Vapor absorption cycle and Plant (detailed).

Q: What is regenerative steam condenser? Explain with a simple diagram.

A: The answer is given below

Q: Choose the valid statement about ideal vapor compression refrigeration cycle Select one: O a. Heat…

A:

Q: In simple and clear explanation. What is polygeneration system in refrigeration systems?

A: The polygeneration system is used in refrigeration for more efficient cooling . There is no specific…

Q: A turbine receives steam at 8.5 MPa, 400°Cwith condensing pressure of 0.06 MPa. Determine the Cycle…

A:

Q: A turbine receives steam at 8.5 MPa, 400°Cwith condensing pressure of 0.06 MPa. Determine the Cycle…

A:

Q: A Cascade refrigeration system using flash tank and intercooler is operating an evaporator with a…

A: Schematic Diagram

Q: 10. Explain the benefit of power factor in material in a thermoelectric.

A: The thermoelectric effect is the transfer of temperature variations to electric voltage and back…

Q: How does a shell-and-coil condenser remove heat from the refrigerant?

A: Condenser is the type of heat exchanger which is used to remove heat from the refrigerant.…

Q: How is regenerative thermal oxidizer (RTO) different from traditional thermal oxidizer?

A: A thermal oxidizer or a thermal incinerator or afterburner is an air pollution control process unit…

Q: the highest pressure of water in the power plant cycle is located a. after the boiler b. at the…

A: Given: The highest pressure of water in the power plant is at the.......

Q: • A SIMPLE SATURATED REFRIGERATION CYCLE FOR R 12 SYSTEMS OPERATES AT AN EVAPORATING TEMPERATURE OF…

A:

Q: In a two stage compression with intercooling and flash gas removal design, the evaporator pressure…

A: The intermediate pressure: Pintermediate = 500 kPa

Q: 02. The Li-Br water absorption cycle operate at the following temperature: generator temperature =…

A: Generator Temperature, Tg = 90℃ = 363KCondenser Temperature, Tc = 35 ℃ = 308KAbsorber Temperature,…

Q: How does the Steam Pressure relates Steam Temperature in the boiler?

A: Steam pressure and steam temperature are directly proportional. As we know that in presence of…

Q: What is the ideal reheat Rankine cycle

A:

Q: Heat accepted by evaporator is 4500 W. Determine the heat rejected by condenser if COP=5?   a) 5400…

A:

Q: 30°C. The flow rate o

A:

Q: In the Benson boiler given below, what is A?

A:

Q: The LiBr-water absorption cycle shown in Fig. 17-2 operates at the following temperatures:…

A: Find the concentration of Li-Br in the generator Tg=100°C Tc=55°C Te=10°C Ta=30°C

Q: (i) List the name of the four processes in a generic Carnot cycle and state what type of energy…

A: Carnot cycle : A Carnot cycle is a theoretical perfect thermodynamic cycle suggested by Sadi Carnot,…

Q: The figure to the right gives the schematic of an air conditioner cycle that steadily circulates…

A:

Q: 330 MW steam power plant operates according to the simple ideal Rankine cycle. Water vapor enters…

A: Given Data Turbine Inlet:10 MPa,525°C Condenser pressure:15 kPa P=330 MW

Q: Explain ideal reheat regenerative cycle and actual reheat regenerative cycle

A: Reheat regenerative cycle is heat cycle in which there is bot regenerative heating and reheating of…

Q: What is the mass flow rate flowing through the boiler?

A:

Q: Question # 04 a. Explain Why steam Condenser is used in steam power plant b. Draw the block diagram…

A: Understand the following block diagram for the simple steam cycle power plant. If the condenser was…

Q: What is the major difference in the way water is heated in firetube and watertube boilers?

A: The boiler in which water flows inside the tube, and hot gases flow outside the tube, is called…

Q: QI) Steam is supplied to a turbine at 30 bar and 350°C. The turbine exhaust pressure is 0.08 bar.…

A:

Q: The type of condenser in which the steam and cooling water flow from top to bottom and mix is called…

A: Condenser is a mechanical device that exchanges heat and condenses the vapour into a liquid state by…

Q: ideal reheat regenerative Rankine cycle

A: Fig:TS diagram

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A:

Q: 3. Steam is supplied to a two-stage turbine at 170 bar and 600°C. It expands isentropic ally until…

A: Given: T1 = 600 C P1 = 170 bar T3 = 500C P4 = 0.2 bar isentropic efficiency = 80%

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A: It is required to determine pressure at state 5

Q: The catalog for a refrigerant 22, four cylinder, hermetic compressor operating at 29 r/s, a…

A: Using the properties of the R-22 table  At -4°C evaporating temperature (State-1) Enthalpy at state…

Q: refrigerant flow and distribution. c. Explain in details the analysis behind the diagram

A:

Q: Waters enters the condenser at 20°C and leaves at 35°C. what is the log mean temperature difference…

A: GivenTC1=20oCTC2=35oCTh1=Th2=45oC

Q: Compare the throttling processes happening at the following two locations in the steam power plant…

A:

Q: Why are there more safety precautions for R-410A thanwith other popular refrigerants like R-22 and…

A: There are different types of refrigerants present in the refrigeration engineering. Some of them are…

Q: Explain the heat transferred from a furnace (Q) to convert the boiler feed water at 25 ° C into…

A: Given data  The initial state  =  liquid  initial temperature = 25oC Final state = superheated steam…

Q: A refrigeration system using refrigerant 11 is to have a refrigerating capacity of 80 kW. The cycle…

A: Given Data Refrigerant R-11 Te= -15°C Tc=30°C

Q: Explain the open and bepped gas turbine cycle with the headlight on a.  Besides the intended use of…

A: A closed-cycle gas turbine can be characterized as a gas turbine, which overcomes the…

Q: While discussing the reaction by a refrigerant to heat:

A:

Q: The isentropic efficiency of the turbine and the pump is 90%, the steam flow circulating in the…

A:

Q: An NH, vapor compression refrigeration system has a condensing temperature of 25°C and an…

A: 1-2 :- isentropic compression process(Compressor) 2-3 :- isobaric heat rejection…

Q: 1.What is the difference between the Water Tube Boiler and Fire Tube Boiler ?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A: It is required to determine specific enthalpy at state 3

Q: At lower condenser pressures, the moisture content of the turbine exhaust steam

A: It is required to determine the effect of lowering condenser pressure on the moisture content of the…

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A: Given: P3=48 barT3=400°CT5=400°CP6=0.04 bar

Q: A reheater cycle is executed of 1 kg steam expanding initially from 12.546 Mpa and 540.546oC. The…

A: