Use mesh analysis method to find thebranch current 13 *10 V+1O 3 mAO -5 mAO 3 AO -2 MAO-3 mA4Ωi₁136Ω3Ω1245 A

Answered: Use mesh analysis method to find the…

Use mesh analysis method to find the branch current 13 * 10 V (+ O 3 mA O-5 mA O3A O -2 mA -3 mA 4Ω i₁ 13 6Ω 3 Ω ww 1₂ 5 A

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 9PP: In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.

See similar textbooks

Related questions

Q: Safety precautions for handling cell storage case battery

A: Safety precautions for handling cell storage case battery are listed below

Q: What will be the average power in the load for the circuit shown, when alpha = π/4 Assume SCR to be…

A: The Given α=π4 Assume SCR to be ideal. The supply Voltage is 330 sin 314t To calculate the RMS power…

Q: A 50 MVA, 11 kV, 3-phase generator has a stored energy of 400 MJ. Its inertia constant is?

A: Given a 3-phase generator with, MVA rating, S = 50 MVA Stored kinetic energy, K.E. = 400 MJ

Q: A 100 KVA transformer is at 80% of full-load with power factor of 0.85 lagging. What KVA of load of…

Q: From the circuit shown in the figure, assume LED1 has a forward voltage of 2 volts and 20 Q forward…

A: For the given circuit diagram we need to calculate the value of current I1.

Q: (9) A carrier frequency of 105 Hz modulated by a message signal m(t) produced an FM signal expressed…

A: Given here a FM signal and asked to find the modulation index.

Q: An AC voltage source has an output of v = (220 V) sin 2 T It and connected to a 70 resistor as shown…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: Discuss advantages of per units representation

A: Advantages of per unit representation

Q: wwww wwww Fig. 40.17 If in Fig. 40.17, R = 220 k2, and C= 500 pF, what will be the frequency of…

A: Given, A phase shift oscillator employing the network Where, Resistance, R=220 kΩ Capacitance,…

Q: The following differential equation describes a water tank system 1 1 AR -h(t) ==q;(t) A where _h(t)…

Q: What is fet and what is bjt !

A: FET is Field Effect Transistor, as the name suggests, the parameters of the device are controlled by…

Q: The pass band voltage gain of an amplifier is 275. The voltage gain in decibels (dB) at the cutoff…

A: Given: Linear voltage gain of amplifier, Av=275

Q: d) Describe the construction, principle of operation and application of i) Rod gaps ii) Expulsion…

A: Given types of arresters: Rod gaps Expulsion gap Valve type lightning arrester

Q: 4. The amplitude spectrum of the signal x(t) is shown as follows: | X()| 2 A -3500 -3450 -2000 0…

Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * -12.7 V R1…

A: For the given diode circuit we need anode to cathode voltage of the diode.

Q: 2. a) Give a formulation of the Nyquist criterion for stability in both cases, when the open- loop…

Q: A 2-pole, 50 Hz, 11 kV 100 MW alternator has a moment of inertia of 10,000 kg.m². The value of…

A: Given data, Number of pole P = 2 Frequency f = 50 Hz Power P = 100 MW Moment of inertia I=10000 kgm3

Q: 7-22 5V dead battery 0 internal resistance live 12 V battery 0.02

Q: Consider the following electrical circuit: V₁ 2)t 3) R₂ + R₁ VA A R₁ + Assuming zero initial…

A: Transfer function is defined as the ratio of output to input with zero initial conditions The…

Q: Example 2.33. Using Node voltage method, find the current in the 302 resistance for the net- work…

A: Given circuit,

Q: In an attempt to boost DC voltage, two students thought of using a transformer to accomplish such…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: What are the characteristics of an ideal operational amplifier?

A: The solution is provided in the following section.

Q: OR e) Describe the working principle of SF6 circuit breaker and discuss the advantages and…

A: SF6 is gas which is compressed and filled in a tank. Whenever there is a fault conditions, the…

Q: The following function is: f(t) = 3u(t)- 5u(t-1) + 2u(t - 2) O a. O b. O d. Represented in Laplace…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.…

Q: Question (1): (i) What is the noise figure F of a cable with an attenuation factor a = 1.5 dB/m and…

A: Noise figure :- It is uses the logarithmic scale and it is noise factor which is expressed in…

Q: A stationary closed Lissajous pattern on an oscilloscope has 3 horizontal tangencies and 2 vertical…

A: Given data, Number of horizontal tangencies Nh=3 Number of vertical tangencies Ny=2 Horizontal input…

Q: 51. Which of the following options represent the correct reduction of XYZ + XYZ? a) 0 b) YZ c) X+X…

A: Given Boolean function, F=X.Y.Z+X.Y.Z

Q: to c correct the errors that can occur when the data is moved or stored from t to the receiver.…

A: (i) The number of message bit(m) is 16. To find parity bits(p) we use the formula as Given m=16,…

Q: 1. a) What is the amplification ratio (expressed in dB) of a DC amplifier with input DC voltage of…

A: 1. a) The amplification ratio is given by the expression as shown below: Av=VoutVinVout=10 VVin=100…

Q: QUESTION 4 For an n-channel Junction Field-Effect Transistor (JFET), the gate-source cut-off…

Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * R1 -12.7 V…

Q: 1. Find and draw the Fourier Transform of the signal shown if figure below: f(t) -T A coswot

A: 1) To find the Fourier transform of the given signal f(t) = cos(wot) And also draw it's Fourier…

Q: Assume zero initial conditions and no damping and solve for the response of a mass-spring system to…

Q: Vo= 1 + 2R RR) (V₁ – V₂) = k(V₁ – V₂) Rp

Q: A 5 KVA, 2300/230 V, 50 Hz transformer was tested for iron losses with normal excitation and copper…

A: It is given that: Pi=40W Pcu=112W. Power factor =0.8 KVA=5 V1/V2=2300/230 V

Q: b) Find IB, IC, IE, VB and V. in Figure 1 where ßdc is 50. Assume that the transistor is of silicon…

Q: How do you get the value of Vab and Vac here? (YELLOW HIGHLIGHTED PART)

A: Given: A balanced 3-phase voltage source Van=200∠0°

Q: Discuss the significance current limiting reactor in power system

A: A current limiting reactor consists of a large inductance compared to its ohmic resistance

Q: Q1:- Find the value of the electric current passing in (692) in figure (2-24) by using current…

A: Current Division Principle- When two or more passive elements are connected in parallel, the amount…

Q: V d) Describe the construction, principle of operation and application of i) Rod gaps ii) Expulsion…

Q: s²+1 - s(s2+28+8+ Consider the Laplace function F(s) its denominator. How many zeros H(s) has? 02 O…

Q: 3 delta connected load each phase of which has an inductive. reactance of 40 22 and resistance of 25…

A: Drawing the circuit diagram of the system as shown below- iVoltage across each phase of the…

Q: Calculate the Fourier Transform of the signal x(t) = cos(2*pi*t) + cos(5*pi*t) and draw the signal…

A: Given: xt=cos2πt+cos5πt Required: (1)Fourier Transform of the signal x(t). (2)draw…

Q: Example 2.40. Using Nodal analysis, find the node voltages V, and V₂ in Fig. 2.74. IA 8A ww Fig.…

A: Given circuit, Voltage at node 1 is V1 Voltage at node 2 is V2

Q: 13.78 currents in the circuit of Fig. 13.140. 1+ 100/30° V (+ 20 Ω I₁ j80 Ω determine the mesh 40 Ω…

Q: A three-phase four-wire system has unbalanced connected loads that draws 7 amps from line A, 16…

Q: B- The height of a wind turbine is 32.13m. Find the wind speed in K/h needed to generate 4641.7Kw if…

A: Given: Generated power P=4641.7 KW Height of the wind turbine h=32.13 m Density of air…

Q: 1. Find the ammeter current in Fig. 2.57 by using loop analysis. 2V 10 ww ww 103

A: Given circuit,

Q: Consider the following system α 1 * = ( ₁ ) x + (²) ₁² x 1 (1) Calculate the equilibrium of the…

Q: P 11.9-3 The source voltage of the circuit shown in Figure P 11.9-3 is vs = 141.4 cos 100t V.…

Question

Use mesh analysis method to find the
branch current 13 *
10 V
+1
O 3 mA
O -5 mA
O 3 A
O -2 MA
O-3 mA
4Ω
i₁
13
6Ω
3Ω
12
45 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.
TOTAL IMPEDANCE FIND CIRCUIT ( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
Check Causality, dynamic, linearity and time invariant tor the tolowing System Y(t)=]sin(2t)]x(t-2)
Solve no. 02 and show solutions. (Lesson: Network Laws (Source Transformation and Superposition Theorem))
16.8 304200V 6 2 MW 4 a Practice: || Find the Thevenin equivalent at terminals a-b of the below circuit: b oy Answer: | 7y, = 124 - j32 9, Vi = 18.97/—51.57°V.
Find the two elements in a series circuit (i.e., R and L, or R and C, or L and C), given that i(t) = 2 √2 sin(120πt + π/6) A. and v(t) = 100 √2 cos(120πt - π/6)
Consider an LC circuit with L = 0.2 henry and C = 5x10^(-4) farad. At time t = 0, when both i (0) and q (0) are zero, the circuit is connected to a 120 cos (200t) volt alternating current generator. Find the current in the circuit at any time.
I getting incomplete answers please give me full answer i will give like else dislike Two impedances Z{1}= 10 - j15 Ω and Z{2} = 4 + j8 Ω are connected in parallel. The supply voltage is 100 V, 25 Hz. So find the admittance, conductance,susceptance, total current and power factor of the combiner circuit
L = 40 uH C = 1 uF R1 = 10 ohms R2 = 5 ohms R3 = 6 ohms 1) Admittance each branch 2) Equivalent admittance 3) What is the equivalent impedance to the right of the current source? 4) Source voltage and phasor
What is the nature of a circuit if its total impedance is 4-j4 ohms? Group of answer choices reactive capacitive inductive passive
ractice: Find the Thevenin equivalent at terminals a-b of the below circuit: 6 2 =124 —j32Q Vo= 1897,
8. 7.8 In the circuit , the voltage and current expressions are v=400e−5tV, t≥0+;i=10e−5tA, t≥0.2. b) τ (in milliseconds).