Two large plates are maintained at a temperature of 910 K and 500 K respectively. Each plate has area of 100cm^2. Compare the net heat exchange between the plates for the following cases. a. Both plates are black b. Plates have an emissivity of 0.5

Two large plates are maintained at a temperature of 910 K and 500 K respectively. Each plate has area of 100cm^2. Compare the net heat exchange between the plates for the following cases. a. Both plates are black b. Plates have an emissivity of 0.5

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter11: Heat Transfer By Radiation

Section: Chapter Questions

Problem 11.38P

See similar textbooks

Related questions

Q: A triangular duct whose surfaces are all black has a length of L=0.75 m. By considering the details…

Q: An object with a surface area of 45.0 cm2 and an emissivity of 0.9 is in a vacuum surrounded by an…

A: Given Area, A = 45 cm2 Emissivity = 0.9 Power, Q = 300 W…

Q: A plate-type solar energy collectorr with an absorbing surface covered by a glass is to receive an…

Q: The amount of energy emitted by a unit area of a black body at 300°C is approximately, a. 459 W/m?…

A: Temperature (T) = 300°C = 573 K

Q: A black hole is a blackbody if ever there was one, so it should emit blackbody radiation, called…

A: Einstein relation between photon energy and wavelength is given by ε=hcλ Here, h is plank's…

Q: 1 ohmic resistor can convert all of the 50 W of electricity into heat. Can the same amount of heat…

A: It is required to check 1 ohmic resistor can convert all of the 50 W of electricity into heat. Can…

Q: 1000 W/m of radiant energy is incident upon a surface, out of which 300 W/m² is absorbed, 100 W/m is…

Q: For approximate calculations, the sun may be considered a black body, emitting radiation with…

Q: The inverse square law of heat states that intensity of radiation is not inversely proportional to…

A: True

Q: The total emissive power of a surface is 500 W/(m ^ 2) at a temperature T1, and 1200 W/(m ^ 2) at a…

A: Givenemissive power E1=500 W/m2 at T1emissive power E2=1200 W/m2 at T2

Q: Calculate the amount of radiation emitted for a unit surface (1 m2 ) forthe following situations:…

A: Write the expression to calculate the amount of radiation emitted by a surface. Q=σεAT4 Here, the…

Q: stimate the increase in heat transferred by radiation of a black body at 1500 °F relative to one at…

A: Heat transfer by a black body due to radiation,Q=σAT4Where,σ=steffan's boltzman…

Q: A heat exchanger radiates energy at a rate of 2500 ?? / ℎ for every meter square of its surface.…

A: Given: Heat transfer is 2500 kJ/h-m2. Time is 5 hour.

Q: Consider a small surface of area A = 0.8 × 104m?, which emits diffusely with a total, hemispherical…

A: radiative heat exchange is found using the formula in terms of both areas, solid angle and emissive…

Q: Ex2. Two large parallel plates are exchanging radiation. One plate has a temperature of 1000 K and…

Q: A black body absorbs radiant energy at the rate of 5 kW/m2 . Calculate the temperature at which…

Q: Determine the rate of radiant heat emission in watts per square meter from a blackbody at (a) 150°C,…

Q: The outer surface of a charcoal burner has a temperature of 300 C. The fan, near the charcoal…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A spherical particle of density o= 5.00 and 2.00 mm radius is located at the same distance from the…

A: The ratio of the force exerted by the solar radiation to the force of gravity exerted on the…

Q: Two long parallel plates of same emissivity 0.5 are maintained at different temperatures and have…

A: Given: The emissivity of two plates, ε1 = 0.5 The emissivity of radiation shield, ε2 = 0.25

Q: Orange plants were placed in garden overnight in sky at temperature of 260 K. The temperature of air…

Q: Steam enters a turbine with a pressure 4,229 kPa and h=3,263.08 kJ/kg, with a flow of 7.397 kg/s…

Q: A surface gains 500 W/m2 heat at an equilibrium temperature of 30 °C and it is subjected to a…

A: Given: Heat flux (q)=500W/m2Equilibrium surface temperature (Ts)=30°C or (273+30=303K)Temperature of…

Q: 1. Two large plates are maintained at a temperature of 900 K and 500 K respectively. Each plate has…

Q: ROBLEM 3: The configuration of a furnace can be approximated as an equilateral triangular duct which…

A: Data given - T1 = 900 K e1 = 0.8 T2 = 400 K e2 = 0.8 Q= ?

Q: 1. Two large plates are maintained at a temperature of 900 K and 500 K respectively. Each plate has…

A: Given, T1=900 KT2=500 KA=6 m2 Stephan-Boltzmann constant, σ=5.67×10-8 W/m2.K

Q: A 50cm by 100 cm stainless steel plate with emissivity of 0.85 is maintained at 500°C. determine the…

Q: What is the actual wavelength and velocity of a near-infrared beam 1l = 0.901 mm2 of light modulated…

A: Given:Wavelength ofinfrared beam λ=0.901 μmmDry bulb temperature,T=26°CRelative…

Q: Q1. Alarge room at 30 °C surrounds two perpendicular plates with a common edge that measure 60 by 60…

Q: You use an IR-thermometer that uses an assumed emissivity value of 0.95. What temperature will it…

Q: 2. (a) Consider a 25-cm-diameter spherical ball at 700 K suspended in air and assume the…

A: Note - As per our guidelines we are supposed to answeronly one question. Kindly repost other…

Q: Two parallel square plates [1.22 m by 1.22 m], 0.81 m apart, have emissivities of 0.5 (560 ⁰C) and…

A: Calculated heat exchange between two plates.

Q: 1. A window is 2.1 m high and 4.2 m long. A horizontal diffuse reflector is placed in front of the…

A: Given: n=p=2.1 m m=4.2 m nm=pm=2.14.2=.5 ArAc=pmnm=2.1*4.22.1*4.2=1 F(r-c)=.24 horizontal so β=90 o…

Q: Determine the heat transfer that occurs by radiation between two surfaces that are co-axial and…

Q: Two large plates are maintained at a temperature of 910 K and 500 K respectively. Each plate has…

Q: At what rate does the solar wind carry kinetic energy away from the Sun? Give your result first in…

A: Solar wind energy is a flow of charge particles which possess energy and flow away from the sun.…

Q: A triangular duct whose surfaces are all black has a length of L=0.69 m. By considering the details…

Q: Q1. Evaluate the intensity of solar radiation for 15 March 2019, given solar constant (ISC) = 1800…

A: Solar radiation I that reaches the earht surface its givenI=Isc1+0.033 cos360.n360.25where n is…

Q: Determine the following at 3 P.M. solar time at 30°N latitude. i) Altitude and solar azimuth angle…

Q: Q11. 40% of incident radiant energy on the surface of a thermally transparent body is reflected…

A: To find: The emissivity of surface. Given: The transmissivity of the body is τ=0.15. The…

Q: A cordless microphone emits sound with an average power output of 73.9 W. Calculate the distance (in…

A: Solution:

Q: [1] Determine the view factor F12 between the rectangular surfaces: m 1 m 1 m m 3 m 1 m 1 m 3 m 1'm…

Q: should you turn your thermostat down a few degrees, turn it off altogether, o

A: If you wish to save fuel and you're going to leave your warm house for a half-hour or so on a very…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

1.28 The sun has a radius of and approximates a blackbody with a surface temperature of about 5800 K. Calculate the total rate of radiation from the sun and the emitted radiation flux per square meter of surface area.
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 816C and 260C, respectively. Determine the rate of heat transfer by radiation between the plates in W/m2 and the radiative heat transfer coefficient in W/m2K.
11.31 A large slab of steel 0.1 m thick contains a 0.1 -m-di- ameter circular hole whose axis is normal to the surface. Considering the sides of the hole to be black, specify the rate of radiative heat loss from the hole. The plate is at 811 K, and the surroundings are at 300 K.
Determine the rate of radiant heat emission in watts per square meter from a blackbody at (a) 15C, (b) 600C, and (c) 5700C.
Determine the total average hemispherical emissivity and the emissive power of a surface that has a spectral hemispherical emissivity of 0.8 at wavelengths less than 1.5m, 0.6 at wavelengths from 1.5to2.5m, and 0.4 at wavelengths longer than 2.5m. The surface temperature is 1111 K.
11.68 Two infinitely large, black, plane surfaces are 0.3 m apart, and the space between them is filled by an isothermal gas mixture at 811 K and atmospheric pressure. The gas mixture consists of by volume. If one of the surfaces is maintained at 278 K and the other at 1390 K, calculate (a) the effective emissivity of the gas at its temperature, (b) the effective absorptivity of the gas to radiation from the 1390 K surface, (c) the effective absorptivity of the gas to radiation from the 278 K surface, and (d) the net rate of heat transfer to the gas per square meter of surface area.
Three thin sheets of polished aluminum are placed parallel to each other so that the distance between them is very small compared to the size of the sheets. If one of the outer sheets is at 280C and the other outer sheet is at 60C, calculate the temperature of the intermediate sheet and the net rate of heat flow by radiation. Convection can be ignored.