Answered: USE A Electrical block diagram to…

USE A Electrical block diagram to explain a typical n-joint robot driven by Dc electrical motors. USE bold lines for the high-power signals and thin lines for the communication signals.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter47: Solid-state Adjustable Speed Control

Section: Chapter Questions

Problem 5SQ

See similar textbooks

Related questions

Q: The synchronous generator will have voltage and frequency depend on O Field current and speed. O…

A: In this question we will write about synchronous generator frequency and voltage...

Q: A PV system uses 720 silicon PV cells connected in an array which supplies up to 120 V. .How many PV…

A: Given, A PV system uses N=720 silicon PV cells. Total supplied voltage, Vs=120 V One cell delivers,…

Q: After plotting the Boolean function A(w,x,y,z) = A(w,x,y.x)=∑ m (0,1,3,4,5,6,7,8,9,10,11,13,14,15)…

Q: Find the half-power bandwidth of a parallel resonant circuit which has a resonant frequency of 7.1…

A: given resonant frequency of 7.1 MHz and Q of 250.here we have to find the half-power bandwidth of a…

Q: The resistance of a wire

Q: Q2: For the circuit shown in Figure beside, if i 5+20sin(1000t)-10cos(3000t) A.. Find the total…

Q: e 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of the line is…

A: It is given that the length of the transmission line is 15 km. It is considered as a short…

Q: Qle) Find, and in the circuit given. Use KVL and ohms law only to solve. 12 V 40 60 4V

Q: The type of display that enables very precise check reading is 1) digital 2) analog 3) label 4) none

Q: 4. For the Wheatstone bridge network shown in Figure. a) Evaluate the Wheatstone Bridge network and…

Q: 16.2 Circuit Element Models Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt-…

Q: gc+) = 10 Sinwot. → Euler ± juot • F[e ] = 2x S(W=WO)

Q: True or False? The magnetic field lines are independent with magnetic field intensity.

A: Given: The magnetic field lines are independent of magnetic field intensity. Required: True or False

Q: : Answer All points: Find the value of Vx due to the 16V source in Fig.5 (using superposition…

Q: 25. A parallel plate capacitor has 19 interleaved plates each 75 mm by 75 mm separated by mica…

A: For the given number of interleaved plates we need to calculate capacitance of the capacitor.

Q: The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O…

A: Given data, For Pure inductive load , Resistance = 0. Given, iron losses = copper losses. For pure…

Q: 04: For the admittance locus diagram shown beside: 1. Draw the electric circuit. 2. Find the value…

Q: The sync be regula speed.

Q: 17. Find f(t) of the following F(s): = 25s² + 395s + 1494 s² + 15s + 54

A: given here F(s) and asked to find the inverse laplace transform of F(s).

Q: Q2: A JFET has parameters of Vp6V and loss - 3mA. Plot the transconductance curve for the devic…

Q: If a current enters the dotted terminal of one coil, the reference polarity of the mutual volt a.…

A: Q 5 solution) ANSWER- positive According to Dot convention, If a current enters the dotted…

Q: Types of MOSTFET transistor are depending on OThe nature of the bulk semiconductor. OThe name of…

A: MOSFET can be classification based on the construction and the material used in it. MOSFETs are of…

Q: To conserve energy due to the present energy crisis, the Meralco tried tride to readjust their…

Q: Find lb in the circuit shown below if Vg = 25/15° V and la = 5/15⁰ A.

A: Given data, The value of the current Ia is5∠15° A,

Q: The practical inverters output voltage normally is OSinusoidal waveform ONon-Sinusoidal waveform…

A: Practical inverters output voltage normally is

Q: 19. The value of absolute permeability is: a. 1.2566 x 10-6 H cm b. 1.2566 x 10-4- cm C. 1.2566 x…

A: 19) The absolute permeability of the free space is given by u.

Q: 8. The maximum instantaneous voltage output is 300V while the current output is 20A.What is the…

A: The power can be calculated by converting the instantaneous value into RMS value and then use the…

Q: The amount of charge represented by four million protons O+6.408*(10)^(-13). 060.504*(10)^(-13).…

A: In the above given question we need to calculate total amount of charge represented by 4 million…

Q: Determine the value of the current (I) and the drop voltage across the resistance (V1) Rs www 1502…

Q: Assume a Thevenin equivalent circuit with E = 10V, Z = 5.1 K02-11.31, Find Inorton and Znorton…

A: Given a Thevenin equivalent circuit, Thevenin voltage, Eth=10 V Thevenin impedance, Zth=5.1∠-11.31…

Q: Correct any five of the following sentences using At star connection when neutral current isn't…

A: 1) ANSWER- At star connection when neutral current isn't equal to zero the system is Unbalanced.…

Q: Q3/ Answer the followings For the oscilloscope trace of a sine wave. Each horizontal division…

A: We need to find out the frequency, peak to peak voltage and RMS value for given waveform

Q: series motors has a very high starting torque because its armature resistance is small O True O…

A: Given A true or false question based on series DC motor. Please find the answer below

Q: 1.1 How many coulombs are represented by these amounts of electrons? (a) 6.482 x 10¹7 (b) 1.24 x…

Q: For the oscilloscope trace of a sine wave. Each horizontal division represents 200μs and each…

Q: 15. Find f(t) of the following F(s): 8(s + 1)² (s² + 10s +34) (s² +8s +20)

Q: and b) Draw the S.F.G and obtain the transfer functions R₁ using Mason's gain formula. R₁(s) G₁ G₂…

Q: termine the radio horizon for a transmit antenna that is 100 ft high and a receiving antenna that is…

Q: 17. According to the Len's Law, the direction of the magnetic field induced by a current always have…

A: Given that

Q: Three resistors R1, R2 and R3 are connected in series. According to the following relations, if RT =…

Q: Q6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 4Ω ΤΩ 34 ΑΜ 16 Ω ΤΩ 12 V ΤΟ Ω

A: We need to find out output voltage for given circuit

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

Q: a-) In the circuit below, the silicon diode needs 1mA as the lowest value of the current in order to…

A: For the above given series connection of voltage source , resistor and diode we need to calculate…

Q: The amount of charge represented by four million protons

A: Given:Number of protons=4×106To find:The amount of charge represented by 4 million protons

Q: Determine the current flowing through an element if the charge flow is given by (a) q(t) = (3t+ 8)…

A: (a) The current is the rate of change of the charge across the conductor. It is expressed as:…

Q: The voltage 2,000,000 V can be expressed in powers of 10 as: (a) 2 mV (b) 2 kV (c) 2 MV (d) 2 GV

A: Given: Voltage, V=2,000,000V conversion system: 1000=103=K1000,000=106=M

Q: 9. The generator power is always the maximum load power. c. equal b. less than d. greater than or…

Q: The voltage regulation regulated by changing O True Foloo of alternator can b its rotational spee

A: In this question we will write about voltage regulation of alternator.....

Q: -The electric field intensity ? L/A C V/I C V/R C V/L C None of them.

A: In this question we will write about electric field intensity...

Q: Q1b) Application of Mesh Analysis - No simplification needed a) Write V, in terms of mesh currents…

A: using mesh analysis 4 sub part of question is solve as

Question

USE A Electrical block diagram to explain a typical n-joint robot driven by Dc electrical motors. USE bold lines for the
high-power signals and thin lines for the communication signals.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Proportional, Integral, Derivative Controllers and their Combinations

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is CAN (Controller Area Network) and its significance in automotive applications?
briefly describe the steps involved in the newton raphson method
Q.Explain sources of noise and its type(electrical amd static noise) in detail?Explain magnetic noise in detail ?Explain crosstalk,shielding and grounding in detail ?Explain level measurement(mechanical level indicators) in detail?
What function does a classic load balancer serve? I need like three sentences.
a it;s about the signal of mechanical engineering not math.
_URGENTLY_Hello I need to answer this introduction to robotics questions. Thank you by now. _PLEASE RAPIDLY HELP_
how do you do the truth and voltage tables for this equation??
a. What is the ampere rating of the circuits that are provided for the small-appliance loads? _____ b. What is the minimum number of small-appliance circuits permitted by the Code? _____ c. How many small-appliance circuits are included in this residence? ____
The nominal speed of a construction machine with an operation is 1000 rpm, and when the speed of the construction machine is halved, the power of the electrical machine is halved. What are the characteristics of the electrical machine and the work machine that should be preferred for such a system?
How do traction inverters control the power delivery from the battery to the electric motor in an electric vehicle? What strategies are used to optimize efficiency and torque control?
What Are the Different Programming Methods for Robots?
The linearized longitudinal motion of a helicopter near hover can be modeled by the following normalized equations: where ? is the pitch ratio, ? is the hull pitch attitude, ? is the horizontal velocity, and δ is the rotor pitch angle corresponding to the control input.Suppose our sensor measures horizontal velocity ? as output. Automatic Control. Is the system controllable? Is the system stabilizable?