Two kg of helium operate on a three-process cycle where the processes are: constant volume (1-2); constant pressure (2-3); and constant temperature (3-1). Given that P1=100 kPa, T1=(300+x) K and V1N2=5, determine a. The pressure, temperature, and volume around the cycle b. The work for each process c. The heat added

Two kg of helium operate on a three-process cycle where the processes are: constant volume (1-2); constant pressure (2-3); and constant temperature (3-1). Given that P1=100 kPa, T1=(300+x) K and V1N2=5, determine a. The pressure, temperature, and volume around the cycle b. The work for each process c. The heat added

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter45: Domestic Refrigerators And Freezers

Section: Chapter Questions

Problem 2RQ: The operating condition for the single compressor in a household refrigerator is the lowest box...

See similar textbooks

Similar questions

When the outside ambient air temperature is 90F, the temperature of the condensing refrigerant in a standard- efficiency unit should be approximately A. 120F. B. 130F. C. 140F. D. 150F.
The above refrigeration system uses R-12 as the refrigerant, determine: 1. Enthalpies at each point of the cycle 2. Total mass of refrigerant that circulates the system in kg/s 3. Total refrigerating capacity in TOR 4. Total compressor power in kW 5. Heat rejected in kW 6. Coefficient of Performance 7. Draw the P-h Diagram Note: Show your SYSTEM BALANCING.
In a refrigeration cycle, the refrigerant gains heat in the evaporator and in thesuction line. In a certain refrigeration system, R-134a gains 67.8 Britishthermal units per pound (Btu/lb) in the evaporator. It then gains 2.5 Btu/lb inthe suction line. Find in Btu/lb the total heat gained by the R-134a.
Problem # 2: In a steam thermal plant, it operates with a condenser outlet temperature of 180 ° F, and a boiler outlet temperature of 1000 ° F. If the pressure at the pump outlet is 300 psia. If the efficiencies of the turbine and pump are 85%. Determine: a.) The real work of the turbine, in Btu / Ibm. b.) The actual work of the pump, in Btu / Ibm. c.) The thermal efficiency of the real cycle. d.) The thermal efficiencies of the ideal cycle and Carnot. e.) Diagram T vs s, with all possible values and indicating the real and ideal cycles.
Q1) How to steam flow control in thermal power plants?
The following data for the R-12 refrigeration system as shown are as follows: Evaporator 1 0 OC 30 TOR Evaporator 2 -10OC 20 TOR Evaporator 3 -20OC 10 TOR Condenser 20OC Assume simple saturation and isentropic compression and determine the following: a) Draw the h-s diagram b) The refrigerant flow in each evaporator c) Total work of compression, WC in kW d) Heat rejected in the condenser, QR in kj/min e) Coefficient of performance
Draw schematic diagrams of a gas turbine system used for i. generating electricity with irreversible (actual) single stage compression, ii. two stages of irreversible expansion with reheat, and iii. a regenerator. Specify the relevant corner points of the process.
Please help with all questions, thank you so much in advance!! Determine (1) The power input to the compressor (2) The rate of heat removal from the refrigerated space (3) The pressure drop and in the line between the evaporator and the compressor (4) The rate in the line between the evaporator and the compressor (5) and sketch the T-s diagram for this cycle with corresponding saturation lines
A reversible refrigerator operates using a Carnot refrigeration cycle. It operates usingr-134a between 140 and 400 kPa. The refrigerant exits the compressor (and enters the condenser) assaturated vapor. It also leaves the condenser as saturated liquid.a. Sketch the P-v and T-s diagram of this cycle. Define the coordinate properties of each state oneach graph.b. Evaluate the specific heat and specific work properties of each (in kJ/kg). Indicate the sense.c. Evaluate the coefficient of performance using the specific heats and works from the previousitem. Did it match with the COPR obtained if you used the operating temperatures? Solve for states first. Then, show the solution to each of the above required in order.
Hi I need help with parts of a thermo practice problem 2 kg of air in a piston cylinder initially at P1=101 kPa, T1= 300 K undergoes a cycle made up of three processes: 1-2 Isothermal compression until the volume is (1/15) of its original value.2-3 Constant Pressure heating3-1 Isentropic Expansion back to the initial state Assume air is an ideal gas with constant specific heats with the following values: Cpo=1.027kJ/kgK; Cvo= 0.740 kJ/kgK; R=0.287 kJ/kgK; ɣ=1.388 Fill in the processes table below and show all work.
A steam power plant operates in cycle as shown.The rating of the power cycle is 100,000 kW. Determine the m, Qh, Qc and n of the plant.
A Carnot engine using air receives heat at 300°C and rejects heat at 60°C. The pressure and volume at the start of the heat addition process are 5 MPaa and 0.9 L respectively, at the end of the process the pressure drops by 45%. Determine: • Work net • Heat added • Heat rejected • Thermal Efficiency