we have Capacitor with paralletplates c the distanse detueen thi platesare 2 cm e and th plate dimensionis 4 em x 5 cmif the voltage difference is 240Vcalculatea) Capacitance (c)b e) charge cQ)c) Electri field CE)SI unitEL-FFuse

a) We know the capacitance of the parallel plate capacitor , C= epsilon0×A/d, here A=4×5 cm2=20×10-4…

we have Capacitor with parallet plates cthe distanse detuein th plates are 2 cm e and tu plate dimension is 4 em x 5 cm if the voltage difference is 240V Calculate a) capacitance (c) b e) charge cQ) b dt) c) Electrii field CE) use SI unit L-FF

we have Capacitor with parallet plates cthe distanse detuein th plates are 2 cm e and tu plate dimension is 4 em x 5 cm if the voltage difference is 240V Calculate a) capacitance (c) b e) charge cQ) b dt) c) Electrii field CE) use SI unit L-FF

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter27: Capacitors And Batteries

Section: Chapter Questions

Problem 6PQ: According to UE=12C(V)2 (Eq. 27.3), a greater capacitance means more energy is stored by the...

See similar textbooks

Related questions

Q: A parallel plate capacitor has square plate of side 5cm^2 and separated distance of 1mm. Calculate…

A: Step 1: Explanation

Q: A parallel plate capacitor has surface dimension of 40.0 cm x 20.0 cm. The capacitor is connected to…

Q: The point charges are placed at the corners of a rectangle, shown in the figre. 12 em 15 em A…

A: It isn't clearly mentioned if we have to calculate change in potential energy of the system or of…

Q: A certain capacitor has rectangular plates 43 cm by 38 cm, and the gap width is 0.20 mm. What is its…

Q: 2.1 Show that the scale and vector potentials V and A are related to the source charges and currents…

Q: E2.3 What should be the area of the parallel plates to measure a capacitance of 1 F, if the…

A: Given data: Capacitance (C) = 1 F Separation between the plates (d) = 1 mm = 1 × 10-3 m ε0 = 8.85 ×…

Q: Suppose you have a parallel plate capacitor with a capacitance of 4.425 picofarads with a plate…

A: Concept:- The capacitance of a parallel plate capacitor is given by…

Q: Please help with part d.

Q: A parallel-plate capacitor was measured to have a capacitance of Co. What would be the new…

A: Initial capacitance = C0 initial area = A0 initial distance = d0

Q: 1. (II) Determine the rate at which the electric field changes between the round plates of a…

A: Given Diameter of the electric field is D=8.0 cm=8.0×10-2 m Separation between the plates is d=1.1…

Q: A parallel plate capacitor of 1.45 10 Farads Connected to a power supply that keeps a constant…

Q: Two large parallel plates are 2.0 cm apart. The strength of the electric field between them is 100.0…

A: Given: Electric field between the plates E=100 N/C, Distance between the plates dr=2 cm=0.02m.…

Q: 2 aton abcdefghe 주R rauh topb Wh d whidh point aore ha s higher potential? Cesistance aceh

A: a)Traversing the loop in clockwise direction and using KVL in the loop abcdefgha,

Q: A capacitor is composed of 2 plates separated by a sheet of insulating material 2mm thick and of…

A: Original capacitance with one dielectric C1=k1ε0Ad1 New capacitance with two dielectrics…

Q: With a partially-charged capacitor, will it take longer or shorter for a light bulb to stay lit?…

A: First of all light bulb is a resistor as current flows through its filament then due to the heating…

Q: A pair of circular parallel plates each with a diameter of 16.3 cm are separated by a gap of 5.5 mm.…

Q: A parallel-plate capacitor is made of two square plates 30 cm on a side and 1 mm opnectod to a 00-V…

A: Given:- The parallel plate capacitor is made of 30 cm square plate The distance between the plate…

Q: initial acceleration of electron

Q: The capacitor of a defribrillator with 1 μF is charged to 9000 V. Calculate the stored charge.

A: The stored potential energy in capacitor is by the Q=CVU=QV2U=CV22 Energy stored in the capacitor…

Q: A 2.1-µF capacitor is fully charged by a 6.0-V battery. Thebattery is then disconnected. The…

A: Given data The capacitance of the capacitor is C=2.1 μF. The potential difference of the battery is…

Q: In Figure 2, two parallel-plates capacitors (A and B) are connected in parallel across a 240 V…

A: The capacitance of a capacitor is vacuum is given by C =ε0Ad If a dielectric is inserted in the…

Q: Integrated ConceptsSingly charged gas ions are accelerated from rest through a voltage of 13.0 V. At…

A: The potential difference (Voltage), V = 13.0 V The elementary charge, q = 1.602 ×10-19 C Boltzmann…

Q: What is Imax shortly after the capacitor been fully charged, but before you start the discharge…

A: Shortly after the capacitor is fully charged, but before the discharge process Imax is zero .

Q: Two plates of area 30.0 cm² are separated by a distance of 0.0480 cm. If a charge separation of…

A: Given, the area of each plate, A= 30 cm2=30*10-4 m2 Separation distance, d= 0.0480 cm = 0.000480 m…

Q: Two parallel plates separated by 2.4 mm form a capacitor. The top plate has a voltage of -3 bolts,…

A: Inside of a parallel plate capacitor, the electric field is constant. And it is given by V=EdE=Vd

Q: A capacitor is composed of 2 plates separated permittivity 3. The distance between the plates is…

A: Given: The two capacitors are separated by sheet of insulating material of 2 mm. The…

Q: he capacitance noar on tho pl-

Q: Questiond A protun has a Speed of 4.0x10 m at point where electric s moves through a electric the…

Q: 2009 ow. 2 µF 2 F: 6 AF the

Q: Jwolpositivel chargesl qı land q2lare aligned along the x axia land separated byl distance sll as…

Q: The eleetrie field between the iner sad the outer surfaces of a cylindriesl capacitor carrying…

Q: A parallel-plate capacitor is constructed with pla separation of 0.10 mm. How much charge is sto…

A: GivenArea of plate, A=0.4 m2Distance of seperation between plates, d=0.1 mmPotential difference,…

Q: allel-plate capacitor in air arged to a potential diffen sed in distilled water. Ass e charge on the…

A: GivenDistance of seperation between plates , d=1.35 cmArea of plates ,A=35 cm2potential differene…

Q: Question 4 ras Yee You cre given ive scenares Fora parallel- plate capacitor: plates of surface area…

Q: Dry air will support a maximum electric field strenth of about 2.0 x 10^8 V/m.Above, the field…

A: Given data: Electric field strength, E=2.0×108V/m Distance of separation, d=3.5 cm=0.035 m

Q: Two capacitors, each of capacitance 1F ate charged to potential of 10V and 6V respectively. Then…

Q: Two capacitors with 2.0 F and 3.0 F capacitance, respectively, are connected in parallel. The…

A: Capacitor : A capacitor is a device for storing separated charge. It consists of two electrical…

Q: if a prton is placed at electric potential of -100v, it will move?

Q: When a potential difference of 150. V is applied to the platesof an air-filled parallel-plate…

A: Step 1 The capacitance of the parallel-plate capacitor is equal to where C is the capacitance and A…

Q: "hat is the charge on 6-uF capacitor after S is closed ra long time?

A: Charge on capacitor Q = CV

Q: Q. 1. Distance between two plates is 2 cm and-potential difference between them is 200 volt.…

A: Given Data : The distance between the two plates is given as d = 2 cm. The potential difference…

Concept explainers

Dielectric Constant Of Water

Water constitutes about 70% of earth. Some important distinguishing properties of water are high molar concentration, small dissociation constant and high dielectric constant.

Electrostatic Potential and Capacitance

An electrostatic force is a force caused by stationary electric charges /fields. The electrostatic force is caused by the transfer of electrons in conducting materials. Coulomb’s law determines the amount of force between two stationary, charged particles. The electric force is the force which acts between two stationary charges. It is also called Coulomb force.

Question

100%

we have Capacitor with parallet
plates c the distanse detueen thi plates
are 2 cm e and th plate dimension
is 4 em x 5 cm
if the voltage difference is 240V
calculate
a) Capacitance (c)
b e) charge cQ)
c) Electri field CE)
SI unit
EL-FF
use

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check Your Understanding The capacitance of a parallel-plate capacitor is 2.0 pF. If the area of each plate is 2.4 cm2, what is the plate separation?
Suppose that the capacitance of a variable capacitor can be manually changed from 100 pF to 800 pF by turning a dial, connected to one set of plates by a shaft from 0° to 180°. With the dial set at 180° (corresponding to C — 800 pF), the capacitor is connected to a 500-V source. After charging, the capacitor is disconnected from the source, and the dial is turned to 0°. If friction is negligible, how much work is required to turn the dial from 180° to 0°?
A parallel-plate capacitor with capacitance 5.0F is charged with a 12.0-V battery, after which the battery is disconnected. Determine the minimum work required to increase the separation between the plates by a factor of 3.
Find the capacitance of a parallel-plate capacitor having plates with a surface area of 5.00 m2 and separated by 0.100 mm of Teflon™.
Check Your Understanding Determine the net capacitance C of each network of capacitors shown below. Assume the C1= 1.0 pF, C2=2.0pF, C3=4.0pF, and C4=5.0 pF. Find the charge on each capacitor, assuming there is a potential difference of 12.0 V across each network.
When discharging a capacitor, as discussed in conjunction with Figure 21.39, how long does it take for the voltage on the capacitor to reach zero? Is this a problem?
Capacitors C1 = 6.0 F and C2 = 2.0 F are charged as a parallel combination across a 250-V battery. The capacitors are disconnected from the battery and from each other. They are then connected positive plate to negative plate and negative plate to positive plate. Calculate the resulting charge on each capacitor.
A 1-megabit computer memory chip contains many 60.0 1015-F capacitors. Each capacitor has a plate area of 21.0 1012 m2. Determine the plate separation of such a capacitor. (Assume a parallel-plate configuration.) The diameter of an atom is on the order of 1010 m = 1 . Express the plate separation in angstroms.
Check Your Understanding What is the potential energy of Q relative to the zero reference at infinity at r2 in the above example?
According to UE=12C(V)2 (Eq. 27.3), a greater capacitance means more energy is stored by the capacitor, but according to UE = Q2/2C (Eq. 27.2), a greater capacitance means less energy is stored. How can both of these equations be correct?
Consider a charge Q1(1+5.0C) fixed at a site with another charge Q2 (Charge +3.0C , mass 6.0g ) moving in die neighboring space, (a) Evaluate die potential energy of Q2 when it is 4.0 cm from Q1 (b) If Q2 starts from rest from a point 4.0 cm from Q1what will be its speed when it is 8.0 cm from Q1 ? (Note: Q1 is held fixed in its place.)
Capacitors C1 = 6.0 F and C2 = 2.0 F are charged as a parallel combination across a 250-V battery. The capacitors are disconnected from the battery and from each other. They are then connected positive plate to negative plate and negative plate to positive plate. Calculate the resulting charge on each capacitor.