Use the graphical method to construct the bending-moment diagram and identify the magnitude of the largest moment (consider both positive and negative). The ground reactions and shear-force diagram are provided. M = 43 kip-ft P= 19 kips By = 24.89 kips Cy=66.11 kips M Units: kips 3 ft By - в 8 kips/ft 9 ft B₂-72 3 ft P D

Use the graphical method to construct the bending-moment diagram and identify the magnitude of the largest moment (consider both positive and negative). The ground reactions and shear-force diagram are provided. M = 43 kip-ft P= 19 kips By = 24.89 kips Cy=66.11 kips M Units: kips 3 ft By - в 8 kips/ft 9 ft B₂-72 3 ft P D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the forces and moments at point C and point D. 66 Kn/m is the given
Use moment distribution method indeterminate frame hown 1. find the moment at E in kNm. EI is constant choices 166.90 11.09 537.48 36.93 2. Find the horizontal and vertical reactions at support A in kNm. EI is constant 9.0 & 215.2 16.7 & 323.7 9.0 7 323.7 16.7 7 215.7
Q.4 The box beam is made from an elastic- plastic material for which. Determine the magnitude of each concentrated force P that will cause the moment to be (a) the largest elastic moment and (b) the largest plastic moment.
Draw the shear and moment diagram of the following figure
Calculate the vertical support reaction in support A. When sketching FBD, set the positive directions of both reactions in the positive direction of y axis. Enter your answer in kN to three decimal places.
Determine the reactions and draw the shear and bending moment diagrams for the beams shown in by using the Slope-deﬂection method. There’s a settlement of ½ in. at support B.
Calculate the vertical reaction at support B. When sketching FBD, assume the positive direction of all reactions in the positive direction of y axis. Enter your answer in kN to two decimal places.
Calculate the vertical component of the internal force at B. Let W = 4 kips/ft. Indicate the Minus sign (-) if answer is negative.
For the figure shown, find the horizontal reaction and vertical reaction at A and also the vertical reaction at B. Determine the Internal forces at point C. Construct the shear and moment equations/functions at segment DE (1.5 < x < 3.0).Note point D is at 1.5m from A and point E is 3.0m from A.
a) Draw the shear force and bending moment diagrams for the beam shown in the figure aboveand determine the maximum shear force and maximum bending moment along the lengthof the beam. b) Without doing any calculations, illustrate how you would determine the shear force andbending moment at any point in the beam by using the principle of superposition.c) By using the method of virtual work, calculate the vertical displacement at point C as afunction of the flexural stiffness of the beam, EI.
1. Solve for shear and moment diagram. show solution W1=115 p1=30 p2=35 p3=40 p4=50
For the beam presented below:a) What is the degree of indeterminacy; b) Determine the moment reactions at the supports and draw the shear and momentdiagrams. (Solve by expressing the internal moment in terms of vertical reactionsat A and B, EI is constant). c) What would the shear diagram look like if a transverse load P was applied right atthe middle of the beam (Make a sketch of the new shear diagram). W (30kN/m) , L (1.9m)