Two coils A and B known to have the same resistance are connected in series across a 110V, 60 cycle line. The current and power delivered by the source are respectively 4.1A and 300W. If the voltage across coil A is twice that across coil B. Calculate the inductance of coil B

Two coils A and B known to have the same resistance are connected in series across a 110V, 60 cycle line. The current and power delivered by the source are respectively 4.1A and 300W. If the voltage across coil A is twice that across coil B. Calculate the inductance of coil B

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Related questions

Q: Briefly explain the working of following power plants a) Thermal Power plant b) Hydel power plant

A: Given: a) Thermal Power plant b) Hydel power plant

Q: Through a 1-phase electrical installation, the power of 2500 W is carried by a 20 m long cable with…

A: Given 1 phase cable P =2500 W length l =20 m area =2.5 mm2 conductivity of cable =K =56 MS/m…

Q: In a 33 kV overhead line, there are three units in the string of Example 1. insulators. If the…

Q: 2. The capacitances of a 3-core belted type cable are measured as detailed below: (i) Between three…

A: The solution is given below

Q: Q2: In a 3 units suspension insulator, the voltage across the top and middle units are 30% and 32%…

A: We will find ratio of capacitance of insulators to its capacitance to earth by taking ratio between…

Q: A relay has a resistance of 350 ohms and an inductance of 0.8 henry. V volts is suddenly impressed…

Q: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on…

A: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on voltage…

Q: 1. A current of 5 Amp flows through a non - inductive resistance in series with a choking coil when…

Q: Compare Wind Energy and Solar Energy

A: a) Site requirements: Wind energy: Wind energy systems perform well in plain land states. Solar…

Q: q) 150 kv single core cable has a radius of cable of 5cm. The insulation martial has two layers. The…

A: This is q very good question based on power system topic of transmission. Here we have to find the…

Q: How to calculate to continues power of 500KVA generator at 60hz, 440v, pf

A: In this question we will find continuous power...

Q: TOPIC: Ohm's Law, Power and Generating Direct Current Direct Current Circuit Analysis Inductor,…

Q: Exercise 2: Resistance-Inductance Series Circuits on an AC Supply Calculate (a) peak to peak voltage…

Q: 3. A coil has a resistance of 32 ohms and reactance of 24 ohms when connected across a 440V, 60HZ…

Q: 50. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The…

Q: Three coils each having resistance 6  and inductance are connected in star with 415V. If the line…

A: Given Data: R = 6 ohm VL = 415 V IL = 30 A

Q: 6. A string of four suspension insulators is connected across a 285 kV line. The self-capacitance of…

A: The solution can be achieved as follows.

Q: 18. An iron-cored electromagnet has a d.c. resistance of 7.5 2 and when connected to a 400-V 50-Hz…

A: Note : as per our honor code, we are authorized to answer up to 3 sub-parts, we’ll answer the first…

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 – j6.5)A and(1.8 –…

A: In this question , two parallel branch voltage and currents are given....We have to find out power…

Q: what is the similarities and differences between renewable and nonrenewable sources of energy? Point…

A: The sources of energy that are abundant in nature are the renewable source, while the sources that…

Q: The effective resistance of a 500 V, 50 KVA alternator is 0.2 Q. A disturbing electric current of 10…

A: Given a 500 V, 50 KVA alternator having, Effective resistance, Ra=0.2 Ω Distributing current, I=10 A…

Q: (1) Name and explain any two methods for improving string efficiency. ( (i) A string of suspension…

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (d) the maximum…

Q: Referring to the Figure 2, compute the following values, given that the operating frequency is 60Hz…

A: Given that Voltage E= 120 V Frequency, f=60 Hz A circuit is shown below. Find inductive reactance,…

Q: . Thermal efficiency (nth)of reversible cyclic heat engine absorb amount of heat Q1= 4kW from the…

Q: 3) Switching Impulse (SI) Voltage used to test the withstand ofHV equipm against natural lightning:…

A: Since two different questions are present, as per the guidelines, in the following section, only the…

Q: A power plant produces 1000MW to supply a city 40km away. Current flows from the power plant on a…

A: The solution to part a is as follows, but the solution to part b can not be achieved as the…

Q: Write your conclusion in this module on how the hydro-electric power affects the needs of the…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: An iron cored choke coil has an equivalent resistance of 5 ohm. It draws 10 A when the applied…

Q: - When a voltage is applied to a coil or the applied voltage is cut off, the current of the circuit…

A: When a battery across a coil disconnected then current through the coil stable after some time…

Q: Two electric circuits, represented by boxes A and B, are connected as shown. The reference direction…

A: To understand the logic behind the power flow consider the following equation and diagram In the…

Q: pick one of the following renewable energy sources and justify the selection against the other…

A: Wind energy : Wind energy is the energy which is produced by wind it is the means by which the wind…

Q: Switch ww 10 15 V L 1H

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves the same stage with…

Q: Two heating elements which is 500 ohms and 250 ohms are connected in series with temperature…

A: Given: At temperature, T=20°C The resistances of heating elements are R1=500 Ω and R2=250 Ω The…

Q: A string of suspension insulators consists of three units. The capacitance between each link pin and…

A: As we have given V3=35 kVk=16=0.16

Q: During a weather storm, an atmospheric discharge hits a lightning pole that is grounded through a…

A: Given, The current that passes through the person, I = 0.3 A The man's body resistance (between his…

Q: A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source. If the…

A: A resistor, in series with a 138-microfarad capacitor, Frequency=60Hz The voltage drop across the…

Q: A series-parallel resistive circuit will appear as what kind of load to a power source?…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.…

Q: Two coils are connected in parallel across 100-V supply mains take 10A from the line. The power…

Q: Write about Oman's Power sector scenario 2021

A: The generation and trade of electricity is referred to as the power sector. The term "professional…

Q: A suspension string has 3 units. Each unit can withstand a maximum peak voltage 11kB. The…

A: Line voltage is the conductor between a load and source of the current and the voltage between two…

Q: For the mutual electric circuit shown in figure beside, find the set values of ?mesh currents 1 & 12

Q: Calculate the capacitance of the remaining discs, (b) If the voltages of units one and two are 60%…

A: We have to calculate the capacitance of the remaining discs, and If the voltages of units one and…

Q: Two coils A and B known to have the same resistance are connected across a 110-volts, 60 cycle line.…

A: Given data, Two coils are connected in series. Resistance of both coils are same. Supply 110 V, 60…

Q: (1) Name and explain any two methods for improving string efficiency (ii) A string of suspension…

Q: Three coils each having resistance 6  and inductance are connected in star with 415V. If the line…

A: The value of inductance can not be calculated as frequency is not given.

Q: AC resistance of conductors used in electrical machines which is operating with AC power supply is…

A: In the question, the given Statment "AC resistance of conductors used in electrical machines…

Q: Do you agree that wind turbine will operate and generate electrical power at any wind speed

A: Do you agree that wind turbine will operate and generate electrical power at any wind speed?

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____
You are working as an electrician in a large steel manufacturing plant, and you are in the process of doing preventive maintenance on a large DC generator. You have megged both the series and shunt field windings and found that each has over 10 M to ground. Your ohmmeter, however, indicates a resistance of 1.5 across terminals S1andS2. The ohmmeter indicates a resistance of 225 between terminals F1andF2. Are these readings normal for this type machine, or is there a likely problem? Explain your answer.
Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A: a) find the value of inductive reactance as well as inductance value? B) If θ = 45 then calculate the power dissipation in kW when it is connected in Delta.
Two coils A and B known to have the same resistance are connected across a 110-volts, 60cycle line. The current and power delivered by the source are 5.8 Amperes and 500 watts,respectively. If the voltage across coil A is twice that across coil B, calculate the inductance ofcoil B.
A current of 5 Amp flows through a non – inductive resistance in series with a choking coil when supplied at 250 V, 50 Hz. If the voltage across the resistance is 125 volts and across the coil 200 Volts, calculate: a. Impedance, reactance and resistance of the coil. b. The power absorbed by the coil. c. The total power Draw the phasor diagram.
A resistance 10 Ω and inductance 100mH in series, is connected to a 200V, 50 Hz supply. Calculate (a) the current flowing, (b) the phase difference between the supply voltage and current, (c) the voltage across the Resistance and (d) the voltage across the inductance.
In your solution, follow the sequence: Given, unknown, solution, and final answer. BOX your final answers. thank you! 10. What is the inductance of the coil whose resistance is 100 Ω if it draws 0.55 A from a 110 V. 60 Hz power line?
An iron core 0.4m long and 5 cm2. In cross section, is wound with 300 turns. When a current of 0.5 A flows in the coil, how much is the inductance of the coil. Assume the core has a permeability of 2500. Ans 350mH
The capacitance per kilometre of a 3-phase belted cable is 0.18 µF between two cores with the third core connected to sheath. Calculate the kVA taken by 20 km long cable when connected to 3-phase. 50 Hz, 3300 V supply.
4.Suspension string has 3 units. Each unit can with stand a maximum voltage of 11kV. The capacitance of each joint and metal work is 30 percent of the capacitance of each disc. Find i) Maximum line voltage for which the string can be used?
When an impedance coil is connected to a 114 volt 60 cps source, the current is 3 A. If the current rises to 4 A when a 116 volt 25 cps is is impressed across the coil, determine the values of the resistance and inductance of the coil.
A suspension string has 3 units. Each unit can withstand a maximum peak voltage 11kB. The capacitance of each joint and metalwork 20 % of the each disc. Fin the (a) maximum line voltage for which the string can be used. (b) String efficiency.