What are some ways to test the strength of a vibration motor?

Q: an R-L circuit takes a current of 7amp that lags behind the 231-volt source by 35elec deg. calculate...

A:

Q: DEGREE: ELECTRICAL ENGINEERING  SUBJECT/COURSE: AC MACHINES   Answer these questions based on its...

A: A)  For starting of a synchronous motor a power supply is must needed which supply the power to roto...

Q: What is Mean Time Between Failure (MTBF)? O A measure of the service life of a component A predictio...

A: There are two most important terms MTBF (Mean time between failure) and MTTF (Mean time to failure)....

Q: ircuit using basic Q.2 A car locking system is to be designed with four inputs (D, B, A, and E) and ...

A: According to the company guidelines we can solve only first three sub parts kindly post another part...

Q: Solve for the admittance, Yab (magnitude only)

A:

Q: Given the two vectors rĄ = –ax – 3a, – 4az and rg = 2ax + 2a, + 2az, and point C(1,3,4), find: a. RA...

A: The solution is given below 

Q: 5.90 • Two blocks connected by a cord passing over a small, fric- tionless pulley rest on frictionle...

A: Here is your answer! I hope this will help you.

Q: A hand written solution is needed for each of the following problem/circuit below. You may submit yo...

A:

Q: In FET, An outward-pointing arrow represents ___. Choose the correct answer below: a.N-type substra...

A:

Q: PROBLEM SOLVING: Solve for what is being asked given the circuit below. Show complete, neat and orde...

A:

Q: olve for Vo1 and Vo2. ... Ge Si 4.7 ka 1.2 ka -10 V K K +12 Vo Ge 3.3 K2 (a) (b) . Vo1=Blank 1 V; Vo...

A:

Q: 12052 602 150 2 A 2002 1502 80.2 1808

A:

Q: Collector-feedback configuration 1.Draw the DC equivalent circuit. 2.Draw the fixed bias base emitt...

A:

Q: Log600

A: Logarithm A logarithm is defined as the power to which a number must be raised in order to get some ...

Q: As the load factor increases, the cost per kWh of energy generated may increase or decrease remains ...

A: In this answer we will find out what will happen to the cost per KWH of energy generated when the lo...

Q: Find the transfer function Y,IY, of the signal flow graph shown in Fig. 1.16.1. Ge -He G3 GA G2 Ys -...

A:

Q: 2. The coil having a resistance of 10 N and an inductance of 0.2 H is connected to a 100-V, 50-Hz su...

A: This question belongs to circuit theory . It is based on the calculation of impedance and power fact...

Q: 16. A faciory load of 900kw at 0.6 power factor lagging is to be increased tby the addition of a syn...

A:

Q: 2.114 Find the value of Vs in the network in Fig. P2.114. Vs 1 kN 1 kN 2Vx 1 kN Vx 1 kΩ 8 V 1 kN Fig...

A:

Q: A 220V. dc series motor is running at a speed of 800 rpm and draws 100 A. Calculate at what speed th...

A: Supply voltage, V = 220 V Initial speed of the motor, N1 = 800 r.p.m Armature current at speed N1, I...

Q: What will be the MMF required to produce a flux density of 0.88 T in an air gap of 8 mm?

A:

Q: What is lami's theorem

A: Theorem The theorem is a statement that has been proved or can be proved. Lami's theorem is useful t...

Q: Boolean Expression and don't care conditions are provided. Simplify F as a product of sums using k-m...

A: In this question we will simplify given boolean expression using k-Map...

Q: Determine V, I and the Power absorbed by each element in the given circuit.

A: Given circuit shown 

Q: In a LED design, a semiconductor Fe2O3 and ZnO is applied to produce light. From Table 4.1 and Table...

A: According to the question, we need to find the color of the light produced by Fe2O3 and ZnO.

Q: The characteristics equation of the series RLC circuit is:

A:

Q: Using the De N TMS thTM convert the SOP Boolean equation: complement. What is the range of values fo...

A:

Q: In a half wave rectifier, the input sine wave is 300 sin 100 Trt Volts. The average output voltage i...

A: Given: In a half wave rectifier the input sine wave voltage, vt=300 sin 100πt V Peak voltage, Vm=300...

Q: A 3-4, 440V, 11KVA, Y-connected cylindrical rotor alternator with synchronous reactance 8/phase is d...

A: Synchronous genertor or alternator is an AC electrical machine in which it's rotor winding is excite...

Q: Write all pertinent solutions including illustrations and box your final answer.  1. Determine the ...

A:

Q: Solve for the admittance, Yab, of the circuit shown. (magnitude only)

A:

Q: 5. Find the average power supplied by the source and average power absorbed by the resistor. ww 5/30...

A:

Q: coil has a resistance of 14 Q at 50°C. If the temperature coefficient of resistance at 0°C is 0.008/...

A:

Q: In the circuit shown, compute for the phase angle of the branch current, Id

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law and ...

Q: An infinitely long wire carrying the current / in the negative x direction is placed along the x-axi...

A:

Q: Consider a 1000-W iron whose base plate is made of 0.5-cm-thick aluminum alloy (p= 2770 kg/m3 and cp...

A: Please refer the attached images for the complete answer..

Q: A commercial establishment has a maximum demand of 1000 kW and a load factor of 40%. It buys electri...

A: This question belongs to electrical power system . It is based on the calculation of cost of power c...

Q: 6 UTM 5 UTM 8 U the accelerator is pressed occurs Q.2 A car locking system is to be designed with fo...

A: The truth table can be designed based on the given condition and the design can be obtained by using...

Q: QUESTION 15 For the step down transformer below the turns ratio is 5: 1, the primary voltage is 122 ...

A:

Q: 20: Given ddc=0.98 , determine Bac O Given Pdc=120 , determine the coriesponding valve of d. Te=2:0m...

A: Part (a)  - Given that,αdc = 0.98We know,The expression for β is givem by,β=α1-α  --(A)  

Q: In the unbalanced bridge circuit of the given figure, find the potential difference that exists acro...

A: Given: The unbalanced bridge circuit,

Q: The voltage v(t) across a device and the current i(t) through it are: v(t) = 19cos(2t) V, i(t) = 8(...

A: Given, Voltage, v(t)=19cos(2t) V Current, i(t) = 8(1−e-0.5t) A 

Q: The open circuit voltage is 14,000 volts of a 12,000 volts three- phase wye-connected turbo alternat...

A: The solution is given below 

Q: Choose one appliance/electronic device that needs application before it can be used and explain why

A:

Q: The voltage v(t) across a device and the current i(t) through it are: v(t) = 25cos(2t) V,  i(t) = 15...

A: The solution is given below 

Q: Q2. The current IcA in a balanced 3-phase A-connected load is 16 < -45°. If the phase sequence is po...

A:

Q: Voltage-Divider Bias Configuration 1.Draw the DC equivalent circuit. 2.Draw the fixed bias base em...

A:

Q: 2. The coil having a resistance of 10 N and an inductance of 0.2 H is connected to a 100-V, 50-Hz su...

A:

Q: 4.5 Voltage-Divider Bias Configuration 15. For the voltage-divider bias configuration of Fig. 4.125,...

A:

Q: 1.5 (a) Find the current and voltage of each diode in the circuit of Fig. P1.5. 15 V 30 kΩ 10 kΩ D1 ...

A:

Gear Motor

A gear motor is a combination of a gearbox and an electric motor. This combination of two systems is used for efficient usage of the motor. It makes a cost-effective solution for high torque, low-speed applications. These motors are used in our household as, garage door openers, alarm clocks. In commercial areas, hospital beds, cranes.