Water (p = 999.1 u = 1.13 x 10-3 kg in a 6-m-wide rectangular channel at a m-s depth of 1 m and a flow rate of 10 m/s. Determine: (1) the Froude Number; (2) whether the flow is subcritical or supercritical; (3) critical depth, critical velocity, critical energy; (4) specific energy.

Water (p = 999.1 u = 1.13 x 10-3 kg in a 6-m-wide rectangular channel at a m-s depth of 1 m and a flow rate of 10 m/s. Determine: (1) the Froude Number; (2) whether the flow is subcritical or supercritical; (3) critical depth, critical velocity, critical energy; (4) specific energy.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Water flowing in a wide channel at a depth of 2 ft and a velocity of 40 ft/s undergoes a hydraulic…

A: Given data as per question Velocity of water = 40 ft/s Depth = 2 ft

Q: In a trapezoidal channel, if m=3, for the best hydraulic section, the ratio B=b/y should be equal:

A: Given data: The hydraulic mean depth, m = 3 For trapezoidal section the aspect ratio is given by:…

Q: The flow in an open channel is observed to have undergone a hydraulic jump. Is the flow upstream…

A: The hydraulic jumps are common in open channel flow and are classified into three types based on the…

Q: Consider water flow over a 0.80-m-high sufficiently long broad-crested weir. If the minimum flow…

A: Given Data: The total head is: H=0.8 m The downstream depth is: h2=0.5 m

Q: Water flowing in a wide horizontal channel approaches a 20-cm-high bump with a velocity of 1.25 m/s…

A: Given Data: The upstream velocity is V1 = 1.25 m/s The upstream depth of flow is y1 = 1.8 m. The…

Q: Water discharges into a rectangular horizontal channel from a sluice gate and undergoes a hydraulic…

A: Write the given data:

Q: Water is discharged from a 5-m-deep lake into a finished concrete channel with a bottom slope of…

Q: Show that the Froude number downstream of a hydraulic jump will be given by Fr, = 8" Fr./[(1 + 8…

A: The Froude number is given by the following equation,

Q: Q(1): A power canal of trapezoidal section has to be excavated through hard clay at least cost.…

Q: A clay tile V-shaped channel of included angle 60° isflowing at 1.98 m3/s on a slope of 0.33°. Is…

A: The flow rate for uniform flow is written as, It is also written as, It is near to the critical…

Q: During steady and uniform flow through an open channel of rectangular cross section, a person claims…

A: In an open channel flow, the specific energy can be determined with the algebraic sum of potential…

Q: Water is to be transported in a cast iron rectangular channel with a bottom width of 6 ft at a rate…

A: Given data: The bottom width of the channel is; b=6 ft. The flow rate of the water is; V˙=70 ft3s.…

Q: At what depth will water flow in a 4 m wide rectangular channel if n=0.018, S0=0.0009, and Q=7m^3/s?

A: Givenb=4 mn=0.018S=0.0009 Q=7 m3/s

Q: Water flows in a 9-m-wide rectangular open channel at a rate of 55 m3/s. If the flow depth is 2.4 m,…

A: Write the formula for Froude number in terms of flow depth, width, and flow rate for the given…

Q: Water, at 20°C, is flowing steadily in a 0.4-m- wide rectangular open channel, made of corrugated…

A: Here we haveb=0.4Q=0.2 m3/sy=0.15 mNow, A=bxy=0.4 x 1.5 =0.06 m2Flow velocity…

Q: The best hydraulic cross section for a rectangular open channel is one whose fluid height is (a)…

A: For a specific rectangular cross-section area in an open channel, the best hydraulic cross-section…

Q: Water is to be transported in an unfinished-concrete rectangular channel with a bottom width of 4 ft…

A: For the unfinished concrete rectangular channel, the manning constant is taken as, n=0.014 Let…

Q: 2) A venturi flume is placed near the middle of a long rectangular channel with Manning's…

A: The value of Manning's coefficient is n=0.012 m-1/3s. The width of the channel is w=5 m. The…

Q: 10. It is Known that: •Q = 18 m^3 / s • Rectangular channel, 3 m wide • Unfinished form concrete •…

A: When liquid flows at a high velocity in an open channel, the flow can become unstable, and minor…

Q: The flow rate of water in a 5-m-wide horizontal open channel is being measured with a 0.60-m-high…

A: Step-1 given Data width b=5m pw=0.60m water depth…

Q: Water flows half-full through a hexagonal channel of bottom width 2 m at a rate of 30 m3/s.…

Q: What is the significance of the Determination of the coefficient of discharge of a 90-degree…

Q: Water flows uniformly in a finished-concrete rectangular channel with a bottom width of 0.85 m. The…

A: Given Data: Bottom width of channel is b = 0.85 m. The flow depth is y = 0.4 m. Bottom slope is S0…

Q: Consider uniform flow through a wide rectangular channel. If the bottom slope is increased, the flow…

A: Solution:

Q: Consider steady flow of water in a downwardsloped channel of rectangular cross section. If the flow…

A: The hydraulic jump can occur in critical flow. y < yn Flow given is subcritical flow.

Q: A triangular open-channel (n=0.014) has a side slope of 2H:3V. The flow depth is 2m when the slope…

A: To find : The volumetric flow rate . Given : The flow depth is d=2 m. The slope is s=0.002. The…

Q: A triangular channel (see Fig. ) is to be constructed ofcorrugated metal and will carry 8 m3/s on a…

A: To find:- (a) the bestincluded angle θ for the channel, (b) the normal depth forpart (a), and (c)…

Q: Figure shows a horizontal flow of water through asluice gate, a hydraulic jump, and over a 6-ft…

A: Discharge,Q=cdHb2gy1Coefficient of…

Q: What is a sharp-crested weir? On what basis are the sharp-crested weirs classified?

A: When a masonry structure is constructed in a open channel to change it's water flow characteristics…

Q: Water at 10°C flows in a 6-m-wide rectangular channel at a depth of 0.55 m and a flow rate of 12…

A: Given data b=6 mQ=12 m3/secy=0.55 m

Q: Consider gradually varied ﬂow of water in a 20-ft wide rectangular channel with a ﬂow rate of…

Q: Consider steady flow of water in a downwardsloped channel of rectangular cross section. If the flow…

A: Froude number is obtained by the division of inertial force with the force caused due to the action…

Q: A triangular open-channel (n=0.014) has a side slope of 4H:5V. The flow depth is 1.5m when the slope…

Q: 2. A rectangular channel of 3m wide carries water at a rate of 13m³/s. At a certain point, there is…

A: given data wide (b) = 3m slope (S1) = 160 = 0.0166 slope (S2 ) = 1600 = 1.66×10-3 Manning…

Question

Water (p = 999.1ku = 1.13 x 10-3 k) in a 6-m-wide rectangular channel at a
%3D
depth of 1 m and a flow rate of 10 m/s. Determine: (1) the Froude Number; (2) whether
the flow is subcritical or supercritical; (3) critical depth, critical velocity, critical energy;
(4) specific energy.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A gravelly rectangular channel, 7 m wide and 2 m deep, isflowing at 75 m3/s on a slope of 0.013. (a) Is this on amild, critical, or steep curve? (b) Approximately howmany meters downstream will the gradually varied solutionreach the normal depth?
A trapezoidal channel with a bottom width of 6 m, free surface width of 12 m, and flow depth of 1.6 m discharges water at a rate of 80 m3/s. If the surfaces of the channel are lined with asphalt (n = 0.016), determine the elevation drop of the channel per kilometer.
In flowing from section (1) to section (2) along a rectangular open channel, the water depth decreases by a factor of three and the Froude number changes from a subcritical value of 0.7 to a supercritical value of 3.4. Determine the channel width at (2) if it is 8 ft. wide at section (1). Assume stead-state flow.
Water is to be transported at a rate of 10 m3/s in uniform flow in an open channel whose surfaces are asphalt lined. The bottom slope is 0.0015. Determine the dimensions of the best cross section if the shape of the channel is (a) circular of diameter D, (b) rectangular of bottom width b, and (c) trap e zoidal of bottom width b.
Consider uniform flow through an open channel lined with bricks with a Manning coefficient of n = 0.015. If the Manning coefficient doubles (n = 0.030) as a result of some algae growth on surfaces while the flow cross section remains constant, the flow rate will (a) double, (b) decrease by a factor of √2, (c) remain unchanged, (d) decrease by half, or (e) decrease by a factor of 21/3.
Water is discharged from a 5-m-deep lake into a finished concrete channel with a bottom slope of 0.004 through a sluice gate with a 0.7-m-high opening at the bottom. Shortly after supercritical uniform-flow conditions are established, the water undergoes a hydraulic jump. Determine the flow depth,velocity, and Froude number after the jump. Disregard the bottom slope when analyzing the hydraulic jump.
A clay tile V-shaped channel of included angle 60° isflowing at 1.98 m3/s on a slope of 0.33°. Is this a mild,critical, or steep slope? What type of gradually variedsolution curve are we on if the local water depth is (a) 1 m,(b) 2 m, or (c) 3 m?
Water flows uniformly in a rectangular channel with finished-concrete surfaces. The channel width is 3 m, the flow depth is 1.2 m, and the bottom slope is 0.002. Determine if the channel should be classified as mild, critical, or steep for this flow.
Water is flowing in a 90° V-shaped cast iron channel with a bottom slope of 0.0018 at a rate of 3 m3/s. Determine if the slope of this channel should be classified as mild, critical, or steep for this flow.
A gravelly earth-wide channel is flowing at 10 m3/s per meterof width on a slope of 0.75°. Is this a mild, critical, or steepslope? What type of gradually varied solution curve are weon if the local water depth is (a) 1 m, (b) 2 m, or (c) 3 m?
What is a sharp-crested weir? On what basis are the sharp-crested weirs classified?
Consider steady flow of water in a horizontal channel of rectangular cross section. If the flow is supercritical, the flow depth will (a) increase, (b) remain constant, or (c) decrease in the flow direction.