Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and directionof the third force so that the resultant of the three forces is vertically downward with a magnitude of 1310 lb.1140 lbAnswers:F=0 =40°i 1461DE60.2O26°O440 lblb Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and directionof the third force so that the resultant of the three forces is vertically downward with a magnitude of 1310 lb.1140 lbAnswers:F=0 =40°i 1461DE60.2O26°O440 lblb

Answered: Image /qna-images/answer/f3bcd7e2-4f1a-4f97-987a-a6d980aa9daf.jpg

Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and direction of the third force so that the resultant of the three forces is vertically downward with a magnitude of 1310 lb. 1140 lb Answers: F= 40° i 1461 9= i 60.2 8 26° ! O 440 lb lb

Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and direction of the third force so that the resultant of the three forces is vertically downward with a magnitude of 1310 lb. 1140 lb Answers: F= 40° i 1461 9= i 60.2 8 26° ! O 440 lb lb

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 38P: A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the...

See similar textbooks

Similar questions

Is surface tension due to cohesive or adhesive forces, or both?
An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the wire be before the stress at its upper end reaches the proportionality limit, which is 8.0107N/m2 ?
a 1,460-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1,584-N crate hangs from the far end of the beam. Find the magnitude of the tension in the wire. The angle theta is 25 degrees and the angle phi is 54 degrees. The length of the beam is L.
A person whose mass is m=77.0 kg steps on a mechanical bathroom scale placed on an inclined plane that makes the angle α=12.3∘ with the horizontal. What is the reading on the scale?
A uniform plank of length 2.00 m and mass 26.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 710–N person is d = 0.500 m from the left end. Answer the 3 boxes below:
A uniform drawbridge must be held at a 38o angle above the horizontal to allow ships to pass underneath. The drawbridge weights 55000 N and is 15.0 m long. A cable is connected 3.5 m from the hinge where the bridge pivots (measured along the bridge) and pulls horizontally on the bridge to hold it in place. What is the tension in the cable? Find the magnitude and direction of the force the hinge exerts on the bridge. If the cable suddenly breaks, what is the magnitude of the angular acceleration of the drawbridge just after the cable breaks? What is the angular speed of the drawbridge as it becomes horizontal? What is the velocity of the drawbridge, just before it “hits” (i.e. goes horizontal)?
A bridge is 36.0 m. long and it weighs 2.50 x 10^5N. a truck weighing 5.20 x 10^4 N is 10m. from one end of the bridge .calculate the force that must be exerted by each pier to support these weighs
The safe load, L, of a wooden beam of width w, height h, and length l, supported at both ends, varies directly as the product of the width and the square of the height, and inversely as the length. A wooden beam 44inches wide, 99inches high, and 168168inches long can hold a load of 59305930pounds. What load would a beam 3inches wide, 7inches high, and 120inches long, of the same material, support? Round your answer to the nearest integer if necessary.
A 1,175 N dowel is held in place by a light cord at an angle ? = 31.0° to the horizontal as shown in the figure. The dowel is attached to a pivot at the bottom, and a mass of weight w = 2,100 N hangs from its top. The dowel makes an angle of ? = 59.0° with the horizontal. Assume the dowel is uniform. Find the tension in the supporting cord (in kN). kN (b) Find the components of the reaction force (in kN) exerted by the floor on the dowel. horizontal component:magnitude kNdirection vertical component:magnitude kNdirection
The horizontal beam in Fig. 1 weighs 150 N, and its center of gravity is at its center. Find (a) the tension in the cable and (b) the horizontal and vertical components of the force exerted on the beam at the wall.
A 185 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the horizontal with a tension ?1, and the other rope pulls up and to the left ?2=42.5∘ above the horizontal with a tension ?2, as shown in the figure. Find the tensions ?1 and ?2.
In the figure, one end of a uniform beam of weight 240 N is hinged to a wall; the other end is supported by a wire that makes angles θ = 26° with both wall and beam. Find (a) the tension in the wire and the (b) horizontal and (c) vertical components of the force of the hinge on the beam.