What are the advantages and disadvantage of with battery and without battery PV operated water pump

Q: 6. An AC precision integrator is desired for a particular application to perform the operation:…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A 5 KVA, 2300/230 V, 50 Hz transformer was tested for iron losses with normal excitation and copper…

A: GIVEN: A 5KVA, 2300/230 V, 50 Hz transformer was tested for iron losses with normal excitation and…

Q: 4. Write down the general expressions of frequency modulated signal and phase modulated signal. And…

A: Type of Modulation Frequency Modulation Phase Modulation  Amplitude Modulation  Pulse code…

Q: (b) (c) Apply Laplace transform to find the transfer function H(s). y"(t) − y' (t) — 2y(t) = x'(t) −…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A flow transmitter has an input range of 40 gallons per minute (GPM) to 130 GPM, using a standard…

A:

Q: Draw equivalent circuit of PV cell with explanation and labelling in details

A: PV cell:  It stands for Photo voltaic cell . It is also called as solar cell. It is a device which…

Q: GROUP 8 LRC series circuit connected in series with resistance of 4 ohms, a capacitor of 26 farad…

A: For the above given series RLC circuit we need to calculate the value of current flow in the…

Q: Write power quality issues and their characteristics

A: It is asked to write the power quality issues and their characteristics.

Q: A 10 mH inductor, a 1 uF capacitor, and a variable resistor are connected in parallel in the circuit…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: (a) Given the voltage-divider bias configuration of Figure 2. Assume R₁ = 56kN, R₂ = R2 8.2k, Rc =…

A: We need to find out the current and voltage for given circuit

Q: D1.8. Transform the following vectors to spherical coordinates at the points given: (a) 10ax at P(x…

A:

Q: what is variac? isadvantages please

A: An autotransformer is mostly used to modify line voltages in order to either change or maintain…

Q: When both switches in the figure are move to position 1, the anode to cathode voltage of D1 is equal…

A: The required voltage can be calculated by finding the state of the diode in the circuit and replace…

Q: A 5 KVA, 2300/230 V, 50 Hz transformer was tested for iron losses with normal excitation and copper…

A: It is given that: Pi=40W Pcu=112W. Power factor =0.8  KVA=5 V1/V2=2300/230 V

Q: Convert 100 watts of power into its equivalent power in dBm.

A: The solution is provided in the following section.

Q: +Q0 I R S1 (close at t=0)

A:

Q: Simplify Y = AB' + (A' + B)C.

A:

Q: For a QPSK system with the parameters mentioned below, determine: (a) Carrier power, in dBm. (b)…

A: (a) Carrier power, in dBm Pc(dBm) = 10 log (Carrier power in milli watt)              = 10 log…

Q: For this Differential Amplifier Circuit, assume 3 of both transistors is very high. Find the value…

A: Types of differential amplifier  Single input balanced output  Single input unbalanced output  Dual…

Q: then f(t) equals:

A:

Q: An LII system is represented by the following difference equation: y(n) = 0.5y(n-1) + 1.5y(n-3) +…

A: Given data, Function is given as, yn=0.5yn-1+1.5yn-3+2xn-0.8xn-2

Q: 7. Calculate the a and ß when the emitter current of BJT is equal to 1 mA and the collector current…

A: Given: In a BJT IE=1 mAIC=0.995 mA

Q: For op-amp circuit shown in fig. 10.80, Determine the bandwidth with feedback when the gain…

A: For the circuit shown in the figure, Gain * BW = 2.6 x 108 Hz   with feedback So if we are able to…

Q: In the QPSK modulator in the figure shown, the reference oscillator (as can be seen in the figure)…

A: QPSK offers excellent noise immunity. Low error probability is provided. A QPSK signal may be…

Q: For V₁(t)=20sin(wt), VD-0.6 and Vz=6.2V. a) State which diodes (and Zener diode) are on and which…

A: Mode of operation of zener diode  Forward biased mode ( behave as a normal On diode) Reverse biased…

Q: Derive an expression of per unit impedance of a given base MVA and base KV in term of new base MVA…

A: To derive the expression of per unit impedance  at a given base MVA and base KV in term of new base…

Q: E V.(2) Figure 10.1 A (2, 1, 3) binary convolutional encoder.

A: Convolutional Encoder: A(2,1,3) binary Convolutional Encoder states that k=1, n=2 and K=3 where k…

Q: The voltage drop percentage for a panel feeder with a no continuous load of 180A, using 3/0 THWN…

A: Given data, A 3/0 THWN copper conductors at 480 V Length, L=248' Load current, I=180 A

Q: 5. Please refer to the parallel-based clipper circuit shown below for this problem. For simplicity,…

A: Given:  Required: (a) Plot the output V0(t) for 0≤t≤T                  (b) Plot the voltage…

Q: Determine the Fourier series representation for the signal x (t) shown in Fig. P. 4.2.9.

A:

Q: Design an astable 555 timer circuit to produce 1kHz square wave, where TH=0.35 ms and T₁ = 0.65 ms.…

A: Given: Output frequency f= 1kHz.           TH=TON=0.35 ms           TL=TOFF=0.65 ms…

Q: If you want an LED to blink : O You need a digital to analog converter between the Arduino and the…

A: Arduino Uno The Arduino software is free and open-source, and it includes a development environment…

Q: Explain isolated operation of solar PV system

A: Solar PV system A photovoltaic system, also known as a PV system or solar power system, is an…

Q: How would the output of Circuit 2 been different if the op amp had not been used? In other  words,…

A: Given: Consider the following circuit: To find: How would the output of Circuit 2 be different if…

Q: 2. Find the Q- point for the diodes in the circuits shown below. Assume that the Zener diode has Von…

A: For the above given question by identifying status of both the diodes we need to compute Q points of…

Q: alent circuit for the network in fig 4. through terminals A B and C in fig 5. ΚΩ C 15 Ω 100 V 7Ω 11…

A: For the given electrical circuit we need determine its thevenin equivalent circuit for node A B.

Q: A continuous-time signal x(t) is sampled at a 10-Hz rate, with the resulting discrete-time signals…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 14. Consider the discrete-time signals that follow. For each signal, determine the fundamental…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: D6.27 The circuit of Fig. 6.27(a) is to be fabricated using a transistor type whose ß is specified…

A: The given circuit can be analyzed by using the DC analysis of the circuit. If the voltage at…

Q: Consider the following Transfer Function; G(s) = (s² + s-6) (s² - 2s + 6) (s² - 5s + 6) (s² + 2s +…

A:

Q: Problem 1: D1.8. Transform the following vectors to spherical coordinates at the points given: (a)…

A: It is given that: a)10ax at P x=-3,y=2,z=4b)10ay at Q ρ=5,ϕ=30°,z=4c)10az at M r=4,θ=110°,ϕ=120°

Q: 2) Aşagıdaki voltajlar ve empedans per-unit cinsinden verilmistir. a) Buna gore Ybus'i bulunuz? ell…

A:

Q: R(s) R(s)=1/s 1 Y(s) Ts+1 Figure 3 first order control system

A: For the given first order system we need to find its unit step response.

Q: Q1.) Calculate the power efficiency for the modulated signal shown below if R= 10". 3 ~ ~ O 2 2 1 2…

A: We need to find out power efficiency of given modulated signal

Q: 1 Given Vi=4mV, determine the Zi, Zo, Vo, and Av. (Non-anonymous question) V₂0H Ζ΄ 1.5 ΚΩ Z; +15 V…

A: The given circuit diagram is shown below: It is given that: IDSS=8 mA=8×10-3 AVP=-2.8 Vrd=40…

Q: The steady state stability limit of a synchronous machine connected to infinite bus is 2.2 p.u.…

A: Given: The steady state stability limit of synchronous machine, Pss=2.2 p.u. The infinite bus…

Q: What is the current gain for a common-base configuration where IE 4.2 mA and IC = 4.0 mA?

A:

Q: 3 2 0 2 3 45 6 7 *** 111413 2 -2-1 101 23456 (b) -2 (d) 2345678 Figure P9.2

A:

Q: 7. Space diversity s also known as a) Frequency diversity b) Antenna diversity c) Polarization…

A: The solution is provided in the following section.

Q: 10.23. Draw the block diagrams of both the direct forms I and II simulation diagrams for the systems…

A:

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.