Using the following items (shapes) build a system of analog AM music broadcast.

Q: he resistor. Complete parts A - I. R₁ m m R3 Vb R₂ M ww Rx

A:

Q: LED ObreakN VCC In the figure shown above 15 mA are needed to make the LED shine, how much…

A: We need to find out the base current for given circuit

Q: Take that vs = 36 V   Find the value of i1 in the figure.   Find the value of i2 in the figure

A: In this question We need to determine current I1  and I2  as shown the circuit.  We know  Voltage V=…

Q: can you also answer question 4 and 5

A: “Since you have posted multiple questionswe will provide the solution only to the first three sub…

Q: 4. Draw the circuit structure of a TCR. By changing the firing angle of thyristors, how can we…

A:

Q: Use Laplace transforms to determine the solution of the IVP y" - 3y' - 4y = -16x ८ y(0) = -4 y'(0) =…

A: Given that  y"-3y'-4y= -16 x Initial values y(0) = -4 y'(0)= -5

Q: The following input impedance curves have been measured for a straight wire antenna as a function of…

A: Straight Wire Antenna:

Q: Q4 (Sed 1.47) An amplifier using balanced power supplies is known to saturate for signals extending…

A: They are probability pulse-modulated harmonic oscillations. It is possible to think of each…

Q: Consider the circuit below. C Sal b Ri RE www R3 R7 www RG www R522 ERS RAZV+ /= 18A, /₁ = 8A, R7 =…

A: We need to find out the current for given circuit.

Q: A stringed instrument generates a complex waveform with the following components: 250 Hz with an…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: 1 Consider the continuous-time periodic signal: x(t) = cos(2nt) + 2 sin(6лt). a) Determine the…

A: Given: A continuous time periodic signal,  x(t)=cos(2πt)+2sin(6πt), To find: a) Fundamental period,…

Q: Q2/ For a source produces an equiprobable, symbols which has entropy 2.80735 bit per symbol, find…

A: Given: A discrete source with equi-probable symbols has entropy = 2.80735 bits/symbol, To find:…

Q: M R5 R3 R4 www R2

A:

Q: Across a 230 V, 60 Hz power supply is a 15 Ω non-inductive resistor. Find the equation  of the…

A: We need to find out the current through given resistor.

Q: 1) CHOICES: Ump 3= www 2R -(RCs + 1) RC₂1 www N/20 #R²C² s² +3RCs +1 R²C2g2+ RCs +1 5 Ugut # - RCs +…

A:

Q: A 240 V, 25 Hz single-phase ac generator is connected to a 20 Ω resistor. Find the  instantaneous…

A: The general expression of sine wave given as V=2 ×Vrms sin(ωt)

Q: *2.15 Determine I, in the circuit of Fig. P2.15. 12 V + www 502 2523 Ix Figure P2.15: Circuit for…

A: Given circuit, To determine current Ix.

Q: A single-phase, 20-kVA, 20,000/480 V, 60Hz distribution transformer is tested with the following…

A: “Since you have posted multiple sub parts,We will provide the solution only to the first three sub…

Q: Consider the circuit below. a 10 Ri ww 1- www R₂ Answer Ri K3 d 22 Question 6 ( Consider the circuit…

A: In these questions,  We need to determine the current and voltage.  We are solving this problems…

Q: P3. A 50 hp, three-phase, 60 Hz, wye-connected induction motor operates at a shaft speed of almost…

A:

Q: The characteristic impedance and phase constant of a lossless transmission line are Z₁ =502,…

A: Given  Zo = 50  f3 = 57z- x10-3 m-1 Load Zi, = 80 Vg, =120 V and Zg =12  Find load voltage

Q: 16. Find Rab· a) 4 Ω b) 6Ω c) 8 Ω d) 10 Ω e) none of these b 12Ω, 12 Ω ΜΝ 4Ω 14 Ω 4Ω

A:

Q: where a QR, b = QS, and c = QP. (b) Use the formula in part (a) to find the distance fr point P(2,…

A:

Q: find the G(s) = VL(s)/V(s) of the network v(t) +1 2Ω 1F WHE 252 1 F WH 2Ω 2 H elle VL(t)

A: Any closed path through a circuit when a node is not encountered exactly once is referred to as a…

Q: A rechargeable battery has a capacity of 28900 C of charge. When connected to a 2.35 A DC power…

A: Note: Charging time of Battery  T=Qfinal-QinitialIdc sec

Q: P1. Determine the number of poles, the slip, and the frequency of the rotor currents at the rated…

A: Note: As per our company guidelines we are supposed to answer only one question. Kindly repost other…

Q: P2: Determine the electric field flux density at (1,2,3) if there is a point charge - nС at (0,4,2)…

A:

Q: (a) Obtain the transfer function for the electrical circuit shown below using KVL and Laplace…

A: To find the transfer function of given circuit using KVL.

Q: Given the NE555 timer IC and a 9 V supply, design a circuit to generate a continuously running…

A: NE555 Timer IC:

Q: A 500-V, 37.3 kW, 1000 RPM, DC shunt motor has on full-load an efficiency of 90 percent. The…

A: Input power = Terminal voltage× Line current = Output powerefficiency. For motor, Line current =…

Q: 1.20 Halle V, y la potencia absorbida por cada elemento en circuito en la figura 1.31. 30 V 6 A 12 V…

A:

Q: a I R1 R₂ R3 R7 RO R522 R8 + RAZVA /= 24A, /₁ = 12A, R7= 100, and Rg = 160. Determine the power…

A:

Q: 1 If 2 ohm resistor is connected across the open circuit terminal. Using Thevenin's and Norto…

A:

Q: 2. Compute the convolution x[n]*v[n]. Express your answer in closed form. (a) v[n] au[n] and…

A:

Q: The current , in the circuit in (Figure 1) is 2.0 A, and the voltage v is 300 V. Figure Vg 4Ω www 50…

A: In these questions We need to determine the current i1  and power dissipate across each resistance.…

Q: 2. Aa circuit connected to a 115-V, 50 Hz supply takes 0.8 A at a power factor of 0.3 lagging.…

A:

Q: For a first order system find out the output of the system when the input applied to the system is a…

A:

Q: Find the Q-point for the diode in the following circuit using a) The ideal diode model; b) The…

A:

Q: In the circuit below, v₁ = -1 Volts, R₁ = 60, R₂ = 90. Find the Voltage v₁ across R₁. Give you…

A: Given data, vs=-1 V, R1=6Ω, R2=9 Ω. Circuit diagram is given as,

Q: For the circuit shomy Calculate the current through 30 Using Superposition Theorem. loov + 200 M ?I…

A:

Q: A measurement model follows R = kx^3 where x is the measured variable and K is a coefficient.…

A: Given  measurement model follows R = kx^3 where x is the measured variable  K is a coefficient…

Q: Exercise 9: Use the "synthetic multiplication" convolution algorithm to compute the output y[n] for…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: For the previous question, estimate the capacitance per unit length (pF).

A: Capacitance per unit length of a coaxial cable : b=Outer Diametera=Inner DiameterCapacitance…

Q: E1 12V Τ R1 1ΚΩ R2 1ΚΩ R3 1ΚΩ R4 1ΚΩ R Load

A:

Q: 50 µF 70 μF 60 μF 20 µF " 120 μF Respuesta: 40 μF.

A:

Q: Exercise 10: A signal x(t) has the two-sided spectrum representation shown below. 57 43e-j/2 43e)*/2…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: 7 Find the equivalent resistance between terminals a and b for the network shown in (Figure).…

A: Given data R1=12 Ω We have to find out the equivalent resistance between a and b when R1=12 Ω.…

Q: Find ReqT, currents and voltages of each resistor in the circuit. Fill the Table. ReqT R₂ W 6Ω I₁…

A:

Q: Caleulate the de output voltage in Fig

A: These given circuits are voltage multiplier circuits as shown their output. We can find dc output…

Q: Determine VL in the circuit below where R1=8 Ω and R2= 11 Ω.

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.