three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance of 0.0118 µF per Km per phase. The line is 500 Km long, and for the purpose of this problem, a lossless line is assumed. the phase constant B is ÷ the line surge impedance is 2c 0 and the wavelength A is #

three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance of 0.0118 µF per Km per phase. The line is 500 Km long, and for the purpose of this problem, a lossless line is assumed. the phase constant B is ÷ the line surge impedance is 2c 0 and the wavelength A is #

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.31P: A 500-kV, 300-km, 6()-Hz, three-phase overhead transmission line, assumed to be lossless, has a...

See similar textbooks

Similar questions

A single-phase overhead transmission line consists of two solid aluminum conductors having a radius of 3 cm with a spacing 3.5 m between centers. (a) Determine the total line inductance in mH/m. (b) Given the operating frequency to be 60 Hz, find the total inductive reactance of the line in /km and in/mi. (c) If the spacing is doubled to 7 m, how does the reactance change?
A three-phase power of 460 MW is transmitted to a substation located 500 km from the source of power. With VS=1. per unit, VR=0.9 per unit, =5000 km, Zc=500, and =36.87, determine a nominal voltage level for the lossless transmission line based on Eq. (5.4.29) of the text. Using this result, find the theoretical three-phase maximum power that can be transferred by the lossless transmission line.
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
1. What is the necessary condition for matching transmission lines? In addition, what is a micro strip line? 2. For a distortion less line α = 0.02dB/m, Z0 (R0) = 60Ω and C = 0.2nF/m. Find the resistance and velocity of wave propagation. [Do not forget the units.] 3. For a finite lossless transmission line with open-circuit termination, sketch Xio vs l. Indicate where the sketch is inductive and capacitive.
. A 70 cm long lossless transmission line with characteristics impedance of 50 Ω operating at 5Mhz is terminated with a load of ?? = (65+j80) Ω. If the velocity is 0.8 times the velocity of light, then calculate (a) The reflection co-efficient, also verify the value using the given smith chart. (b) Compute the input impedance using the transmission line input impedance equation 50 Ω line is terminated with an impedance of ??= (90 – j120) Ω. Design a shortcircuited single stub matching circuit using Smith chart that is provided
A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line if the shunt capacitance is 200 nF/m.
A Three-Phase, 180 KV, 75 Hz Transmission Line consists of 1.2 cm radius conductors spaced at 2.4 meters apart in an equilateral triangular formation. If the Temperature is 40 ºC and Atmospheric Pressure is 76 cm of Hg, calculate the Corona Loss per km of the line. Take m0=0.8
A transmission line has an inductance of 4 mH/loop km and a capacitance of 0.004µF/km. Determine, for a frequency of operation of 1 kHz, the phase delay, the wavelength on the line, and the velocity of propagation (in metres per second) of the
The capacitance per unit length and the inductance per unit length for a lossless transmission line are 0.1 F/m and 20 H/m respectively. What will be the characteristic impedance of the line?
A 500kV,300km,60Hz500kV,300km,60Hz, three-phase overhead transmission line, assumed to be lossless, has a series inductance of 0.97mH/km0.97mH/km per phase and a shunt capacitance of 0.0115mF/km0.0115mF/km per phase. Determine the phase constant ββ, the surge impedance ZcZc, velocity of propagation vv, and the wavelength λλ of the line. a. β=0.001259rad/km,Zc=290.43Ω,v=2.994×105km/s,λ=4990kmβ=0.001259rad/km,Zc=290.43Ω,v=2.994×105km/s,λ=4990km b. β=0.001259rad/km,Zc=290.43Ω,v=2.599×105km/s,λ=4990kmβ=0.001259rad/km,Zc=290.43Ω,v=2.599×105km/s,λ=4990km c. β=0.000629rad/km,Zc=290.43Ω,v=1.533×105km/s,λ=4990kmβ=0.000629rad/km,Zc=290.43Ω,v=1.533×105km/s,λ=4990km d. β=0.001049rad/km,Zc=290.43Ω,v=2.994×105km/s,λ=5998km
The capacitance per unit length and the characteristic impedance of a lossless Transmission line are C and Z0 respectively. Express the velocity of travelling wave on the transmission line in terms of the two given parameters above.
Estimate the corona loss for a 3-phase, 110 kV, 50 Hz, 150-km-long transmission line consisting of three conductors, each of 10 mm diameter and spaced 2.5 m apart in an equilateral triangle formation. The temperature of the air is 30oC and the atmospheric pressure is 750 mm of mercury. Take the irregularity factor as 0.85. Ionisation of the air may be assumed to take place at a max voltage gradient of 30 kV/cm.