Use the circuit given to the right to do the following:a. Determine the voltage across each resistor.3 k218k 215 V9k 2b. Determine the current through each resistor.c. Determine the power absorbed by each resistor.d. Determine the power output by the voltage source

According to Ohm's law , the voltage across the circuit is calculated by using the formula V=IR ,…

Use the circuit given to the right to do the following: a. Determine the voltage across each resistor. 18k 2 3 kQ + 15 V 9 k 2 b. Determine the current through each resistor. c. Determine the power absorbed by each resistor. d. Determine the power output by the voltage source

Use the circuit given to the right to do the following: a. Determine the voltage across each resistor. 18k 2 3 kQ + 15 V 9 k 2 b. Determine the current through each resistor. c. Determine the power absorbed by each resistor. d. Determine the power output by the voltage source

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 37P: Consider the circuits shown below, (a) What is the current through each resistor in part (a)? (b)...

See similar textbooks

Related questions

Q: 3. 3 resistors are connected to a 9 v battery. The values are listed in the table below. a) Draw a…

Q: A circuit has a 62.1Ω resistor, a 71 and a 47.2 resistor all connected in parallel with each other.…

A: R1 = 62.1 Ω R2 = 71 Ω R3 = 47.2 Ω

Q: n series across an applied voltage of 120 V. What is the voltage drop across each resistor? Sketch…

Q: On three separate instances you connect each lightbulb to a battery with an emf of 12.00 V and an…

A: 1. The equation for the voltage drop across the lightbulb is given by V=ε-Ir Here, ε is the emf of…

Q: Three resistors with resistance 1 Ω, 5 Ω, and 10 Ω respectively, are connected in parallel with a 20…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 2. An air conditioner draws 14.0 A at 220-V. The connecting cord is copper wire (resistivity of…

A: As you have not mentioned the number of questions to be solved. According to Bartleby Policy, we…

Q: When a single resistor is connected to a battery, the current through that resistor can be found…

Q: An electric circuit consists of two emf sources with negligible internal resistance, three…

Q: Consider a simple circuit consisting of a battery, a closed switch, and a resistor. The voltage…

A: Write the expression for resistance

Q: 7. A 22-KQ resistor having a tolerance of 10% has failed. You have on hand five resistors, valued at…

A: in this question we connect resistance in parallel then get resultant by that equation. p

Q: 04a. Find the resistance of an electric toaster which draws a current of 6.62 A when plugged into a…

Q: When a single resistor is connected to a battery, the current through that resistor can be found…

A: When a single resistor is connected to a battery then the current through the resistor measured…

Q: The parallel combination of 40 ohms, 60 ohms, and 120 ohms is connected in series with 15 ohms and…

Q: 8. ht The following description of a circuit appears in your experimental laboratory manual. You are…

A: An ammeter is connected in series with the batteries.

Q: Solve the following question below, (a) Calculate the current through a 2.5  flashlight filament…

Q: ww 7.0Ω ww 80Ω 4.0 2 12.0 V A06 ww

Q: Figure 3 shows a circuit consists of three batteries and three resistors. 5V 100 ohms 200 ohms ww 10…

Q: A battery with an emf of 12 V and an internal resistance of 0.8 ohm is to be recharged through a 20…

Q: A resistor with resistance 25.5 2 is connected to the terminals of a voltage source. (a) Calculate…

A: a. Current through resistance is I=VR=7.5 V25.5Ω=0.29 A

Q: 1. Which of the following is true about Ohm's law? a. It gives us the relationship among wire's…

A: According to ohm's law V = IR V = potential difference I = current R = Resistance

Q: You are given a number of 33 Q resistors, each capable of dissipating only 3.1 W without being…

A: Power dissipated is given by, P=imax2R

Q: Could someone help solve these problems? 3) (a) Find the equivalent resistance between points a and…

A: (3) (a) The parallel combination of resistance at the point c and d is, Substitute the values,

Q: 24.0 V 2. Consider the circuit shown in figure 5. The terminal voltage of the 24.0-V battery is 22.6…

A: Given data: The emf of battery is ε=24 V. The terminal voltage is V=22.6 V. The current in the…

Q: 1- The drawing shows three different resistors in two different circuits. The battery has a voltage…

Q: The circuit shown below consists of a 12-V battery and four resistors. The currents through K and N…

A: battery rating = 12 V current through K = 9 A current through M and N = 1 A voltage across M = 3 V…

Q: Problem 1. A battery with a terminal voltage of 12V is connected to a circuit consisting of four 10…

A: Given Voltage (V) = 12V Resistance = 10 ohm Resistance = 20 ohm

Q: Assume that you have a voltage source of 31 V and three resistors: Resistor A is 9.5 Ω, Resistor B…

Q: What is the purpose of a battery or a generator in a circuit? a. Restricts the flow of…

Q: A 3-ohm resistor and a 6-ohm resistor are connected in series across a 9-volt battery. Which…

A: Resistance, R1 = 3 ΩResistance, R2 = 6ΩAlso, R2 = 2 R1Voltage = 9V

Q: A2.2 kN and a 4.0 kl resistor are connected in parallel; this combination is connected in series…

Q: QUESTION 11 A series circuit has.. O a. 1 path, but if one light/ electrical device burns out in a…

A: In a series connection, there is only one path possible for the flow of electron or charges and if…

Q: A circuit consists of a series combination of 6.50 kΩ and 5.00 kΩ resistors connected across a 50.0…

A: Given,

Q: 5. A certain Tesla car has a 400 V battery which stores 2.9x108 J. The car can travel 402 km (250…

A: (A) Let d be the distance traveled by car with a velocity v before the battery gets depleted. Write…

Q: When a pair of identical resistors (say 4 ohm each) are connected in SERIES to a 12 V car battery,…

Q: 12V 24V 1002 4002 40Ω

Q: A voltage V(t) = Vm sin(wt) is applied across a 49 ohm resistor. What is the average power in Watts…

Q: 4 When a resistor with resistance R is connected to a 1.50-V flashlight battery, the resistor…

A: Given data V=1.5 VP=0.0625W

Q: 3. A triangular array of resistors is shown in the figure on the right. What current will this array…

A: Given data The potential difference of the battery is V = 35 V The resistance across the ab is Rab =…

Q: Three resistors with values of 9 ?, 6 ?, and 12 ? respectively are connected in parallel to a 12 V…

A: Given three resistors are connected in parallel circuit and their resistance values are 9 ohm, 6 ohm…

Q: A circuit consists of a series combination of 5.50 kΩ and 5.00 kΩ resistors connected across a 50.0…

A: (a)The equivalent resistance of two resistors in parallel is given by,Substitute the values,

Q: Fill out the missing details on the data sheet. Include the sample calculations, and graphs (if…

Q: A circuit with a battery, a 4 Ω resistor, a 15 Ω resistor, and a 22 Ω resistor in series. The total…

A: Resistances are 4ohm, 15ohm, 22phm are connected in series Total current is 9.6A

Q: 2. You need a 45 Q resistor, but the stockroom has only 20 Q and 50 Q resistors. How can the desired…

Q: 1. Which of the following is true about Ohm's law? a. It gives us the relationship among wire's…

A: Answer: (1). a. It gives us the relationship among wire's resistance and the factors affecting it…

Question

Use the circuit given to the right to do the following:
a. Determine the voltage across each resistor.
3 k2
18k 2
15 V
9k 2
b. Determine the current through each resistor.
c. Determine the power absorbed by each resistor.
d. Determine the power output by the voltage source

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 :Introduction

VIEW

Step 2 :Calculation of the equivalent resistance

VIEW

Step 3 :Calculation of the net current

VIEW

Step 4 :Calculation of the current and power across R3

VIEW

Step 5 :Calculation of the voltage and current across R1 and R2

VIEW

Step 6 :Calculation of the power absorbed by R1 and R2

VIEW

Step 7 :Calculation of the power output by the voltage source

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 7 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuits shown below, (a) What is the current through each resistor in part (a)? (b) What is the current through each resistor in part (b)? (c) What is the power dissipated or consumed by each circuit? (d) What is the power supplied to each circuit?
Three 100- resistors are connected as shown in Figure P28.5. The maximum power that can safely be delivered to any one resistor is 25.0 W. (a) What is the maximum potential difference that can be applied to the terminals a and b? (b) For the voltage determined in part (a), what is the power delivered to each resistor? (c) What is the total power delivered to the combination of resistors?
Consider the circuit shown in Figure P18.11. Find (a) the potential difference between points a and b and (b) the current in the 20.0- resistor. Figure P18.11
The circuit in Figure P27.34a consists of three resistors and one battery with no internal resistance. (a) Find the current in the 5.00- resistor. (b) Find the power delivered to the 5.00- resistor. (c) In each of the circuits in Figures P27.34b, P27.34c, and P27.34d, an additional 15.0-V battery has been inserted into the circuit. Which diagram or diagrams represent a circuit that requires the use of Kirchhoffs rules to find the currents? Explain why. (d) In which of these three new circuits is the smallest amount of power delivered to the 10.0- resistor? (You need not calculate the power in each circuit if you explain your answer.) Figure P27.34
Why is the following situation impossible? A technician is testing a circuit that contains a resistance R. He realizes that a better design for the circuit would include a resistance 73R rather than R. He has three additional resistors, each with resistance R. By combining these additional resistors in a certain combination that is then placed in series with the original resistor, he achieves the desired resistance.
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
(a) What is the terminal voltage of a large 1.54-V carbon-zinc dry cell used in a physics lab to supply 2.00 A to a circuit if the cell’s internal resistance is 0.100 ? (b) How much electrical power does the cell produce? (c) What power goes to its load?
Unreasonable Results A 1.58-V alkaline cell with a 0.200- internal resistance is supplying 8.50 A to a load, {a) What is its terminal voltage? (b) What is the value of the load resistance? (c) What is unreasonable about these results? (d) Which assumptions are unreasonable or inconsistent?
For the circuit shown in Figure P28.24, calculate (a) the current in the 2.00-11 resistor and (b) the potential difference between points a and b.
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
The circuit shown in Figure P27.17 is connected for 2.00 min. (a) Determine the current in each branch of the circuit. (b) Find the energy delivered by each battery. (c) Find the energy delivered to each resistor. (d) Identify the type of energy storage transformation that occurs in the operation of the circuit. (e) Find the total amount of energy transformed into internal energy in the resistors.
A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?