Using Kirchhoff's rules, find the following. (E, = 70.8 V, E, = 62.0 V, and & = 78.8 V.)b.4.00 kNdEE,E.R3R23.00 kN2.00 kNaR1(a) the current in each resistor shown in the figure abovemAIR3mA(b) the potential difference between points c and fmagnitude of potential differenceVpoint at higher potentialSelect-- v

Given: Voltage E1 = 70.8 V Voltage E2 = 62 V Voltage E3 = 78.8 V Resistance, R1 = 2 ohm…

Using Kirchhoff's rules, find the following. (1= 70.8 V, 2 = 62.0 V, and 3 = 78.8 V.) 4.00 kN d E, R3 E, R2 3.00 kN 2.00 kN R1 (a) the current in each resistor shown in the figure above mA IR2 mA mA (b) the potential difference between points c and f magnitude of potential difference point at higher potential -Select-

Using Kirchhoff's rules, find the following. (1= 70.8 V, 2 = 62.0 V, and 3 = 78.8 V.) 4.00 kN d E, R3 E, R2 3.00 kN 2.00 kN R1 (a) the current in each resistor shown in the figure above mA IR2 mA mA (b) the potential difference between points c and f magnitude of potential difference point at higher potential -Select-

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 88CP: The charge that flows through a point in a wire as a function of time is modeled as...

See similar textbooks

Similar questions

Pacemakers designed for long-termuse commonly employ a lithium-iodine battery capable of supplying 0.42 A # h of charge. (a) How many coulombs of chargecan such a battery supply? (b) If the average current producedby the pacemaker is 5.6 mA, what is the expected lifetime of thedevice?
Please help: A typical cell membrane is 8.0 nm thick and has an electrical resistivity of 1.3 x 10^7 Ω•m (A) If the potential difference between the inner and outer surfaces of a cell membrane is 75 mV, how much current flows through a square area of membrane 1.0 micrometers on a side? Express your answer using two significant figures (B) Suppose the thickness of the membrane is doubled, but the resistivity and potential difference remain the same. Does the current increase?
Please help: A typical cell membrane is 8.0nm thick and has an electrical resistivity of 1.3x10^7Ω*m A. If the potential difference between the inner and outer surfaces of a cell membrane is 75mV, how much current flows through a square area of membrane 1.0μm on a side? Express answer using two significant figures. B. Suppose the thickness of the membrane is doubled, but the resistivity and potential difference remain the same. Does the current increase or decrease?
An experiment is conducted to measure the electrical resistivityof Nichrome in the form of wires with different lengthsand cross - sectional areas. For one set of measurements, astudent uses 30.0 - gauge wire, which has a cross - sectionalarea of 7.30 x 10-8 m2. The student measures the potentialdifference across the wire and the current in the wire with avoltmeter and an ammeter, respectively. For each of the measurementsgiven in the following table taken on wires of threedifferent lengths, calculate the resistance of the wires and thecorresponding value of the resistivity. What is the average value of the resistivity, and how does thisvalue compare with the value given in Table 17.1?
Consider a resistor of resistivity 3.84 x 10-5 Ω • m, length 10.44 m, and unknown cross-sectional area. What potential difference, in millivolts, should be applied across the said resistor so the current density in it is 28.92 A/m2?
The charge that flows through a point in a wire as a function of time is modeled as q(t)=q0et/T=10.0Cet/5s . (a) What is the initial current through the wire at time t = 0.00 s? (b) Find the current at time t=12T . (c) At what time t will the current be reduced by one-half I=12I0 ?
A tungsten wire in a vacuum has length 15.0 cm andradius 1.00 mm. A potential difference is applied across it.(a) What is the resistance of the wire at 293 K? (b) Supposethe wire reaches an equilibrium temperature such that itemits 75.0 W in the form of radiation. Neglecting absorptionof any radiation from its environment, what is the temperatureof the wire? (Note: e = 0.320 for tungsten.) (c) What isthe resistance of the wire at the temperature found in part(b)? Assume the temperature changes linearly over this temperaturerange. (d) What voltage drop is required across thewire? (e) Why are tungsten lightbulbs energetically inefficientas light sources?
Part A:If there is an annealed copper wire with resistivity 0.172 nano ohm meters and a diameter of 2mm placed in an electric field of 16,000N/C, then how much current will go through the wire? Part BIf this wire (the same as in part A) has an electron density of 8.5x10^28 m^-3 then what is the drift velocity of the electrons in this wire? The charge of each electron is, as usual, 1.602x10^-19C.
What is the resistance of a 2.54-cm-diameter rod of pure silicon that is 20.0 cm long. What current flows through the rod when 1.00 × 103V is applied to it?
If a current of 80.0 mA exists in a metal wire, (a) howmany electrons flow past a given cross-section of the wire in10.0 min? (b) In what direction do the electrons travel withrespect to the current?
A 120 V house circuit fused for 25 A has operating on it the following: two 75 W bulbs, a 1500 W heater, a 20 W radio, a1.5 W clock. (a) How large a current is required? (b)Will the fuse blow if a second electric heater rated at 1500 W is plugged into it?
a) A1500W heater is connected to a 120V line. How many heat energy does it produce in 2.0hours? b) The resistivity of gold is 2.44x10-8ohm.m at room temperature. A gold wire that is 1.8mm in diameter and 11cm long carries a current of 170mA. How much power is dissipated in the wire?