Use msseh naalyiss to answer the following W=5 Y=0

Q: 5 Find the average value of the periodic function shown in figure. VIMA 0 π/3 2π/3 4/3 5/3 2π [Ans:…

A:

Q: QI/A: The per unit admittances are indicated at the diagram and the bus data are given in table as…

A: YBUS=Y11Y12Y13Y21Y22Y23Y31Y32Y33where,Y11=y12+y13Y12=Y21=-y12Y13=Y31=-y13Y22=y12+y23Y23=Y32=-y23Y33=…

Q: For the circuit shown: 1. Find the value of "Rc" that makes the circuit in resonance. 2. Calculate…

A: Given Data:- Voltage(VT)=10∠0°VResistance(RL)=8ΩInductance(XL)=j6ΩCapacitance(XC)=-j5Ω

Q: Great algebraic explanation, what would the conclusion be?

A: The solution is provided in the following section.

Q: A coil having a resistance of 2002 and an inductance of 150 mH is connected series to a 50 μF…

A: Resonant frequency is the natural frequency of object it vibrate at a high amplitude. resonant…

Q: [20] For the system given below, find the sinusoidal expression for the unknown current i, if 4-20 x…

A: In this question,  We need to determine the sinusoidal expression for the unknown current i1  .  We…

Q: Find the Thevenin equivalent at terminals a-b of the circuit 492 ww 1.51, 2/0° A -j3 92

A: For the given circuit diagram we need to derive the values of thevenin voltage and impedance.

Q: The voltage and current of a load are v(t)=5cos(5nt+15) and i(t)=0.5cos(5t+45), respectively.…

A: Given, The voltage and current of a load are, vt=5cos5πt+15°it=0.5cos5πt+45°

Q: Find v and ic for t> 0 if i (0) = 1A and v(0) = 8V. 4H 20 250 mF 1.6. + >. ic 802

A:

Q: Shunt and series generates can connected in parallel. O True O False

A: Generator:- It is used to convert mechanical energy to electrical energy. DC and AC generators are…

Q: Instructions Transform the following Boolean expression into a Logic Diagram and convert into NOR…

A: given here a boolean expression and asked to draw the logic diagram and NOR gate implementation

Q: Question 17 Find the wave length of a carrier wave with frequency of 20 MHz. 35m 45m 25m 15m

A: Given: Frequency, f=20MHzSpeed of light, c=3×108 m/s

Q: 40. According to the continuity of current, if we consider closed surface, then current out of the…

A: Continuity of current :-  It states that " when current leaves a small closed surface then there…

Q: Using Bio-Savart law, calculate the Magnetic Field (B) at an axial point P a distance x from the…

A: Boot Savart Law is directly proportional to the current in the elemental part , length of the…

Q: Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage input is multiplied by…

A: Given Circuit is:-

Q: For the circuit shown: 1. Find the value of "R" that makes the circuit in resonance. 2. Determine…

A: It is given that:

Q: For the circuit shown. Find R₁, R₂, R3 so that Z₁1=2.5K₁, Z₁2=Z₂₁1 = 1.25K₁² Z2₂2= 3.125 K R₁ -MM ww…

A:

Q: The average current of sinusoidal wave is 50A. Compute for maximum current. Group of answer choices…

A: given here the average current of sinusoidal wave is 50 Ahere we have to find the maximum value of…

Q: Q2) Referring to the Figure 2 below, determine i(t) and ir(t) for t> 0 Given [1, t0 20 Ω www 4 A 20…

A:

Q: Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt- age input is multiplied by…

A:

Q: Qs-For the circuit Shown in Fig (3) - SOKA loo 2mA 43 50 PF 3MA a) By using approximate Parllel…

A:

Q: If the  surface leakage current is 2nA for a reverse voltage of 25V, what is the surface leakage…

A:

Q: 5. The short circuit load is connected to a transmission line. When the transmission line length is…

A:

Q: A single phase half-bridge voltage source inverter (VSI) has a resistive load of 2.4Ω and input dc…

A: Single phase half bridge is a voltage source inverter. The input power of the inverter is a DC…

Q: If A = 3a, + 2ag - 6a, and B = 4a, + 3a, determine (a) A B (b) A X B (c) The vector component of A…

A: It is given that: A=3ar+2aθ-6aϕB=4ar+3aϕ

Q: Ro Find the voltage V₂ by the corrent Source Iz 2 find the voltage V3 by the voltage Source Vz 3…

A:

Q: capacitor vo(t).

A:

Q: A Thevenin de equivalent circuit always consists of an equivalent......... a. AC voltage source DC…

A:

Q: 29. What is the value of current density at (0, 0, 1) when magnetic field intensity is: A H = y cos…

A: The value of current density at (0,0,1) when magnetic field intensity given: H=ycos2x ax+y az  Am…

Q: 22 3 We apply a voltage of 220 V to Fcc an copper wire of 20 m long, number of charge carries (n) =…

A:

Q: Estimate the resistivity of a Si sample doped with phosphorus to a concentration of 10 ^ 15 * c * m…

A: When Silicon is doped with phosphorus the majority of the charge carrier are electrons which means…

Q: Please solve asap my deadline is very close

A:

Q: 14. Compute the minimal value of K so that the steady-state error due to a unit step distur- bance…

A:

Q: Determine the thermal efficiency of a steam power station given the following data:  Coal…

A: Given  A problem on thermal efficiency of a steam power station. Please find the below attachment…

Q: 2 Q1// Calculate the output voltage (Vout) for the amplifier RF ww 1MQ R1 www 10kQ V1 1mV- R2 20kQ…

A: In this question we will find output voltage of given operational amplifier.....

Q: What kind of circuits should be used to convert the analog signal into digital signal? figure with…

A: ADC is a Analog to digital converter used for the conversion of the analog signal to the digital…

Q: In a linear circuit the super position principle can be applied to calculate the O Voltage and power…

A: In this question we will write about superposition theorem.....

Q: Question 39 Super positions theorem is not applicable in the network when it is Linear Time in…

A: In this question we will write about superposition theorem....

Q: I need the solution for Part B please. 1.07 KiloOhms is incorrect and 0 KiloOhms is also incorrect.

A: Given: Consider the circuit shown in the figure: A Q-point value for IC between a minimum of 4 mA…

Q: A half wave rectifier feeds a load of 10ohms in series with inductance of 20mH. The input supply…

A: Given  A half wave rectifier circuit along with its parameters.we need to determine the average dc…

Q: Question 9: Time-domain sampling. Consider the continuous-time signal xa(t) = {e !* (e-j4nFot, t≥0…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Plot & Root locus for the T.f. k G(s)H(s) =+ S(S+1) (5+2) (5+3)

A: 1-Root locus is the locus of The poles of closed loop system when the gain of the open loop system…

Q: 9- In AM DSB/SC, the carrier is suppressed in order to: a) simplify the receiver design b) reduce…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: hevenin's theorem is quite useful when the current in one branch of a network is to e determined. -…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: VTH for the circuit external to RL. XC 12 ΚΩ RL 49 ΚΩ R • 15 ΚΩ

A: In this case we have to remove RL and measure open circuit voltage across it in order to calculate…

Q: Question 14 The rms value of half wave rectified sine wave is 100A. Its maximum value is 199 A 202 A…

A: Q.14) ans:( d) 200A    For half wave rectifier, RMS value of load current = Io(RMS)  = Jpk /2

Q: 5. Write the Boolean expression equivalent to the following logic circuit. Dor simplify! Hint: Each…

A: Given logic circuit,

Q: Referring to this figure, find Zo if yos = 20 µS. express answer in kiloohms 2k2 C₁ HH ť V Z I MQ 2V…

A:

Q: Two 8 bit numbers in a hexadecimal are E3 and FE. Obtain the checksum.

A: 8 bit hexadecimal

Q: 1. Thevenin's theorem is quite useful when the current in one branch of a network is to be…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,