Two solid cylindrical rods (1) and (2) are joined together at flange Band loaded, as shown. The diameter of rod (1) is d; - 1.53 in. and the diameter of rod (2) is de- 3.19 in. Determine the normal stresses in rods (1) and (2). Assume P- 15 kips and Q- 28 kips. Use positive for tensile stress and negative for compressive stress. 2) Answers: ksi. ksi.

Two solid cylindrical rods (1) and (2) are joined together at flange Band loaded, as shown. The diameter of rod (1) is d; - 1.53 in. and the diameter of rod (2) is de- 3.19 in. Determine the normal stresses in rods (1) and (2). Assume P- 15 kips and Q- 28 kips. Use positive for tensile stress and negative for compressive stress. 2) Answers: ksi. ksi.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 74AP: Two rods, one made of copper and the other of steel, have the same dimensions. If the copper rod...

See similar textbooks

Similar questions

A 100-N weight is attached to a free end of a metallic wire that hangs from the ceiling. When a second 100-N weight is added to the wire, it stretches 3.0 mm. The diameter and the length of the wire are 1.0 mm and2.0 m, respectively. What is Young’s modulus of the metal used to manufacture the wire?
Can Young’s modulus have a negative value? What about the bulk modulus?
The bulk modulus of a material is 1.01011N/m2 . What fractional change in volume does a piece of this material undergo when it is subjected to a bulk stress increase of 107N/m2 ? Assume that the force is applied uniformly over the surface.
Check Your Understanding A 2.0-m-long wire stretches 1.0 mm when subjected to a load. What is the tensile strain in the wire?
Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m long and has cross-sectional area 9.1mm2 . If a 10,000N tensile force is applied at each end of the combination, find: (a) stress in each rod; (b) strain in each rod; and, (c) elongation of each rod.
Alarge uniform cylindrical steel rod of density =7.8g/cm3 is 2.0 m long and has a diameter of 5.0 cm. the rod is fastened to a concrete floor with its long axis vertical.what is the normal stress in the rod at the cross-section located at (a)1.0 mfrom its lower end?(b)1.5 m from the lower end?
Check Your Understanding Find the compressive stress and strain at the base of Nelson’s column.
Discuss how you might measure the bulk modulus of a liquid.
Two rods, one made of copper and the other of steel, have the same dimensions. If the copper rod stretches by 0.15mm under some stress, how much does the steel rod stretch under the same stress?
Can compress stress be applied to a rubber band?
A copper wire is 1.0 m long and it diameter is 1.0 mm. if the wire hangs vertically how much weight must be added to its free end in order to stretch it 3.0mm?
To stretch a relaxed biceps muscle 2.5 cm requires a force of 25N. Find the Young’s modulus for the muscle tissue, assuming it to bea uniform cylinder of length 0.24 m and cross-sectional area 47 cm2