Using the formulas found in question 1, compute the amount of capacitive  current  needed in the circuit  to correct the power factor to 90%.

Q: Plot Ia and n against out power in same graph paper. Plot speed against output power.

A:

Q: A 240-V air conditioning compressor has an apparent resistance of 8 Ω. How much current will flow in…

A: According to the ohm's law relation between the voltage,current and the resistance is given by V =…

Q: For the above circuit determine VA in Volts rour 32.58 Volts then enter 32.6 as your submitted ar…

A:

Q: On the figure below, 3 different kind of dc sources pass through the 10- ohm resistor. Calculate for…

A: In this question we need to find a total voltage drop across 10 ohm resistor.

Q: A coil takes a current of 4 A when 24 V d.c. are applied and for the same power on a 50-Hz a.c.…

A: PART (a): For a Coil, Z=R+jXL Where,  R= Resistance of the coil, XL=Inductive reactance of the coil.…

Q: Determine the power angle in the series circuit which consists of R = 25 ohms, L = 0.123 H and C =…

A: Given Data: R = 25 ohms L = 0.123 H C = 123 uF V = 200 V f = 30 Hz

Q: 4. A certain load takes 10 kw at 75% pf. In the power contract, the pf penalty is applied only to…

A:

Q: An inductance of L Henries and a resistance of 15 ohms are connected in series with EMF of 135…

A: Apply KVL in loop and write the differential equation relating inductor current.  Now using linear…

Q: Circuit II A series circuit  composed of 100 ohms resistor and a 20 microfarad capacitor  connected…

A:

Q: In figure given below, V, = 1/2 V; = 18V, V, = 25V, V. = 30V. The applied voltage must then be equal…

A:

Q: In flat plate solar collector, if total surface of the collector is 110 m2 and the shadow effect is…

A: Area of collector surface = 110 m2  shadow effect = 90 %

Q: The existing condition of the power system can be determined by analysis. O Stability Power Flow…

A: Answer is power flow analysis

Q: find the average power delivered to each of the passive elements. verify the answer by calculating…

A:

Q: A 8µFcapacitor is connected in series with a 1260 resistor. The total current of the circuit is…

A:

Q: (a) Efficiency when supplying half full load at a power factor of 0.7. (b) Load corresponding to…

A:

Q: The real efficiency of the best commercial wind turbine is _than that of a solar cell. O a. equal O…

A: Real efficiency of best commercial wind turbine is more than that of solar . Because of wind turbine…

Q: Determine the power angle in the series circuit which consists of R = 25 ohms, L = 0.959 H and C =…

A: Given that R=25 ohmC=959 μFL=0.959 HV=200 voltsf=30 Hz calculate capacitive and inductive reactance…

Q: A certain solar array consists of four 12 v250 modules connected in parallel. The short cireuit…

A: Given Data: Power = 250 W Voltage = 12 V

Q: Across a 230v, 60Hz power supply is a 15 ohm non-inductive resistor. What is the equation of the…

A: We need to find out current through resistor for given voltage .

Q: thso v Compute the value of equivalent or total resistance at termina tiso v 180 V F

A:

Q: If the impedance of the circuit is 500 and the resistance is 80. Find the power factor.

A: In AC circuits, the power factor is defined as the ratio of Active power to Apparent power. It is…

Q: DC CIRCUIT IN SERIES NUMBER 6 amps Current flow, direction Internal Resistance 36 V 15 ohms…

A:

Q: Find the effect of all sources on the 1 ohm

A:

Q: Considering the energy conservation law, answer the following question using the diagram bellow:…

A: Here, given value of current is negative so current direction will be changed. In the given circuit…

Q: Commercially available PV panels today have efficiencies closest to about : A_20% B_50% C_1% D90%

A: In this answer we will try to understand what is a PV panel and how its efficiency is affected and…

Q: Three coils each having resistance of 25 n are connected in star across 415 V, 50 Hz supply. Then…

A:

Q: In the circuit shown in figure, when the firing angle of thyristor T is 90 degree, what is the value…

A:

Q: Solve for the Magnitude and direction of current on the 1 ohm resistor 42 252 20V

A:

Q: Three coils each having resistance of 17 Q are connected in star across 415 V, 50 Hz supply. Then…

A: The power consumed in a 3 phase circuit is  P=3Vl2R=3Il2.R Vl = 440 volt R=17 ohm

Q: In wattmeter, the coil connected in parallel is called.........................................?

A: In wattmeter, the coil connected in parallel is called

Q: Three coils each having resistance of 14 N are connected in star across 407 V, 50 Hz supply. Then…

A: Given, Line voltage, VL= 407 V so, phase voltage, Vph= 234.98 V Resistance, R= 14 ohm

Q: 21v 92 10 20v Figure Q5 Using a circuit analysis technique with which you are familiar, determine…

A: Here it is asked to get all the current values passing through the resistors. Here KCL has been used…

Q: Determine the electric current that flows into the circuit in the Figure below. a.-1.6A b. 1.6A c.…

A: Given, The circuit is,

Q: In figure below, The potential across the resistor is equal to: L 650 mH 120 V 60 Hz R472 :1pF

A: In parallel connection voltage is equal among all branches.

Q: In DC and AC circuits, power is measured using an Ammeter Select one: O True O False

A: The given statement is false.

Q: 5. A coil takes a current of 4 A when 24 V d.c. are applied and for the same power on a 50-Hz a.c.…

A:

Q: EMF in a circuit is ____. a. Cause current to flow b. Maintains potential difference c. Increases…

A: Basic network problem... Look below the explaination..

Q: 100 V/60 Hz/0 Deg +) I, 50 uF 35 Ohm 120 VI60 Hz/30 Deg 60 mH 50 Ohm I, 100 uF I; V 10 Ohm 130 uF 15…

A: This is a basic problem of circuits  The calculation can be done by using Kirchoff’s current Laws…

Q: Apply source tranformation to simplify the circuit ane determined the power absorbed by 52 resistor.

A:

Q: An alternating voltage e= 120 sin 314t is applied to a circuit in which an ohmic resistance of 30ohm…

A:

Q: Referring to circuit below, Determine: the value of the indicated current 'T'. . the potential…

A:

Q: . Calculate the load power for the circuit Vs 120 Vac RL 300 N

A:

Q: 10k What are the component using in circuit? IDEAL

A:

Q: Thirty (30) units of 200 watts, 250 V incandescent bulbs are connected in balanced delta across a 3…

A:

Q: Given the following Resistances, Inductors and Voltage Source are parallel to one another:…

A: Given:

Q: It is the AC Power that is neither consumed in the circuit nor does it do any useful work; it merely…

A:

Q: 1Ω 4 Α 1Ω

A: The equivalent resistance seen from the 4A current source:

Q: Problem 15: Determine the power absorbed by the dependent source in the circuit below 4 kN 2 VA 1 kN…

A: Nodal analysis is an important method to solve big and complex circuits. It is based on Kirchoff's…

Q: Si IR Vo +12 Vo 1.8 V Ip 680 N

A:

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.