value of the pressure coefficient for an airplane flying at 170m/s in air at 2
Q: Students conducted an experiment to evaluate the velocity profile,u(y), of a fluid flowing over a…
A: Obtain a relation of shear stress and wall shear stress in terms of a and b using the appropriate…
Q: What is the pipe velocity at point 1? Given the specific gravity of pink liquid S=3.9 and height…
A:
Q: plain the velocity and pressure behavior of the fluid through venturi. Also explain how to measure…
A: given: Explain the velocity and pressure behavior of the fluid through venturi. Also explain how to…
Q: 3- Fluid flow between two horizontal infinite parallel plates with a spacing of H mm shown in figure…
A:
Q: A 10 cm conical pointed shaft turns in a stationary conical bearing with an angular velocity of 5…
A:
Q: Water flows through a pipe having an inner radius of 10 mm at the rate of 36 kg/h at 25°C. The…
A:
Q: An incompressible fluid flows between two infinite stationary parallel plates. The velocity profile…
A:
Q: The velocity in a certain flow field is given by the equation below, V = (x² - y²)ī — 2xyj Show that…
A:
Q: Q2) A layer of water flows down an inclined fixed surface with the velocity profile shown in Fig.…
A: The property of fluid due to which it resists the flow of fluid layer one above the other is known…
Q: three reservoir systems given below, where local losses are neglected. How many meters is the…
A:
Q: B) The laminar flow velocity profile in pipe for Newtonian fluid is given by: U₂ = 2a [1-()], where…
A: GivenNewtonian fluidUx=2u¯1-2rd2where Ux is point velocity r is radial position
Q: What is meant by the term “velocity of circulation” and explain its relevance in the quantity…
A: The quantity of money circulating in the economy during a specific time period is known as the…
Q: Water is flowing out of a horizontal pipe at a rate of 1.9 L/s at a temperature of 25°C. The…
A: Given:Discharge, Q=1.9 Ls-1 =1.9 * 10-3 m3s-1T= 25o Cμ= 1.2*10-3 pa-sPinlet = patm + Pgauge…
Q: 1. Explain laminar boundary layers and ability to formulate energy equation in a pipe flow system.…
A: Laminar boundary layer
Q: In a stream of glycerine in motion, at a certain point the velocity gradient is 0.25 meter per sec…
A:
Q: What is the kind of stress applied on the illustration which has caused the fluid to create a…
A: From above figure we get to know about the flow development between two plates. This kind of flow is…
Q: A plate 0.05 mm distance from a fixed plate moves at 2.2 m/s and requires a force of 2.2 N/m² to…
A:
Q: The no-slip condition, pressure force is a component of the molecular stress tensor. O A. vanishing…
A:
Q: In order to measure the air speed in a pipe of radius R, you construct a device which tapers the…
A:
Q: s airflow passes through a normal atic pressure (1), density (ii), and M (i) decrease (ii) increa se
A: Shock is an abrupt flow field discontinuity that happens when the local flow speed surpasses the…
Q: The P-35 experiences a certain dynamic pressure at its cruising speed of 114.2 m/s at an altitude…
A: Given Data: Altitude h = 4 km. Cruising velocity v= 114.2 m/s. The density of air at 4 km altitude…
Q: A large artery in a dog has inner radius of 4.0 x 10-3 m. Blood flow through the artery of the rate…
A:
Q: Q1\ A crude oil of viscosity 0.85 poise and relative density 0.7 is flowing through a horizontal…
A:
Q: Q1: An oil (u = 0.083 N.sec/m2) flows between two inclined fixed and parallel plates %3D 6mm and 1…
A:
Q: 1) The velocity profile of a viscus fluid over a plate is parabolie with vertex 25 cm from the plate…
A: Given data: The distance between vertex and plate is, 25 cm The velocity of fluid at the vertex is,…
Q: The velocity distribution for the flow of oil with dynamic viscosity of 0.05 Pa-s is given by…
A: Given data: ● The dynamic viscosity of the oil: µ = 0.05 Pa•s ● The velocity distribution is given…
Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…
A:
Q: A viscous liquid with a density p = 1.8 slug/ft³ and a kinematic viscosity v = 10+ ft²/s flows…
A:
Q: 1. Describe and illustrate laminar flow and turbulent flow.
A: Dear student, According to the guidelines I am allowed to answer only one…
Q: Q2. The laminar flow of a Newtonian fluid between parallel plates is illustrated in the below…
A: Write the given expression of velocity distribution and then differentiate it.
Q: Q: Consider water flows between two parallel fix plates at 20C (dynamic viscosity =0.001 Pa.s). The…
A: Given data dynamic viscosity = 0.001 Pa.s velocity distribution = u = 10 ( .01Y-Y2)where Y is in…
Q: B) The laminar flow velocity profile in pipe for Newtonian fluid is given by: ux = 2ū [1-(2)²],…
A:
Q: Consider the laminar flow of an incompressible fluid over a flat plate at y-0.
A:
Q: Provide an example list of Laminar and Turbulent Flow.
A: ● Laminar flow is a smooth flow which flows without any interference or intermixing of fluid layers…
Q: Given that: • Pipe diameter: 0.450 m Crude oil: Kinematic viscosity = 0.0000232 m2/s Water: Dynamic…
A:
Q: The uniform velocity ‘U’ of water flowing in a pipe at 70 oF is 79 ft/s. Figure out the following…
A: Given data:
Q: Briefly explain the shear stress and velocity profile for turbulent flow
A:
Q: Consider the incompressible viscous flow of air between two infinitelylong parallel plates separated…
A:
Q: The radius of the blood vessel is 0.9 cm with a viscosity and density of 0.004 kg/(m-sec) and 1010…
A:
Q: Q1/Consider a fluid flow between two parallel fixed plates 5 cm apart, as shown in Fig. (1).The…
A:
Q: A sound wave is observed to travel through a liquid with a speed of 1290 m/s. The specific gravity…
A: Given that: Speed of sound in a liquid is 1290 m/s Specific gravity of the liquid is 1.5 It is…
Q: B) The laminar flow velocity profile in pipe for Newtonian fluid is given by: u₂ = 20 [1-(²) Ux…
A:
Q: P = Patm 1 Vị = 6.9 m/s Flow h = 0.89 ft water 3 Density of water = 1000 kg/m³ Determine the…
A: Given P1=Patm=101325 PaV1=V2=6.9 m/s h=0.89 ft = 0.24384 m ρ=1000 kg/m3 To find Pressure at point…
Q: 3. Air is flowing parallel to the plate at U=5 m/s and T.=F300 K over the flat plate of length L=0.1…
A: givenvelocity of air U∞=5m/stemperature of air T∞=300Klength of plate L=0.1mdepth d=1m
Q: Q1/ A 120 mm disc rotates on a table separated by an oil film of 1.8 mm thickness. Find the…
A: As per the guidelines of BARTLEBY we are subjected to solve only one question at a time. Please…
Q: A pipe delivers grape juice to a 1.5 m diameter tank. Another pipe (5 cm in diameter), located near…
A: Given data: Dexit=0.05 mH=2.5 m
What is the critical value of the pressure coefficient for an airplane flying at 170m/s in air at 2 deg C?
Step by step
Solved in 2 steps with 2 images
- Q. 6 A 4.5-cm wide space between two plates is filled with SAE 30W lubricating oil at 26.7°C (Hoil = 0.301645 N.S/m2 ). What is the area of a very thin plate which is dragged by a force of 18 N through the oil at velocity of 16 m/min if the plate is 1.5 cm away from one of the fixed surfaces?a scaled tank cintaining sea water to a height of 12m also contain air above the water at gage pressure of 5 atm, water flow out from the bottom through a small hole. calculaye the efflux speed of the water, psw = 1.03x10 kg/mThe pressure-density relation for ethanol is approximatedby Eq. with B =1600 and n = 7. Use this relation toestimate the speed of the sound of ethanol at 2000 atmospheres.
- Consider a commercial airliner flying at a speed of 540 mph (relative to the air) at analtitude of 30,000 feet. (c) With a mean molar mass of M = 28.9 g/mol, determine the Reynolds number andMach number in flight. Justify your choice of characteristic length by referencinga commercial aircraft currently in service.(d) Is this flow inviscid or viscous? Is this flow subsonic or supersonic? Qualitativelydescribe the differences between these flight regimes.An oil drop has a density (?1) of (560+R) kg/m3. The terminal velocity of a spherical drop of thisoil falling in air at the room temperature is (15 + R) cm/s. At the room temperature, air density(?2) is 1.2 kg/m3and its viscosity is 18 μPa.s. Find the radius of the droplet. Consider g =9.81 ??Consider air flowing past a hemisphere resting on a flatsurface. If the internal pressure is pi, findan expression for the pressure force on the hemisphere. At what point A on the hemisphereshould a hole be cut so that the pressure force willbe zero according to inviscid theory?
- Calculate the air velocity at ports 1 and 2 if the water column pressure difference is 8.5 cm. Air and water have densities of 1.25 kg/m3 and 1000 kg/m3, respectively.Consider an air solar collector that is 1 m wide and 5 m long and has a constant spacing of 3 cm between the glass cover and the collector plate as shown in Figure below, Air flows at an average temperature of 45°C at a rate of 0.15 m/s through the 1-m-wide edge of the collector along the 5-m-long passageway. Disregarding the entrance and roughness effects and the 90° bend, determine the pressure drop in the collector.Estimate the speed of sound of carbon monoxide at 200-kPa pressure and 300°C in m/s.
- Derive an expression for the capillary- height change h, as shown, for a fluid of surface tension Y and contact angle 0 be- tween two parallel plates W apart. Evaluate for water at 20°C if W = 0.5 mm.Air at Ma1 = 2.0 and p1 = 100 kPa undergoes an isentropicexpansion to a downstream pressure of 50 kPa. What is thedesired turn angle in degrees?An oil gusher shoots crude oil 23.0 m into the air through a pipe with a 0.100 m diameter. Neglecting air resistance but not the resistance of the pipe, and assuming laminar flow, calculate the pressure (in N/m2) at the entrance of the 45.0 m long vertical pipe. Take the density of the oil to be 900 kg/m3 and its viscosity to be 1.00 (N/m2) · s (or 1.00 Pa · s). Note that you must take into account the pressure due to the 45.0 m column of oil in the pipe.