Answered: Wave Energy is non-conventional source…

Engineering

Electrical Engineering

Wave Energy is non-conventional source of energy Select one: True False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.25MCQ

See similar textbooks

Related questions

Q: Define inductance and capacitance and describe on what physical parameters they depend. Determine…

A: 1) To define inductance and capacitance And determine the energy stored in the capacitor and…

Q: 11. What kind of dependent source is this? How do you say so? Explain.

Q: Analyse the steady state error of the system ( I correct the question now please solve it )

A: For the given unity negative feedback system we need to calculate steady state error. Note : It is…

Q: 18/1.A. Draw the phasor diagram, also write the voltage and current relation statements for the…

A: Since it is an ac circuit the voltage and current will have phase angle between them. We will…

Q: Assuming that a nonzero ac source is applied, state whether the power and reactive power are…

A: Assume the power angle is θ and complex power is S, and the relation is given by, a). Pure…

Q: Find the power relations (real power, reactive power, apparent power, draw power triangle)

Q: A 60 Hz voltage of 230v effective value is impressed on an inductive of 0.265H. a.) Write the time…

A: In this question, We need to 1. Write the time equation for the voltage and the resulting current.…

Q: What impedance vector 10 + j22 represents: A. A pure resistance. C. A pure capacitance. B. A…

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to:

A: Vm=2Vrms =2×150Vm=212.13 V a- For purely resistive, phase angle- ϕm=0 i=Imsinwt=Im sin…

Q: Sketch the output waveform for vL in the following circuit if vs= Vm Sin(a t) Ideal Load

Q: The waveforms below represent one full cycle of the applied voltage vs and the supply current is.…

A: We can tell phase nature of waveforms by observing their peak positions with respect to time.

Q: lagging Pi determine the value of Cl if the current passing to it is 12.67 A. Also compute the input…

Q: The relation between current and admittance locus is the voltage False True

A: I=VY ohm's law,and Constant Voltage V, so the admittance locus Y represent the change in current I…

Q: na pure inductive circuit, connected to an ac source, the current in it leads the applied voltage by…

A: in a pure inductive circuit, connected to an AC source the current in it leads the applied voltage…

Q: Faraday and Henry are the units for inductance and capacitance. Select one: True False

A: In this question , we will write units of inductance and capacitance .

Q: 4. An emf e₁ = 100 sin 2л60t is in series with an emf e₂ = 120 sin 2л60t. a. Sketch the waveform of…

A: The emf connected in series can be added to form a single emf source. The given sinusoidal…

Q: V=100*sin(wt-75°), i=5*sin(wt-45°) V=100*sin(wt+35°), i=5*sin(wt+35°) V=100*sin(wt+20°) ,…

A: The given expression is- V=100×sinωt-75°, i=5×sinωt-45°V=100×sinωt+35°,…

Q: A resistor of R = 50Ω resistance is in series with a capacitor of C = 150μF. At t= 0, it is suddenly…

A: Given: Series RC circuit with R=50 Ω and C=150 μF DC source voltage, V=25 V Required current and…

Q: Q/What are the practical applications of the subject of Admittance and Current Locus

A: Consider the following circuit diagram,

Q: 1) For the circuit given in the figure (a) Draw the voltage and current reflection diagrams. (b)…

A: For the circuit given in the figure a)draw voltage and current reflection diagram b)plot voltage and…

Q: Alternating Current In Europe, the voltage of the alternating current coming through an electrical…

A: Here the value of voltage is given as v=-30sin(100πt) ..............(1) V is measured in volts ant t…

Q: 4. (30) For a given AC network shown in the figure, do the followings. a). Find inductor current b)…

Q: State the phase difference between voltage and current of an inductor in an AC circuit with one…

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

A: Given data, V=240 V, R=100 Ω, L=100 mH, C=100 μF, f=50 Hz Given circuit diagram,

Q: draw the voltage, current, and power waveforms in the case of AC applied to a pure inductor circuit.…

A: we need to draw voltage, current, and power waveforms in the case of AC applied to a pure inductor…

Q: When charging a capacitor, as discussed in conjunction with Figure , how long does it take for the…

A: Given: The diagram is given as:

Q: The waveform shown is characterized as direct current (DC). v(t) Triangle t A) True B) False

A: Wafe form is said to be DC if it does not vary with time I.e it has constant value irrespective of…

Q: Leading power factor implies that current leads voltage-a capacitive load Select one: True C False

Q: Design a 15v full wave power supply that will deliver a 1.5A of DC current to a load of 1kohms…

A: A full-wave rectifier is a circuit used for converting a full AC wave to a full DC wave. It consists…

Q: State the phase difference between voltage and current of a capacitor in an AC circuit with one…

Q: calculate the energy spect kat density at The following sisterten XCX) = [. else where Then…

Q: What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a 480 nF…

A: This is the series RLC circuit and concept of resonance Use fundamental formulas

Q: 29. A telephone circuit has a capacitance of 6 microfarads. What current flows through it when 15 V…

Q: p, i) Calculate the absolute value of the angle between voltage and current and then the power…

A: b,ii It is given that R=1.4 kΩ, C=89 nFVs=230V (rms)f=1.3 kHz Now calculate capacitive reactance…

Q: determine the equivalent inductance of this circuit below

A: Given : Brief description: Inductor is an element which is used to store the energy in the form of…

Q: A coil, with 100 mH Of Inductanče and resistance, has been CO UP 01 Da ower supply Vs(t)= 200…

Q: Q1: Explain in detail, the power factor and its value for the following AC circuits ahown figure…

A: To solve above problem, one should have basic idea about working of AC circuits. In ac circuits…

Q: Attempt five questions only Q1.) a) Derive the basic S.I units, then write the basic dimensions for…

A: Hii there!! Since there are two different questions in the image, I will be solving the first one.…

Q: https://matlab.mathworks.com/ Question 1 Which of the following best describes the average power…

Q: An AC circuit contains a 24-Ω resistor, a 15.9-mH inductor, and a 13.3-µF capacitor connected in…

A: R , L and C are connected in parallel hence voltage will be same across each VR=240 VVL=240 VVc=240…

Q: A circuit has inductance of 2h. If the circuit current changes at the rate of 10a/second, then self…

A: The inductance of the circuit is given as: L=2 H The rate of change of the current is given as:…

Q: The voltage across a charging capacitive circuit is described by the following V(t) = 10(1 - e)…

Q: 2.It is possible to use the voltmeter for measuring the non sinusoidal A.C voltages ? and is it…

A: Yes it is possible to use a voltmeter to measure non-sinusoidal AC voltage. Oscilloscope (CRO) is…

Q: Determine the equivalent inductance of the figure.

A: Brief description: For the given circuit by the clear identification of the placing of the dots we…

Q: In the circuit shown in the figure, the apparent power (S) of the second arm is given as 1490 VA.…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Wave Energy is non-conventional source of
energy
Select one:
O True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to polar and exponential form: (c) calculate A3=(A1+A2), giving your answer in polar form: (d) calculate A4=A1A2, giving your answer in rectangular form: (e) calculate A5=A1/(A2*) giving your answer in exponential form.
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor domain.
According to the Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of active power in the power plants whose power is greater than 50 KVA?
The power factor angle of a purely inductive circuit is 0 degrees Select one: True False
i. the current flows in the circuit. ii. the inductance iii. the capacitance iv. the maximum rms current in the circuit.
Discuss the importance of reactive power in maintaining voltage levels in a power system.
The current in a pure capacitor circuit is i=0.17cos500t. If the rms value of the impressed emf is 80 volts. a) What are the equation for the voltage and power? b) What is the circuit frequency?