Using the steam tables, determine the amount of coolimg water needed by a condenser in kg/sec if wet steam comes into the condenser at P= 610.44mmHG vac and 99.47% moisture, mass flow rate= 7200 + (100 (value of x) /25 (value of SN)) kg/hr. Cooling water enters the condenser at 12 deg C and leaves at 21 deg C. Answer: ___ B. Draw the schematic diagram if the condeser and process in the PV and TS diagram. Cp H2O= 4.187 KJ/(kg-K) The value 100/25 signify X/SN

Using the steam tables, determine the amount of coolimg water needed by a condenser in kg/sec if wet steam comes into the condenser at P= 610.44mmHG vac and 99.47% moisture, mass flow rate= 7200 + (100 (value of x) /25 (value of SN)) kg/hr. Cooling water enters the condenser at 12 deg C and leaves at 21 deg C. Answer: ___ B. Draw the schematic diagram if the condeser and process in the PV and TS diagram. Cp H2O= 4.187 KJ/(kg-K) The value 100/25 signify X/SN

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter22: Condensers

Section: Chapter Questions

Problem 7RQ: When a standard-efficiency air-cooled condenser is used, the condensing refrigerant will normally be...

See similar textbooks

Similar questions

The typical temperature relationship between a standard-efficiency air-cooled condenser and the ambient temperature is A. 50F. B. 40F C. 30F. D. 20F.
An electrostatic precipitator is the same as A. an extended surface air filter. B.a fiberglass media filter. C.an electronic air cleaner. D. a washable steel air filter.
What is the heat output, in Btu/h, of a terminal unit with a T of 10F and a water flow rate of 5 gpm?
Welded ______sealed compressors are normally used in household refrigerators.
The condensing pressure is 260 psig and the condenser outlet temperature is 108F for R-22. By how many degrees is the liquid subcooled in the condenser? A. 12F B. 42F C. 7F D. 14F
Define a near-azeotropic refrigerant blend, and give twoexamples.
Why are there more safety precautions for R-410A than with other popular refrigerants like R-22 and R-404A?
Why is a circulating brine system more attractive for ship refrigeration than individual evaporators?
When a standard-efficiency air-cooled condenser is used, the condensing refrigerant will normally be higher in temperature than the entering air temperature.
Why is two-stage compression popular for extra-low-temperature refrigeration systems?
The condensing pressure is 260 psig and the meteringdevice inlet temperature is 100F for R-22. What is the total subcooling in this system? A. 15F B. 20F C. 25F D. 30F
The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40 °C and an evaporating temperature of -4 °C shows a refrigeration capacity of 96.4 kW. At this operating points the motor (whose efficiency is 90 percent) draws 28.9 kW. The bore of the cylinders is 87 mm and the piston stroke is 70 mm. The performance data are based on 8 °C of subcooling of the liquid leaving the condenser. Compute 3.1 the actual volumetric efficiency and 3.2 the compression efficiency.