Answered: Two point charges, q1 = q and 92 = 3q,…

Two point charges, q1 = q and 92 = 3q, are 25 cm apart. They repel each other with a force of 2.7 N. What is the value of q? a. 2.5 μC. b. 3.5 MC. c. 4.5 MC.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter10: Using Wire Tables And Determining Conductor Sizes

Section: Chapter Questions

Problem 10PP: Determine the ohms-per-mil-foot of an aluminum conductor located in an area with a temperature of...

See similar textbooks

Related questions

Q: what is kvl and kcl in circuit theory ?

A: The electrical circuit consists of various active and passive elements and The circuit calculations…

Q: 1. Which of the following is not an electronic device? a) A mobile b) A computer c) A magnifying…

A: mobile , keyboard and computer are design by semiconductor devices like BJT ,MOSFET, Amplifier .

Q: Reduce the block diagram below into single transfer function.

A: Closed-Loop System (CLS)-A system having the input of the system depends on the system output. It…

Q: A uniform cylindrical shell has inner radius 6.39 meters, outer radius 19.31 meters, and length…

Q: A safe has 5 locks: V, W, X, Y and Z, all of which must be unlocked for the safe to open. The keys…

A: The following table indicates the executives and the locks they can open. v w x y z A 1 1…

Q: Explain why it is important that the stimulus signals in a testbench be synchronized to the inactive…

A: The stimulus signals in a testbench to be synchronized to the inactive edge of the clock of the…

Q: An EM wave progating in a certain medium is described by E = 31 sin(3922.8 x 10°t - 9.2x) az V/m…

A: Given: EM wave E=31sin3922.8×106t-9.2xaz V/m

Q: 9. Which of the following equation represents mass semiconductors in electronic circuits? action law…

A: The correct option along with the explanation is provided in the following section.

Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…

A: We need to select the correct option

Q: A capacitor in an LC oscillator has a maximum potential difference of 15V and a maximum energy of…

Q: Please don't copy i need answer for my assignments. A 3-phase bridge inverter is operated from…

Q: 4 a) Differentiate clearly between “intrinsic conduction” and “extrinsic conduction” in…

A: 4) (a) S.No. Intrinsic Conduction Extrinsic Conduction 1. Having low conductivity Having higher…

Q: Determine VP(sec), VP (out), PIV, Vp(rect), Vr(p-p), Vòc and the ripple factor, r 1 : 1 D₁ * 120…

A: Rectifiers are crucial components of power supply circuits because they convert an AC input voltage…

Q: Prove that the exponential signal shown in Fig. is non-periodic

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A: Given data, The block diagram is

Q: VRY = 220 cis 0°, VYB = 220 cis -120° and VBR = 220 cis -240°. IR = 10 cis 0°. The load is balanced…

Q: What is the minimum area (in square meters) of the top surface an ice slab 0.445 m thick floating on…

A: A surface that reduces its area locally is called a minimum surface. This is the same as having a…

Q: Your team are been assigned to develop a portable electrical car jack as shown in Figure 3. The…

A: In this, The portable electric car jar has four subsystems Electric wrench Electric jack electric…

Q: 10. A capacitor is connected across a 120 V, 60 Hz supply. An ammeter indicates 5 A and a wattmeter…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: 12-10. Determine the SWR for a 50-02 transmission line that is terminated in a load resistan ZL = 75…

Q: m(t)=Amsen(comt) Figura 1 MODULADOR AM (DSB-LC) Vsalida(t) vc(t)=Acsen(wet)

Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…

A: The correct option, along with the explanation, is provided in the following section.

Q: If the number of turns in the coil is increased, the induced electromotive force in the coil will A.…

A: According to faradays 1st law of electromagnetic induction, whenever a conductor cuts the magnetic…

Q: Using TDR, a transmission-line impairment

A: Velocity factor- When electromagnetic signal passes through any medium then the speed of…

Q: 4. This is a phasor problem. Start by writing a current divider formula for I. Simplify and find…

Q: When Inverters are used as the input to a NAND gate, the circuit performs what logic function? When…

A: NAND and NOR gates are the universal gates, using the NAND and NOR any gate can be implemented. Let…

Q: Determine Vout in V. +10 V Vin OV -10 V 3 V Vout when Vin = +10V = Vout when Vin = -10V = 1.0 ΚΩ +₁₁…

Q: An energy meter has a meter constant of 600rev/kwh when correctly adjusted. If the lag adjustment is…

Q: Determine the output voltage and current

Q: 3. A relay coil has a resistance of 500 ohms and inductance of 10mH. The triggering current of relay…

A: Solution is attached with this notes.Thank you.

Q: Find to in the network shown. 12 Τ Select one: O a. 4 mA ΙΚΩ O b. 3 mA Oc. None of them Od. 6 MA O e…

A: We need to find out the current for given circuit

Q: Briefly explain what you mean by discrete system and continuous system.

A: Continuous system: Continuous systems seem to be ones in which output & input signal are…

Q: A coil of resistance 20 Q and inductance 10 mH is in series with a capacitance and is supplied with…

A: Given a coil with a series RLC connection having, Resistance, R=20 Ω Inductance, L = 10 mH At the…

Q: 3. In an ideal op-amp, which is not true?

A: The correct option along with the explanation is provided in the following section.

Q: A 200kVA transformer with impedance of 5% and the power factor of the load is 85%. The primary…

A: Given data, Rating of transformer S = 2000 KVA Percent impedance %Z=5 % Power factor cosϕ=85 % =…

Q: Explain the difference of technical translation and literary translation.

A: Given & to find: Explain the difference between technical translation and literary translation.

Q: A 10 V, 1 kHz ac source is connected to a parallel circuit consisting of a 470 2 resistor and a…

A: The required parameters can be calculated by using the impedance and input current of the circuit.

Q: For a 16 ary PSK signals having bit rate equal to 250 kbps the BW efficiency will be?

A: Given, A 16 ary PSK signals having bit rate equal to 250 kbps. M = 16

Q: 1. The circuit in the figure is a half-wave rectifier whose input is sinusoid vin(t)=sin wt and its…

Q: 3. In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance…

A: The correct option along with the explanation is provided in the following section.

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: 8. Derive the Characteristic Table and complete the timing diagram of the following gated SR latch…

A: SR Latch : R S Q Remark 0 0 NC No Change 0 1 1 1 0 0 1 1 - Racing When both input…

Q: A majority logic function is a Boolean function that is equal to 1 if the majority of the variables…

A: The truth table can be obtained by counting the number of one's in the input if the number of one's…

Q: 1. Nodal Analyris 1 JAĴ 10 um IOLO (c Ej5 4 m | 10L 30" GE j8 3 REQUIRED: IA, IB, IC, ID 9 LE BE LET…

Q: Difference between circuit breaker and fuse.

A: Fuse: In the event that an electrical circuit's current has become too high, a fuse acts as an…

Q: Determine the voltage across C, VC in V, and Vout. +1 V Vin 0- -1 V C DE X R Vout

A: In the question following figure is given we have to determine Voltage across capacitor Vc and…

Q: DIFFERENTIAL EQUATION with POWER SERIES: y" - xy = 0

A: An accumulation of words of the general form aₙ(x-a)ⁿ is a power series. Power series are functions…

Q: For the below circuit, find the power dissipated in the 62 resistor 1.6 Ω 10 A Select one: O a.…

A: We need to find out power dissipation in the given circuit

Q: Disadvantages of fuse in electric circuit.

A: What is Fuse? It is the economical protecting equipment within a circuit against circuit overloads…

Q: Explain how a half adder and a full adder differ in their functionality.

A: Adder: An adder is a digital circuit that adds two numbers together. In computers, the arithmetic…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Two point charges, q₁ = q and 92
q2
3q, are
25 cm apart. They repel each other with a
force of 2.7 N. What is the value of q?
a. 2.5 μC.
b. 3.5 MC.
c. 4.5 μC.
d. 5.5 μC.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Determine the value of IR if E1 to 0.5v. ( Explain the reason for your answer in detail )
Calculate the value of V0 Determine the value of IR if E1 to 0.5v. ( Explain the reason for your answer in detail )
A charged particle q is shot towards another charged particle Q which is fixed, with a speed v. It approaches Q upto a closest distance r and then returns. If q was given the speed 2v, then what would be the closest distance of approach.
1) A source charge gives rise to an electric field. At one particular point in space, the magnitude of the electric field due to this source charge is 1500 N/C. A +12 nC test charge is placed at this point. How will the magnitude of the electric field change if the +12 nC test charge is replaced by a +24 nC test charge?
17 - Two charged particles are located on the x-axis. The charge + Q is at the point x = -a and the other unknown load is at the point x = + 2a. If the magnitude of the electric field created by these two charges at the origin is 2kQ / a>, what is the unknown charge? A) + QB) -4QC) -2QD) + 3QE) + 5Q
A Square with sides 2 m each has a charge of 40 uC at each of its four corners. Determine the electric field at a point 5 m above the center of the square.
Calculate the total electric field at point A due to the two point charges, Q1 = -40 µC and Q2 = 25 µC. From your results in rectangular format.
Two small balls, each with a mass of 10 g, are suspended from the same point by two threads each 1 m long. If when charging the balls with the same electric charge, the threads separate at an angle of 10º, determine the value of the electric charge.
The distance between the plates of a parallel capacitor with air between them is 0.1 m.The surface area of each of the boards is 0.5 m². If a potential difference of 20 V is applied to the plates, what is the surface charge density in C/m²? (Eo=8.85x10-12 C²/Nm²)
A particle moves along a straight path with velocity v(t) = (4 - 4t) m/s at a time s. What is the total distance traveled by the particle from 0 sec to 4 secs
Determine the electric field intensity in free space if D=30ar c/m2.