Two long straight aluminum wires, each of diameter 0.40 mm, carry the same current but in opposite directions. They are suspended by 1.0-m-long strings as shown in the figure. If the suspension strings make an angle of 4.0° with the vertical and are hanging freely, what is the current in the wires? (density of aluminum = 2.7 g/cm³, g=9.80 m/s?) 80 The answer is integer. 12 1.0 m

Two long straight aluminum wires, each of diameter 0.40 mm, carry the same current but in opposite directions. They are suspended by 1.0-m-long strings as shown in the figure. If the suspension strings make an angle of 4.0° with the vertical and are hanging freely, what is the current in the wires? (density of aluminum = 2.7 g/cm³, g=9.80 m/s?) 80 The answer is integer. 12 1.0 m

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.27P

See similar textbooks

Similar questions

The figure is a cross section through three long wires with linear mass density 58.0 g/m. They each carry equal currents in the directions shown. The lower two wires are 4.0 cm apart and are attached to a table. What current I will allow the upper wire to "float" so as to form an equilateral triangle with the lower wires?
A thin insulator rod of mass m and length L=40 cm, as shown. thresholdon the surface of the plane and in an outer bend from the rails placed on the edges. It slides frictionlessly with a constant velocity of V=0,8 m/s. Itrails at the lower edge of the inclined plane. to each other with a rail parallel to the bar connected so that the bars and rails are closed, a rectangular frame they form. Rail plane is Ɵ=50° angle with horizontal plane (xz plane) is doing. Before the rod begins to weld, it must be tilted above the inclined plane. It stood above the lower edge of the plane at a distance of S=4m. Inclined plane and the rod shows a magnetic field of uniform B=0,5i+0,8j+0,20k(T) is under the influence. When the bar starts to slide, at t=3s moments the bar, the edge magnetic passing through the frame surface formed by the rails and the rails at the bottom edgewhat is flux?
Two very long parallel conducting wires carry currents I1 = 1 A, I2 = 2 A in opposite directions. They hang horizontally from pylons by pairs of insulating cables, each of length a = 1 m, and are a distance d << a apart. The wires have mass m per unit length and the cables make angle theta to the vertical. Find theta. Show solving
9-- A loop of wire in the shape of a rectangle of width b=5 cm and length L and a long, straight wire carrying a current I lie on a tabletop as shown in Figure 1. Suppose the current is changing with time according to I =10 e-wt A, where w is constants. Determine the direction and magnitude of the emf that is induced in the loop in 2 sec, if w= 0.2 s-1, a = 10 mm, and L = 10cm. Show step by step solution.
In free space, q1= 3nC and q2= -4nC are located in the form of load axes, as well as at the base y=1 and y=6 on the y-new. Accordingly, how many volts is the electric potential value at the origin?
Coaxial cables are often used to connect electrical devices, such as your video system, and in receiving signals in television cable systems. Model a long coaxial cable as a thin, cylindrical conducting shell of radius b concentric with a solid cylinder of radius a as shown. The conductors carry the same current i in opposite directions. Calculate the inductance L of a length ℓ of this cable.
Two long straight current-carrying wires are lined up parallel to one another in vacuum at a distancedCurrents of I1 and flow I2 through the wires, both in the same direction generating the field of B Delta f at a midpoint between themWrite down an expression for BM in terms of the currents running in each of the wires Assume vacuum permeability u= 1
An L-shaped conducting wire, in the xz-plane, measuring 1.0 m by 1.0m for each leg, carries a 4 A constant current, in the directions shown in the Figure. The origin coincides with the corner of the L-shape. Calculate the B (with arrow on top) field at a point on the y-axis 0.5m from the origin.
Two very large (50m x 50m) and 10mm thick plastic discs have the volume charge density ρ1 = +5μC/m3 for the left disc and ρ2 = +3μC/m3 for the right disc in the figure. The discs are placed in parallel. The adjacent surfaces of the discs are 5mm apart. Use Gauss law and superposition to determine the size and direction of the electric field at the following points, far from the outer edges of these discs. a) Dot A, 5mm from the left side of the left disc b) Dot B, 2mm from the left side of the right disc c) Point C, in the middle of the right disc.
An infinitely long coaxial cable has an inner and an outer conductor of radii "a" and "b"respectively. If the space between the conductors is filled with two different dielectrics ofdielectric costants ɛ1 and ɛ2 as shwon below, find the capacitance per unit length of this coaxialcable
Two 1.20 m non-conductive wires form a right angle. A segment has +2.50 µC of charge, distributed evenly along its length; while the other segment has -2.50 µC of charge, distributed uniformly along its length, as illustrated in the ﬁgure. Find the magnitude and direction of the electric field produced by these wires at point P, which is 60.0 cm from each wire.
Given a coaxial capacitor with the length of L which has two coaxial conductors with radius a=1 cm and b= 4 cm for inner and outer conductor, respectively. The inner conductor carries the total charge of –Q C whilst the outer carries +Q C. If the length of the coaxial, L = 100m and the coaxial is filled with the lossy Teflon (εr = 2.2 and σ = 4 Sm-1), determine: i. Potential Different between r = 3cm and r = 6cm ii. Energy in region a<r<b Note: In dielectric material, permittivity ε=εoεr and D=εE