction between the block and the incline is 0.13. Determine the acceleration of the blocks and the tension in the string joining them as they accelerate. 32 kg 24° 67° 25 kg

Two blocks on two inclines are attached by a string over a pulley where the two inclines meet. When the blocks are released from rest, the 25 kg block on the 67° incline slides down the incline, pulling the 32 kg block on the 24° incline up its incline. In both cases the coefficient of friction between the block and the incline is 0.13. Determine the acceleration of the blocks and the tension in the string joining them as they accelerate. 32 kg 24° 67° 25 kg

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter6: Applications Of Newton's Laws

Section: Chapter Questions

Problem 40P: A service elevator takes a load of garbage, mass 10.0 kg, from a floor of a skyscraper under...

See similar textbooks

Similar questions

A car is stuck in the mud. A tow truck pulls on the car with the arrangement shown in Fig. P4.32. The tow cable is under a tension of 2 500 N and pulls downward and to the left on the pin at its upper end. The light pin is held in equilibrium by forces exerted by the two bars A and B. Each bar is a strut; that is, each is a bar whose weight is small compared to the forces it exerts and which exerts forces only through hinge pins at its ends. Each strut exerts a force directed parallel to its length. Determine the force of tension or compression in each strut. Proceed as follows. Make a guess as to which way (pushing or pulling) each force acts on the top pin. Draw a free-body diagram of the pin. Use the condition for equilibrium of the pin to translate the free-body diagram into equations. From the equations calculate the forces exerted by struts A and B. If you obtain a positive answer, you correctly guessed the direction of the force. A negative answer means that the direction should be reversed, but the absolute value correctly gives the magnitude of the force. If a strut pulls on a pin, it is in tension. If it pushes, the strut is in compression. Identify whether each strut is in tension or in compression.
A firefighter with a weight of 7 N slides down a vertical pole with an acceleration of 3.00 m/s, directed downward. What are the magnitudes and directions of the vertical forces (a) on the firefighter due to the pole and (b) on the pole due to the firefighter?
If the order of the barges of the preceding exercise is reversed so that the tugboat pulls the 3.00 × 103 -kg barge with a force of 20.0 × 103 N, what are the acceleration of the barges and the tension in the coupling cable?
When the Moon is directly overhead at sunset, the force by Earth on the Moon, FEM , is essentially at 90° to the force by the Sun on the Moon, FSM , as shown below. Given that FEM = 1.98 × 1020 N and FSM = 4.36 × 1020 N, all other forces on the Moon are negligible, and the mass of the Moon is 7.35 × 1022 kg, determine the magnitude of the Moon’s acceleration.
If the skier above weighs 150 lbs, what is the magnitude of the force of the skier (FS), the normal force (FN), and the force that makes the skier want to slide down the hill?
Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of the blocks, as shown. The coefficient of kinetic friction between the blocks and the surface is 0.25. If each block has an acceleration of 2.0 m/s2to the right, what is the magnitude F of the applied force?
A woman of mass 58.4 kg is standing in an elevator. If the elevator floor pushes up on her feet with a force of 404 N, what is the acceleration of the elevator? Assume the +y-direction to be up. Enter a negative answer if the acceleration is downward and a positive answer if the acceleration is upward. If the elevator maintains constant acceleration and is moving at 1.50 m/s as it passes the fourth floor on its way down, what is its speed 4.00 s later?
A child on a sled (total mass 55 kg) accelerates down a 16.1 degree incline at 1.43 m/s^2. What is the magnitude of the forces opposing motion?
The person in Figure P4.49 weighs 170. lb. Eachcrutch makes an angle of 22.0° with the vertical (as seen from thefront). Half of the person’s weight is supported by the crutches,the other half by the vertical forces exerted by the ground on his feet. Assuming he is atrest and the force exerted bythe ground on the crutchesacts along the crutches, determine(a) the smallest possiblecoefficient of friction betweencrutches and ground and(b) the magnitude of the compressionforce supported byeach crutch.
A shopper pushes a 8 kg shopping cart up a 300 incline. If the applied force is parallel to the surface, find the magnitude of force needed to give the cart an acceleration of 2 m/s2. Neglect the friction
the net external force on the 24-kg mower isstated to be 51 N. If the force of friction opposing the motionis 24 N, what force F (in newtons) is the person exerting onthe mower? Suppose the mower is moving at 1.5 m/s whenthe force F is removed. How far will the mower go beforestopping?
A block of mass m1 = 4.0 kg on a frictionless plane inclined at angle θ = 30.0° is connected by a cord over a massless, frictionless pulley to a second block of mass m2 = 3.0 kg as shown below. What are: a) the magnitude and direction of the acceleration of each block, b) the tension in the cord?