Two Conducting Plates of Size 15m are inclined at (450) to each other with gap of width 4mm Seperating as shown in figure below determine an. approximate tatue of the charge pesplate the plates are maintained at potential difference 50 assume that the medium toetween then has Ev=15 Pulth

Two Conducting Plates of Size 15m are inclined at (450) to each other with gap of width 4mm Seperating as shown in figure below determine an. approximate tatue of the charge pesplate the plates are maintained at potential difference 50 assume that the medium toetween then has Ev=15 Pulth

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Compute the current i(t) at the steady-state for Ao = 6, A, e(t) = 10 cos(3t), V, R= 10,ohm,, C=F/3…

Q: 16, determine the For the spring assemblages shown in Figures S nodal displacements, the forces in…

A: The given spring assemblage is shown below:

Q: Evigh 2M Q3: A 2 MVA three-phase, 33/6.6 kV, delta/star transformer has a primary resistance of per…

Q: 4. Find the period of a periodic waveform whose frequency a. 25 Hz. b. 35 MHz. c. 55 kHz. d. 1 Hz.…

A: In this question , we will find period of periodic waveform whose frequency is given... Note :- as…

Q: Draw the ASK, FSK and PSK of 1101001011 digital signal.

Q: Q3:- if the input impedance and voltage gain of a voltage series feed (Rin = 3K) and (A=100) and the…

A: Solution- Given, Rin = 3 KohmA = 100β = 150 So the input impedance of closed loop configuration is…

Q: (2-1) Assuming that the output is feeding a 20-k2 resistor, determine the total voltage gain and…

A: Given the circuit, as shown below: Assuming that the output is feeding a 20 kΩ, we need to…

Q: parallel capacitance needed to correct a load

A: Capacitor- It is one of the passive elements which can't act like source it can only utilize energy.…

Q: 1. The capacitor in the figure is charged with vc (0) = 10 V. Then, clearly state the mathematical…

Q: SECTION 13.2 Sinusoidal ac Voltage Characteristics and Definitions 1. For the periodic waveform of…

A: The given waveform is a periodic waveform and the required parameters can be calculated based on the…

Q: A power transmission line carries current from a 6000 V generator to three loads, A, B, and C. The…

A: Transmission line is the transmit the power from one place to another place. It is long conductor…

Q: (1-b) Build a full-wave rectifier circuit with four diodes to perform the charging function. Explain…

A: Rectifier is a circuit which converts AC into pulsating DC. Full wave rectifier consists of 4…

Q: Assume that the microprocessor can directly address 1M with a and 8 data pins. The maximum RAM…

A: Consider that the microprocessor can directly address 1M with a and 8 data pins. The maximum RAM…

Q: b. Two 1-ph transformers 6000/400V, the first the other is performing the short circuit test the…

A: Condition of Parallel operation of transformer Same frequency Same Voltage Same polarity Same…

Q: Find V4 by using Superposition theorem R₁ R₁ Ron E₁12 V 3012 R. 1 +11 1241 E

Q: Sir as you can see in the diagram below when the voltage is zero current is maximum at the…

A: The charging and discharging in an AC circuit can be alternatively explained as the storage and…

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per…

A: Given data : distance D=25 feet

Q: 03: if the input impedance and voltage gain of a voltage series feedback operational amplifier are…

Q: A 10KVA single-phase transformer provides a no-load secondary voltage of 110 volts. If the…

Q: V (t) lo(t) 1 OHM 1 H 1ohm R M Vo(t)

Q: 5. (a) What is the full form of the word "LASER"? Explain how stimulated emission amplifies light in…

A: (a) LASER: The full form of LASER is "light amplification by stimulated emission of radiation". A…

Q: Industrial Motor Controls 15.a. A discrete input can be which of the following? A. −10–+10 VDC B.…

A: To select correct answer from given options

Q: Va = 120/20° V an In a balanced three-phase system, the source has an abc sequence, is Y-connected,…

A: Given : A balanced 3-phase system, Y connected and Van = 120<20° v Source feeds two loads which…

Q: 2. A 25 cycle current is 15+j0 amp flows in an impedance having a resistance of 17.32 ohms and…

A: 2. Given data, Frequency, f=25 Hz Current, I=15+j0 A Resistance, R=17.32 A Inductive reactance,…

Q: 8, Phase angle between E, and E, 1.1514986ms/10 ms x 360° = 41.4539496⁰ 8 Phase angle between E, and…

A: Here we discuss about error in an angle measurement.

Q: An 8-pole alternator runs on 750 rpm and supplied power to a 6 pole induction motor which has a full…

Q: Consider the following system that consists of two sub-systems in parallel. 3 s+2 U(s) Y(s) 1 s+1…

A: For the above given question we need to justify stability, impulse response and controllable…

Q: transmision line

Q: It is desired to compare two 4-bit numbers for equality. If the two numbers are equal, the circuit…

A: The logic circuit can be designed with the help of NOR gate and AND gate. The equal comparator can…

Q: root locus

Q: VDD J. VinM₁ - Vout V₂M₂ For the above circuit, let (W/L)1=(W/L)2=10, unCox-0.2mA/V², VTH=0.5V,…

A: For the above given question we need to calculate the value of DC bias current, transconductance and…

Q: Three conducting wires are connected to a junction. The current flowing into the junction in two…

Q: Q/What are the key analogies between dynamic systems? Support your answer with physical examples and…

Q: B- what are the disadvantages of the auto transformers? C-An auto transformer is used to step-down…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q5) Steady-state condition exist in the circuit shown in Fig.3 at t < 0.The switch is closed at t=0.…

Q: V peak to peak, and has a time of 5 ms between consecutive peak and through, at t = 0 is -3.6 V and…

Q: Find V4 by using Superposition theorem

Q: Using the values of the magnitudes given in the image, the injection efficiency of electrons is D₁…

A: Electron injection process is used for injecting transfer of electron from a excited state to an…

Q: = 12.) (Neamen: Problem 7.22) - Consider a GaAs pn junction at T 300K. The junction capacitance at…

Q: three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance…

A: In this question we will find phase constant , surge impedance for lossless line...

Q: Get the block diagram and transfer function of the following diagram

A: The given circuit of a DC generator is shown below. It is asked to find the transfer function and…

Q: 1. The power transformer that used to steps the voltage down from transmission levels to…

A: For the above given multiple choice questions we need to give the correct answer of the given…

Q: A circuit is shown in Figure 2 below. The diodes are germanium type with forward biased voltage of…

Q: What is the frequency corresponding to a wavelength of 1 meters?

Q: Find the equivalent resistance to the combination shown on the right. α 7.6 Ω 5Ω 22 Ω 9Ω 3 Ω 6Ω 4Ω…

Q: Sketch the transfer characteristic vo versus vi for the limiter circuit shown below. All diodes…

Q: Design a Half adder, Full adder, Half Subtractor and Full Subtractor.

A: The adder and subtractor circuit can be designed by using truth table and the Boolean expression can…

Q: Find the (div D) at the origion if D-e-2 cos y ax-e* sin y ay +6 z az. 21x aby

Q: 4.3 Point charges 30 nC, -20 nC, and 10 nC are located at (-1, 0, 2), (0, 0, 0), and (1, 5, -1),…

Q: 9) A dc voltage of 6V applied to the ends of 1km of a conducting wire of 0.5mm radius results in a…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Question

i need the answer quickly

Two Conducting Plates of Size 15m are inclined
at (450) to each other with gap of wichth 4mm
Seperating as shown in figure below determine
an. approximate tatue of the charge pesplate
if the plates are maintained at potential difference
of 50v assume that the medium between then
has Ev=15
gap of width
4m²
45
1m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A charge of −1 nC is located at the origin in free space. What charge must be located at (2, 0, 0) tocause the ?-component of the electric field to be zero at (3, 1, 1)?
Since the potential of a perfect conducting sphere with a radius of 3.5 cm in empty space is 10 V, calculate the value of the potentials at a distance of 13.3 cm from the center of the sphere as Volts in ke.
A conducting cylinder with a radius of 1 cm and at a potential of 20 V is parallel toa conducting plane which is at zero potential. The plane is 5 cm distant from thecylinder axis. If the conductors are embedded in a perfect dielectric for which ?* =4.5, find:(a) the capacitance per unit length between cylinder and plane;(b) ?# R4S on the cylinder.
A spherical charge of radius 3 cm and a volume charge density given below. How much is the D-field at a distance of 8 cm from the center of the spherical charge and in uC/(m^2) and 3-decimal places? note: PV = 20 mC/m^3
Please write to text format The charge per unit length on the thin rod shown below is ?. What is the electric field at the point P? (Hint: Solve this problem by first considering the electric field dE at P due to a small segment dx of the rod, which contains charge dq = ? dx. Then find the net field by integrating dE over the length of the rod. Use the following as necessary: L, a, ?, and ?0. Enter the magnitude. Assume that ? is positive.) E
Find the electric field (magnitude and direction) at the point P for the following 3-charge configuration, where Q= +1nC and a=2cm. Show detailed work and a free body diagram.
A 20-nC point charge is at the origin in free space. Calculate V1 if pointP1 is located at P1(2, 3,−1) and V = 0 at (6, 5, 4).
Find the work done in moving a point charge Q = -20 μC from the origin to (4, 2, 0)m in the field
An infinite line charge with a liner charge density of λ. The potential difference Vab where points a and b are ra and rb distances away from the line charges respectively, is given by the equation? (Derive Vab)
Coaxial conducting cylinders are located at ? = 0.5 cm and ? = 1.2 cm. The region betweenthe cylinders is filled with a homogeneous perfect dielectric. If the inner cylinder is at 100 V and the outer is at 0V, find(a) the location of the 10 V equipotential surface;(b) the maximum value of electric field ( ????? );(c) the dielectric constant of the medium (??), if the charge per meter length on theinner cylinder is 10 nC/m.
In free space, let Q1 = 10nC be at P1 (0,4,0) and Q2 = 20nC be at P2(0,0,4). Find E at the origin. Where should a 50 nC point charge be located so that E = 0 at the origin?
Using Gauss’ law deduce the expression for the electric field due to a uniformly charged spherical conducting shell of radius R at a point (i) outside and (ii) inside the shell. Plot a graph showing variation of electric field as a function of r > R and r < R (r being the distance from the centre of the shell)