What are the different between TEV and TEV with equalizer?

Q: What is the function of the folowing system. What is the benefit of vacuum boos Why is there a…

A: The vacuum booster is a metal canister with a diaphragm and a smart valve. On one side, a rod…

Q: While discussing secondary voltage: Technician A says that the normal required secondary voltage is…

A: Solution:

Q: A low pressure control has a high event and a differential setting. The technician wants the system…

A: Given: Starting pressure is 28 psig. Shut down pressure is 2 psig.

Q: List all the control modes for both engine crank and engine warmup.

A:

Q: Explain the difference between rotary and vortex fluid flow in a torque converter.

A: Inside the torque converter, there are two types of fluid flow. The vortex flow is the first, and…

Q: In which type thermocouple sensor, one of the wires is copper?

A: The answer is T type. A thermocouple is an electrical device consisting of two dissimilar electrical…

Q: of Disc check va

A: Stage 1 given; What the destroying and Assemble of stomach valve Also what is capacity of part than…

Q: What does do the exciter system in turbo generator unit? Sketch a block diagram of a typical exciter…

A: Given Generator To find Function of exciter Block diagram of working

Q: Which one of the following is a not electrical method of actuation,but it uses air to actuate…

A: Solution:

Q: - Name two things in the design of a reciprocating com pressor that control the efficiency of the…

A: The performance of the reciprocating compressor majorly depends on the two design factors.

Q: Two meshing ge ocity ratio Moc I, e=2 Pressure angle

A:

Q: Define intercooler and explain its function

A: Intercooler: It is a mechanical device which is used to cool a fluid in between the successive heat…

Q: What the dismantling and Assemble of diaphragm valve Also what is function of part than constant it

A: given; What the dismantling and Assemble of diaphragm valveAlso what is function of part than…

Q: What are the different inputs to the ECM/PCM to control the duty cycle of a Variable Valve Timing…

A: VVT system enhances fuel efficiency, and performance by emitting the right amount of gas in and out.…

Q: What is the maximum torque? to avoid damage from throttle r LAB T

A:

Q: The throttle opening is electronically controlled; the position When the throttle is fully open,…

A: Given Engine setup To find Role of Air filter Air temperature sensor Intake manifold (tumbler) valve…

Q: While discussing SFI systems: Technician A says that when the injection system fires according to…

A: The SFI system stands for Sequential Fuel Injection System. Within the SFI system, a specially…

Q: Q1: What are the components of air handling unit? And list the main difference between the air…

A: Air handling unit : It is device used for to regulate and circulate air as part of heating,…

Q: ts to the ecm/p

A: introduction: By emitting the proper quantity of gas in and out, the VVT system improves fuel…

Q: Based on the hydraulic circuit in Figure 4, (a) Explain how the system works?

A: Given Hydraulic circuit consist of  1. Reservoir  2. Filter 3. Pump 4. Pressure relief valve 5. 4/3…

Q: ot

A: introduction: This can be accomplished in one of two ways: through air cooling or through liquid…

Q: How does the automatic expansion valve respond to aload increase?

A: Expansion valves are the devices used to control the refrigerant flow in a refrigeration system.…

Q: timing diagram with IPO, IPC, TPO, TPC,EPO, EPC as 35,35,40,40,35,50

A: The port timing diagram for required functions with angle is shown below.

Q: When the throttle plates are closed in a port injectionsystem, where does the air needed for idle…

A: Port fuel injection on which fuel is delivered directly into the cylinder head or intake manifold of…

Q: what are the two tune up methods used for a variety of big bore cummins engines

A: There are two tune up methods used for a variety of big bore Cummins engines. OBC (Outer base…

Q: VOR can be tuned from the following places in most large body aircraft. Nav control panel MCDU…

A: To find: The VOR can be tuned from the following places in most large body aircraft. Explanation: A…

Q: the rotor has an oute le radius, the inlet bla ding velocity diagrams

A:

Q: what is an attenuator used for in vehicle

A: A attenuator is used in the vehicles. It is intended to absorb impact of high or low speed crash,…

Q: which one of the componets is used in Hydraulic systems only? a)counter balance valve b)Quick…

A: Let us discuss about hydraulic systems.

Q: How does the fault tolerance used by SONET work?

A: Fault tolerance is a feature of operating systems that allows them to adapt to hardware or…

Q: ticity of poly of nolvmer

A: Given data Modulus of elasticity = 1234567x 108 Fracture toughness = 0.4 J/m2 Failure stress = 1.75…

Q: The required gap in ignition system between---- O -0.4 to 5 O .-4 to 5 O 0.4 to 0.5 O .-4 to 0.5 O…

A: Required gap in ignition system in automobile generally 0.6 to 1.8 mm.  M15 is used for high…

Q: 1-Can the (watt )regulator be used for higher speeds? 2-What does regulator stability mean?

A: 1. No, the fan consumes the same amount of current operated at different speeds. As when you control…

Q: Explain the trip and drive cycle in an OBD II system.

A: On-board diagnostics (OBD) is an automotive term referring to a vehicle's self-diagnostic and…

Q: dew point is 6 0% of mixed a g coil in kW a

A: Given that v=0.8m3/st=32°C DBT v2=4 m3/sTe=22°CRH=55%dew point =6°C

Q: Q. What is the reason of having preheater before steam injector?

A: A preheater is a mechanical device that is used to heat the water before entering the boiler. A…

Q: What is the advantage of a variable intake system and what inputs are required by the ECM?

A: The variable intake system is an advance manifold technology incorporated in an internal combustion…

Q: frequency of vibratic

A: By using angular frequency formula.

Q: Tech A says that the weight of the flywheel smoothes out the engine’s power pulses. Tech B says that…

A: Flywheel: A flywheel is a mechanical device having higher value of moment of inertia. This high…

Q: pls do make an ntroduction about  Automatic Return of a Double  Acting Cylinder using Roller Lever…

A: DOUBLE ACTING CYLINDER A double acting cylinder is a chamber wherein the functioning liquid…

Q: 2. Draw and Explain the Circuit diagram for holding the cylinder of double acting cylinder in the…

A: Circuit diagram for holding the cylinder of double acting cylinder in the fully extended position…

Q: How can vou improve performance of engines to achieve more power

A: There are many ways to increase the performance of an IC ENGINE: 1) By using rich fuel mixture, peak…

Q: V- belt 40kw 80rad/sec 20rad/sec D2 800mm

A:

Q: explain briefly which input signals to the ECM control the turocharger ?

A: Turbocharger :- The turbocharger is used to boost the intake air temperature of an internal…

Q: a DCV, this part moves the spool, it can be a lever or a button a. operator b. springs c. spool…

A: The solution is attached below:

Q: A shunt generator is running at 1000 rpm. If flux is reduced by half, then what is * ?the new speed…

A: In shunt generator the flux is directly proportional to the speed.

Q: Control system evaluation about single and double acting cylinder and How it functions. What was the…

A: Control system : A control is used to manage or operate an required mechanism using a given input…

Q: Which of the following is not a base Sl unit?

A: Explanation 27 As we know that there are only seven fundamental unit which can we written as 1.…

Q: The two types of motors used for hermetic compressorsare _________ and _________.

A: There are basically four types of single-phase motors in use in hermetic assemblies: the permanent…