V = 20V %3D I = 1A $ = 30° %3D

Q: A professor created the circuit shown in the figure for her lab. Assuming E = 7.70 V and R = 5.00 N,...

A: The circuit diagram is shown below: (a) Applying K.V.L in loop 1 of the given circuit, Applying K....

Q: A ower system is operating at 1000Mw, 132kV, 50Hz, with 0.8 p.f. laging in parallelwith another line...

A:

Q: Find the quality factor of an antenna if it has a bandwidth of 600 kHz and is cut to a frequency of ...

A: The quality factor of the antenna is defined as the measure of the radiation efficiency of the anten...

Q: Q3: A unity feedback control system has K G(s) s(s + 2)(s+5) Sketch the root locus and show on it (a...

A: Part (a): Consider the open-loop transfer function,

Q: What causes of reflactive in transmission line?

A: Sometimes when the transmission line is connected to the antenna, a part of the power is reflected b...

Q: PLZ SOLVE IT URGENTLY

A: Circuit diagram is given as ; For finding Thevenin equivalent thevenin voltage and thevenin impedan...

Q: For a generator differential relay, protecting the three phases by only 1 relay, Im-0.01 A, I.RN =0....

A: Given values are =

Q: what are some vital parameters to be considered when siting a consumerunit/distribution board.

A:

Q: Q4: a) A In center tape FWR circuit ,R=9002,V,=150Volt ,f=60H .Draw output wave form, then find Vac,...

A:

Q: Calculate the bandwidth of an antenna having a cut off frequency of 110 MHz and a quality factor of ...

A: For any radiating antenna system, the bandwidth (B) is related to the cutoff frequency (fc) and the ...

Q: For a parallel RLC circuit operating under initial conditions only:a) Give detailed discussion of di...

A: The parallel RLC circuit having only the initial condition, Parallel circuit has three type of respo...

Q: Electrical Engineering Question

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: Answer b and c

A:

Q: Give the reason why a dielectric material increases capacitance compared with what it would be with ...

A:

Q: c) A single phase 25 kVA, 1200/120 V, 60 Hz distribution transformer has the following parameters; R...

A: Please note: subscript '1' in the given problem express as subscript 'p' in figure same case for '2'...

Q: What is the minimum logic swing V required foran ECL gate to have a noise margin of 0.1V at roomtemp...

A: The noise margin can be expressed as  

Q: Apply the Norton theorem on following network to determine the current (Ix) flows through the load r...

A:

Q: Explain what carrier mobility is and elaborate on the factors that influence carrier mobility.

A: Carrier mobility - Carrier mobility is a parameter which gives information that how rapidly an elect...

Q: Find the power absorbed by resistor

A: Mark the voltage V in the given circuit as shown below:

Q: Rioad load Rioad Vs(t) + Vs +, BLioad source load source load An electric dryer with an equivalent s...

A:

Q: A Y-Y three-phase system has a source of 380 V and a load of impedance of 6+j5 Ohm/phase through a t...

A: Line voltage is given, For star connected network line voltage is  times of phase voltage. Therefor...

Q: Project 2 In the Wheatstone bridge circuit of Fig. below select the values of resistances RI, R3 and...

A: The following figure shows the general Wheatstone bridge.

Q: PROBLEM 5: In the circuit shown, A. Find the currents I,, 12, and Iz in the circuit using Kirchhoff'...

A:

Q: a unity feedback control system has ?(?) = ?/ ?(? + ?)(? + ?) sketch the root locus and show on it (...

A:

Q: What’stheantenna? What’sitsroleinwirelesscommunicationsystems?

A: In the wireless communication system, an antenna is an electrical device that is used to convert an ...

Q: An uncharged 0.2 μF capacitor is driven by a triangular current pulse. The current pulse is describe...

A: Write the expression for the current at different intervals.

Q: Q2) A) Express the decimal number (- 30 ) as an 8-bit number in 2's complement form, and verifying i...

A:

Q: R2-360ohm R3-720ohm R4-1200ohm C4-1.2Mf

A: Considering the bridge is balanced then the product of the impedance opposite to each other will be ...

Q: A three-phase synchronous generator is being used as a source of power for a farm in a remote area o...

A: It is given that the configuration of the alternator is a star. The per-phase open-circuit voltage i...

Q: The measured AC power represents the of the power waveform * Peak value O Average value rms value O

A: The measured AC power represents the RMS value of the waveform. The power output of the circuit:

Q: 10 k2 D2. +10 Vo WN D1 5 k2 -10 V Fig (5)

A:

Q: You are given a spotlight which takes 2 amperes of current designed to work off a 6-volt battery. If...

A: Current taken by spotlight is Spotlight is designed to work at 6 V. Equivalent circuit will be,

Q: An ideal transformer having 50 turns on the primary and 1250 turns on the secondary is connected to ...

A:

Q: A parallel circuit contains four branches. One branch has a current flow of 0.8 A, another has a cur...

A:

Q: | For a continuous time x(t) = 214, find out the Fourier transformation of x(t).

A:

Q: determine transfer function for 2nd order RC lpf in the same way stated in the book

A: To determine the transfer function for the second-order low-pass filter in the same above as mention...

Q: Q1: a) P-types silicon sample is 0.2cm long and has a rectangular cross section 0.03cm² .The accepte...

A: In the P-type silicon sample, the acceptor concentration is equal to the hole concentration. Thus,

Q: For this amplifier circuit, the amplifier has lower frequency of 10KHZ and high frequency of 100KHZ....

A: Note: As per our honor code, we are authorized to answer up to 3 sub-parts, we’ll answer the first 3...

Q: tract the simplified formula for X from the following circult. The answer should be in terms of A B....

A:

Q: Q- Write down the spectral Comparison of ASK,PSK,FSK and QAM. Which technique is expensive in terms ...

A: Write the bandwidth for all types of modulation schemes.

Q: a 220v, 500A,600r/min,separately excited dc motor has armarture and field resistance of 0.2 and 10 o...

A:

Q: A 80 V rms is stepped down to 18V rms by a transformer. The output from the transformer is rectified...

A:

Q: R1 = 50 ohm R3 R2 RI R2 = 25 ohm I2 El = 5 volt R3 = 75 ohm E2 E2 = 4 volt [Q3] Analyze the followin...

A: Given values are = Given circuit is =

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).