We analyzed the biceps muscle example with the angle between forearm and upper arm set at 90° (see figure below).TricepsmuscleBicepsV musclePHYSICSCGFETmaWhCGWaFind the force exerted by the biceps muscle when the angle is 135° and the forearm is in a downward position. (Assume that r, = 6.0 cm, r = 14 cm, r, = 40 cm, m, = 2.0 kg, andm, = 3.4 kg. Enter the magnitude.)

Given Data :- The mass of the book is mb = 3.4 kg. The mass of the arm is ma = 2 kg. The distance…

We analyzed the biceps muscle example with the angle between forearm and upper arm set at 90 (see figure below). Triceps muscle Biceps muscle PHYSICS m. CG m, W. Find the force exerted by the biceps muscle when the angle is 135* and the forearm is in a downward position. (Assume that r- 6.0 om, r- 14 cm, r,- 40 cm, m, - 2.0 kg, and m, - 3.4 kg. Enter the magnitude.)

We analyzed the biceps muscle example with the angle between forearm and upper arm set at 90 (see figure below). Triceps muscle Biceps muscle PHYSICS m. CG m, W. Find the force exerted by the biceps muscle when the angle is 135* and the forearm is in a downward position. (Assume that r- 6.0 om, r- 14 cm, r,- 40 cm, m, - 2.0 kg, and m, - 3.4 kg. Enter the magnitude.)

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 85A

See similar textbooks

Similar questions

To pull with a force F=160 N on the scale as shown, what should the tension in your biceps muscle be? The distance h = 0.28 m.
Assuming a single muscle group (biceps) is responsible for carrying a ball with a weight of 5 kg as shown in the image below, what must be the force generated by the biceps so that the elbow is in static equilibrium? The weight of the forearm is 2 kg. The distance between the bicep attachment and elbow is shown as AO = 5 cm, the distance between the center of gravity of the forearm and elbow is BO = 20 cm, and the distance between the ball and elbow is CO = 40 cm.
If you are holding a 25lb weight in your hand 30cm from your elbow joint and your biceps brachii is generating a 30lb upward force at its attachment 5cm from the axis at 30° of elbow flexion, what will happen to the weight?
Suppose the biceps muscle was attached through tendons to the upper arm close to the elbow and the forearm near the wrist. What would be the advantages and disadvantages of this type of construction for the motion of the arm?
An athlete strengthens her leg and knee by doing "leg curls." While sitting on a bench with the leg initially bent at the knee, she supports a weight with the foot. She then slowly raises the foot and lower leg, with the upper leg held stationary. Find the tension in the quadriceps tendon for the position shown in the figure below. (Let w = 236 N,D = 44 cm and d = 5.5 cm.)
Consider a horizontal forearm. On one end of the forearm is the elbow, and on the other end is the hand. The forearm has a mass of 5.00 kg. The distance from the elbow to the hand is 34 cm. If the biceps muscle connects to the forearm a distance of 5.50 cm from the elbow, and the biceps muscle can supply a maximum force of 775. N (with the forearm in a horizontal position), what is the maximum mass (in kg) that the person can hold? (What equation can I use to solve this problem? Shouls I assume that the center of mass of the forearm to be midway/ in the middle between the elbow and the hand?)
Approximately what magnitude force, FM, must the extensor muscle in the upper arm exert on the lower arm to hold a 4.3-kg shot put (Figure 1)? Assume the lower arm has a mass of 3.0 kg and its CG is 13 cm from the elbow-joint pivot.
The triceps muscle at the back of her upper arm has an effective lever arm of 1.75 cm, and she exerts force on the floor at a horizontal distance of 20.0 cm from the elbow joint. Calculate the magnitude of the force in each triceps muscle, and compare it to her weight.
An athlete strengthens her leg and knee by doing "leg curls." While sitting on a bench with the leg initially bent at the knee, she supports a weight with the foot. She then slowly raises the foot and lower leg, with the upper leg held stationary. Find the tension in the quadriceps tendon for the position shown in the figure below. (Let w = 225 N, D = 44 cm and d = 5.5 cm.) Please help thank you
The biceps muscle exerts a muscle force of 1000N on the forearm, as per below. The muscle force acts at an angle of 30deg to the forearm. How large are the horizontal and vertical components of this force that holds the forearm in place?
The following figure represents a bicep curl maneuver where the center of mass (CoM) of a 23 kg dumbbell is 0.29 m from the elbow joint (pivot). The mass of the arm is 5 kg and acts 0.17 m from the elbow joint, and the biceps tendon acts at a distance of 0.01 m from the elbow joint. What is the required magnitude of the resultant joint reaction force (JRF) at the elbow in newtons (N) for the scenario described above in a) where static equilibrium is achieved.
From the step ladder shown in the figure, sides AC and CE are each 2.44 m long and hinged at point C. Bar BD is a tie-rod 0.762 m long, halfway up. A man weighing 845 N climbs 1.8 m along the ladder. Assuming the floor is frictionless and neglecting the mass of the ladder, find the tension (in N) in the tie-rod.