Two VERY LONG wires are placed along parallel lines as shown below in the picture. The wire ON THE LEFT (at X1= 0, Z1 0) has a current going in the direction shown of value, I1 = 4.00 A The current on the RIGHT (at X2= d, Z2-0) has a current going in the direction shown of value, I2 6.00 A. The point "P" is at the location (x%3D6.00cm, z-10.4cm) Wire 1 Wire 2 a) The direction of current flow for wire1 and wire 2 is given by, (1) +5,-i () -7,+i (iii) +k, -R (iv) -k.+k

Two VERY LONG wires are placed along parallel lines as shown below in the picture. The wire ON THE LEFT (at X1= 0, Z1 0) has a current going in the direction shown of value, I1 = 4.00 A The current on the RIGHT (at X2= d, Z2-0) has a current going in the direction shown of value, I2 6.00 A. The point "P" is at the location (x%3D6.00cm, z-10.4cm) Wire 1 Wire 2 a) The direction of current flow for wire1 and wire 2 is given by, (1) +5,-i () -7,+i (iii) +k, -R (iv) -k.+k

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter31: Gauss’s Law For Magnetism And Ampère’s Law

Section: Chapter Questions

Problem 68PQ

See similar textbooks

Similar questions

(a) A 200-turn circular loop of radius 50.0 cm is vertical, with its axis on an east-west line. A current of 100 A circulates clockwise in the loop when viewed from the east. The Earth’s field here is due north, parallel to theground, with a strength of 3.00 X 10-5 T . What are the direction and magnitude of the torque on the loop? (b) Does this device have any practical applications as a motor?
a) What rate must the magnitude of B change to induce a 6A current in the loop? b) What ar ethe magnitude and direction of the current around the loop at the moment t=3s?
(a) A 200-turn circular loop of radius 50.0 cm is vertical, with its axis on an east-west line. A current of 100 A circulates clockwise in the loop when viewed from the east. Earth’s field here is due north, parallel to the ground,with a strength of 3.0 × 10−5 T. What are the direction and magnitude of the torque on the loop? (b) Does this device have any practical applications as a motor?
A very long coaxial cylindrical cable is composed of an inner solid cylinder of radius R1 and an outer hollow cylinder of radius R2,{The space between inner and outer cylinders is empty}. An electrical current I runs through the inner cylindrical wire and returns through the outer cylindrical wire. (a) Write down the magnetic energy density function for both the inner and outer regions of the cable. (b) What is the energy per unit length L, for all regions (Both for inner and outer regions)? I did ask the same question last time, but I think the tutor was confused since the radius of the inner cylinder is R1, outer is R2. It's not R1 = 1R, R2 = 2R. Thank you
a.) A wire 4 m long has a mass of 224 g. The wire is connected to an emf. What is the minimum current in the wire that would allow it to levitate above the ground in a magnetic field of magnitude0.4 T? Round your answer to 2 decimal places b.) Per previous question, what direction must the current flow?
A small airplane with a wingspan of 14.0 m is flying due north at a speed of 70.0 m/s over a region where the vertical component of the Earth’s magnetic field is 1.20 μT downward. (a) What potential difference is developed between the airplane’s wingtips? (b) Which wingtip is at higher potential? (c) What If? How would the answers to parts (a) and (b) change if the plane turned to fly due east? (d) Can this emf be used to power a lightbulb in the passenger compartment? Explain your answer.
a) A wire is held horizontally in a vacuum chamber, and carries a current of 1.35 µA. A proton is traveling in a direction parallel to the wire (opposite the current) with a constant speed of 2.40 ✕ 104 m/s at a distance d above the wire. Ignoring the magnetic field due to the Earth, determine the value of d (in cm). b)What If? At what distance d (in m) would an electron moving with the same speed as the proton move parallel to the wire? c)What direction would the electron have to move? In the same direction as the proton. In the opposite direction as the proton. There is too little information to determine the direction.
Frustrated by the small Hall voltage obtained in blood flow measurements, a medical physicist decides to increase the applied magnetic field strength to get a 0.500-V output for blood moving at 30.0 cm/s in a 1.50-cm-diameter vessel. (a) What magnetic field strength is needed? (b) What is unreasonable about this result? (c) Which premise is responsible?