What are the expected readings of the following in the figure below? (R = 9.30 N, AV = 6.20 V) R Δν 10.0 N V 5.00 0 + R 4.50 V (a) ideal ammeter (Give your answer in mA.) mA (b) ideal voltmeter (Give your answer in volts.) V (c) What If? How would the readings in the ammeter (in mA) and voltmeter (in volts) change if the 4.50 V battery was flipped so that its positive terminal was to the right? ideal ammeter mA ideal voltmeter V

What are the expected readings of the following in the figure below? (R = 9.30 N, AV = 6.20 V) R Δν 10.0 N V 5.00 0 + R 4.50 V (a) ideal ammeter (Give your answer in mA.) mA (b) ideal voltmeter (Give your answer in volts.) V (c) What If? How would the readings in the ammeter (in mA) and voltmeter (in volts) change if the 4.50 V battery was flipped so that its positive terminal was to the right? ideal ammeter mA ideal voltmeter V

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter22: Electric Current

Section22.2: Using Electric Energy

Problem 31PP

See similar textbooks

Similar questions

Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
Why can a null measurement be more accurate than one using standard voltmeters and ammeters? What factors limit the accuracy of null measurements?
What is the output voltage of a 3.00-V lithium cell in a digital wristwatch that draws 0.660 mA, if the cell's internal resistance is 2.15 Ω? (Enter your answer to at least five significant figures.)V
Consider an electric diagram in the figure. When the switch in the circuit on the right is open, the voltmeter V reads 3.78 V. When the switch is closed, the voltmeter reading drops to 3.45 V, and the ammeter A reads 8.83 A. What is the battery internal resistance r (in Ω)?
The circuit in Figure has been connected for a long time. Taking R 1 = 2.00 Ω, R 2 = 7.00 Ω, R 3 = 8.00 Ω, R 4 = 1.00 Ω and C = 4.00 µF and ε = 15.0 V find the voltage across the capacitor? (Your result must be in volts. Include 2 digit after the decimal point and maximum of 3% of error is accepted in your answer.)
what are the readings indicated by the voltmeter and the ammeter in the situation shown in Figure a and Figure b? (answer. Va'b '= 8 V; Iaa' = 2 A; Vb'b = 0 V; Iaa '= 0 A). Present the calculations, if necessary.
How many 75-W lightbulbs, connected to 120 V as in the figure, can be used without blowing a 12 A fuse?(Figure 1) Express your answer as an integer. N=
Although an ideal voltmeter has an infinite internal resistance, this theoretical ideal is usually not met in practice. The voltmeter in the Figure has an internal resistance of 2 x 109 Ω and is used to measure the voltage across the resistor R2 as shown. Attaching this non-ideal voltmeter decreases the voltage across R2. Calculate the magnitude of this decrease using an emf of 10 V and R1 = R2 = 150 kΩ.
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 50-uF (micro-Farad) capacitor through a 75 M-Ohm (mega-ohm) resistor to 60.0% of its final voltage. Group of answer choices a)320 days b)57 minutes c)3.2x10^-2 sec d)4.5 minutes
What is the % conversion efficiency of a battery charger that inputs 22 W and outputs 1100 mA at 12 V?
A capacitor is charged to a potential of 12.0 V and is then connected to a voltmeter having a total internal resistance of 3.40 MΩ. After a time of 4.00 s the voltmeter reads 3.0 V. What are (a) the capacitance and (b) the time constant of the circuit?
A capacitor with a capacitance of 3.5 uF is initially uncharged. It is connected in series with a switch of negligible resistance, a resistor with a resistance of 10.5 kOhm, and a battery that has a potential difference of 105V. (a) Immediately after the switch is closed, what is the voltage drop VC, in volts, across the capacitor? (b) Immediately after the switch is closed, what is the voltage drop VR, in volts, across the resistor? (c) Immediately after the switch is closed, what is the current, in amperes, through the resistor? (d) Find an expression for the time after the switch is closed when the current in the resistor equals half its maximum value. (e) What is the charge Q, in microcoulombs, on the capacitor when the current in the resistor equals one half its maximum value.