Vrite the mechanism of the following reaction? 1. NABH4 2. H20 OH

Q: Save Answer You are trying to determine the identity of an unknown compound using its melting point,…

A: Melting point of unknown matches with many Compounds , so we couldn't conclude about unknown from…

Q: You are asked to determine the alkali present and the percentage of each in a component of a sample…

A: To find the alkali present and and the percentage of NaOH, Na2CO3 and NaHCO3 in the sample 4.

Q: /hich of the following reactions would yield isopropylbenzene as the major product? DA. CH,-CHCH3…

A:

Q: Calculate the standard entropy change for the reaction at 25 °C. Standard molar entropy values can…

A: Given, MgCl2(s) + H2O(l) ⟶ MgO(s)+ 2HCl(g) Standard entropy (S°) MgCl2(s) = 89.62 J/mol.K H2O(l) =…

Q: Here are sketches of four electron orbitals: 00 A C D yes Are any of them s orbitals? O no List the…

A:

Q: QUESTION 35 How many moles of potassium sulfide in 27.6 grams of Potassium Sulfide, K2S ? O 110, mol…

A: For question 35, we have to find the number of moles of K2S present in 27.6 grams of K2S. For…

Q: Calculate E° cll from the tabulated standard reduction potentials for each of the following…

A: In the given reaction MnO4- is getting reduced while Fe+2 is getting oxidised.

Q: mportant values if needed for this question. The decomposition of dinitrogen pentoxide in carbon…

A:

Q: When the rate of a reaction changes by a substantial amount (factor of 2 or more) when the…

A: The rate of reaction is defined as the speed at which a chemical reaction progresses.

Q: 2 Fe(s) → 2 Fe2*(aq) + 4 e 02(g) + 2 H20(t) + 4 e-4 OH (aq) Moisture Anode reaction Cathode reaction…

A: The rusting reactions given are,

Q: Use the data from this table of thermodynamic properties to calculate the values of Δ⁢Srxn∘ for each…

A: a) 2CO(g) + O2(g) ⟶ 2⁢CO2⁢(g) Standard entropy (S°) CO(g) = 197.674 J/mol.K O2(g) = 205.138 J/mol.K…

Q: If the order of the reaction is first order for both reagents then using the rate law and the…

A: From the given information about order , we would first write rate law expression for this reaction.…

Q: Exactly 10.5 mL of water at 33.0 °C is added to a hot iron skillet. All of the water is converted to…

A:

Q: 6. Draw the structure for compound A and for compound B in the following synthetic sequence. 1) Mg.…

A: In this question we have to tell the product of the reaction.

Q: You are asked to determine the alkali present and the percentage of each in a component of a sample…

A:

Q: You are trying to dissolve ZnS (pKb = 2.5 x 10-22) in an aqueous solution. The dissolution enthalpy…

A:

Q: d) lon flow e) Cathode-Anode f) Standard Cell voltage g) “+" and “_“ posts NilNiCl2…

A: The oxidation of Ni occurs to form Ni2+ while reduction occurs for Al3+ to form Al. The half cell…

Q: A corrosion cell consists of copper(Cu) with an sheet area of 250cm2 and the density of the current…

A: Given: Surface area of Cu = 250 cm2  Surface area of Fe = 25 cm2  And current density passing = 0.5…

Q: c. Show the mechanism for the initiation and propagation steps using the molecules below. Then show…

A:

Q: Which pair of compounds would be synthetically useful when treated with NaOH? Сно

A:

Q: A 25.00 mL sample of magnesium hydroxide solution is titrated with 0.00500 M HCl and 2 drops of…

A:

Q: 6. How many different types of clectronic transitions for absorption by organic compounds? What are…

A:

Q: Draw the major product(s) that result from the following reaction. Do not draw inorganic side…

A:

Q: Suppose an AM talk radio station broadcasts radio waves with a frequency of 730. kHz. Calculate the…

A: The energy of the radiation is quantized and the energy of one photon is given by: Where, h =…

Q: What is the predicted Van't Hoff Factor for li2O?

A: I

Q: Identify the degree of substitution for the labeled carbons. Answer labels 1 to 10.

A:

Q: The equation of the line for an Abs vs. [FESCN^2+] plot was determined to be y=4462.2x - 0.00329.…

A: Given that, Abs vs [FeSCN2+] plot y=4462.2x - 0.00329  And absorbance for unknown concentration was…

Q: A 0.765-gram sample of impure potassium chlorate KClO3was decomposed by thermal decomposition into…

A: Given: Total pressure of gases = 777 mm Hg. Volume of gas = 222.50 mL = 0.22250 L…

Q: Given the reaction: 2Fe(s) + 3C12(g) --> 2FECI3(s) What is the oxidation state of the product iron?…

A: What is the oxidation state of Fe in FeCl3 ?

Q: 2. What is the product of reaction of the alcohols below with Jones Reagent (HO-CrO2-OH plus H,SO,…

A:

Q: An 8.00 gram sample of the hydrated salt, CoCl2 x XH2O was thermally decomposed into anhydrous…

A: Given: Mass of hydrated salt = 8.00 g. And the mass of anhydrous salt obtained = 4.370 g.

Q: Instruction for nos.1 and 2 a. Look for the elements that change its oxidation state, label the…

A: Write oxidation number changes, which species is oxidized and which one reduced and also identifying…

Q: What is the normality of 0.0824M H3PO4H3PO4? Type only the numerical value in three significant…

A:

Q: 3. Show the steps necessary to transform the acid on the left into the compound on the right. Be…

A:

Q: (b) The reaction (R)-2-chloro-3-methylbutane with KOH shown below, resulted in a mixture of three…

A:

Q: .) ion-ion interactions are stronger than the ion-dipole interactions because the UM has a lower…

A: PEC diagram is given for barium hydroxide.  We have to determine the relative interaction strengths.

Q: For a particular reaction, Δ?∘=−28.4 kJ/mol and Δ?∘=−87.9 J/(mol⋅K). Assuming these values change…

A: Given: ΔHo = -28.4 KJ/mol = -28400 J/mol. And the value of ΔSo = -87.9 J/mol.K.

Q: What will be the solubility of Fe(OH)3 (Ksp in a solution buffered at pH 8.00? = 1.60x10-39) (Hint:…

A:

Q: A corrosion cell consists of copper(Cu) with an sheet area of 250cm2 and the density of the current…

A: Given: Surface area of Cu = 250 cm2  Surface area of Fe = 25 cm2  And current density passing = 0.5…

Q: If the standard reduction potential for Copper is 0.34V, calculate the reduction potential for…

A: given, standard reduction potential of copper = 0.34 V

Q: Which of these can be rinsed down the sink? the left over liquid from a distillation of 1-butanol…

A: To identify: The solution that can be rinsed down the sink.

Q: One kmol of CO is heated to 3500 K at a pressure of 2 atm. What percentage of the original CO, is…

A:

Q: C Metallic Tanta C The Substance C The Substance C The Substance C Which Of The C Get Homewor O 8…

A: PNI2 is made of phosphorus nitrogen, iodide compound.

Q: Calculate the pH of a 0.654 M solution of an acid with Ka = 2.33 x 10-5.

A:

Q: Band theory uses molecular orbital theory to describe the bonding in metals and other solids.…

A: Conductors are substances that are good conductor of heat and electricity. Insulator is material…

Q: LOH H,C O=ら=0

A:

Q: A cylinder is filled with 10.0 L of gas and a piston is put into it. The initial pressure of the gas…

A:

Q: Chemistry Yes or No: Topic - HPLC 1.We need the void time so that we have a measure of the retention…

A: 1. We need the void time so that we have a measure of the retention factor for use in the…

Q: What other metals we can detect with Spectroscopic analysis?

A: Heavy metals ions like lead(Pb2+), cadmium(Cd2+), zinc(Zn2+), arsenic(As2+), mercury(Hg2+) etc. can…

Q: OOther Bookmarks [References Use the References to access important values if needed for this…

A: Here we are required find the order of reaction and the rate constant

Reactions of Ethers

Ethers (R-O-R’) are compounds formed by replacing hydrogen atoms of an alcohol (R-OH compound) or a phenol (C6H5OH) by an aryl/ acyl group (functional group after removing single hydrogen from an aromatic ring). In this section, reaction, preparation and behavior of ethers are discussed in the context of organic chemistry.

Epoxides

Epoxides are a special class of cyclic ethers which are an important functional group in organic chemistry and generate reactive centers due to their unusual high reactivity. Due to their high reactivity, epoxides are considered to be toxic and mutagenic.

Williamson Ether Synthesis

An organic reaction in which an organohalide and a deprotonated alcohol forms ether is known as Williamson ether synthesis. Alexander Williamson developed the Williamson ether synthesis in 1850. The formation of ether in this synthesis is an SN2 reaction.