Answered: What are the four processes that make…

What are the four processes that make up the simple ideal vapor compression refrigeration (VCR) cycle? Make sure you mention what is physically happening during each process

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.75P: Referring to Problem 1.74, how many kilograms of ice can a 3-ton refrigeration unit produce in a...

See similar textbooks

Related questions

Q: 7.18/A typical refrigeration (vapor-compression) cycle uses refrigerant 134a operating between the…

Q: Answer the following problem with complete solutions. Write legibly Refrigerant HFC-134a is…

Q: In a refrigeration cycle, the working fluid (refrigerant) absorbs heat from the surroundings in this…

Q: 4. How does the latent heat of water vary with the working pressure? Explain. 5. What is the kettle…

Q: What is the basic function of the compressor in a vapor compression refrigeration system? How is…

A: The compressor increases the pressure and temperature of the working fluid that flows through the…

Q: How do you determine the mass of bleed steam in an open heater ?

A: Draw a schematic diagram for the regenerative Rankine cycle for the open heater. Here, OFH stands…

Q: Properties of Carbon Dioxide: h@ 220 KPa and -5°C = 350 KJ/kg br@ 25°C = 223.65 KJ/kg b: @ 22°C =…

Q: R-134a enters the compressor of an ideal vapor-compression refrigeration cycle as saturated vapor at…

Q: Consider step 2 of the refrigeration cycle. Which of the following statements is the correct…

A: Option first is correct: An increase in pressure causes the refrigerant gas to evaporate.

Q: For a 15 ton capacity refrigeration system, the pressure of refrigerant in the evaporator is 150…

Q: The following properties for Freon-12 were obtained. At -22 °C h (superheat) = 353 KJ/kg ha = 343…

Q: What are the types of thermodynamic cycle as to the type of output? Define each

A: Any closed system that experiences numerous changes owing to temperature, pressure, and volume,…

Q: What is Carnot cycle, Rankine cycle and Refrigeration cycle

A: Carnot Cycle Carnot cycle is a theoretical cycle which is ideal for heat engine having 4 reversible…

Q: (2) A standard vapor compression system produces 20 tons of refrigeration using R-12 as a…

Q: A Freon-12 vapor compression system operating at a condenser temperature of 40 °C and an evaporator…

A: Given data Refrigerant - Freon 12 - R12 Condenser Temperature = T3 = 40oC Evaporator Temperature =…

Q: standard vapor compression system produces 20 tons of refrigeration using r-12 while operating…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Air operating in a closed cycle consists of the following processes. Process 1-2: Reversible…

A: Isentropic compression:- It is an adiabatic process where decrease in volume results in increase in…

Q: How To determine the energy transfer in the condenser system of the miniature steam power plant?

A: In a steam power plant, the condenser that is generally used is a shell and tube type heat…

Q: kg/sec of steam enters the condenser at 0.12 mpa and 10% mosture. what should be the mass of the…

A: Given:ms=9 Kg/secP=0.12 MPax=0.10Ti=32°CTf=42°C

Q: 2 kg of Refrigerant-134a contained in a piston-cylinder device undergoes a reversed Carnot cycle.…

Q: Steam leaves the boiler of a steam power plant at 400°C and 4MPa. The pressure of the condenser is…

A: Given, Turbine inlet Temperature , T1 = 400 C Turbine inlet pressure , P1 = 4 MPa Condenser…

Q: P18. An ideal vapor-compression refrigeration cycle (i.e., evaporator, compressor, condenser and…

A: The P-h diagram of the vapor compression cycle is given as, Process 1-2 is an Isentropic…

Q: (e) Draw a Carnot power cycle and a Carnot refrigeration cycle for an ideal gas on a T-S diagram.…

Q: A steam power plant operates on a thermodynamic cycle in which water circulates through a boiler,…

A: Given Data: The amount of heat supplied to the turbine is Qsuuplied=2100KJ/Kg The amount of heat…

Q: Why is the reversed Carnot cycle executed within the saturation dome not a realistic model for…

A: The T-s diagram of the reversed Carnot cycle is given as

Q: Calculate thermodynamic and isentropic efficiency of a turbine: Mass flow rate 5kg/s = Condenser…

Q: An air-conditioner which uses R-134a operates on the ideal vapor compression refrigeration cycle…

A: Given: Evapourator temperature→T1=T4=15°C and condensor temperature→T3=32°C

Q: Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine…

A: At state 1 P1=75KPa h1=hf=384.4 KJ/Kg v1=vF=0.001037 m3/Kg At state 2…

Q: Suppose you will install an air conditioner inside your room, Where should you install the appliance…

A: The installation of the air conditioning unit depends upon the region. where it is northern or the…

Q: Properties of Carbon Dioxide: h @ 220 KPa and -5°C = 350 KJ/kg h: @ 25°C = 223.65 KJ/kg h @ 22°C =…

Q: A Carnot cycle operates under the saturation dome of water in between the pressure of 7MPa and…

Q: Describe the ideal process for an adiabatic nozzle, and define the isentropic efficiency for each…

A: The nozzle is a mechanical device used to increase the velocity by decreasing the pressure.

Q: A refrigeration system using R-12 is to have a refrigerating capacity of 60 kW. The evaporating…

A: Given data as per question Refrigeration capacity =60 KW Evaporator temperature =-100 c Condensor…

Q: Assuming the refrigerant vapour to behave as an ideal gas and with perfect intercooling,the optimum…

Q: -thermodinamics 2 1. Give the ts and pv diagrams of regenerative rankine cycle 2. How do you…

A: Note: As per the Bartleby's guidelines, more than three parts of the same question asked. So, three…

Q: (2) A standard vapor compression system produces 20 tons of refrigeration using R-12 as a…

Q: How to define reversible process and irreversible processes.

A: A thermodynamic process in which the system, as well as the surroundings, can quickly restore to the…

Q: The refrigerant R-134a enters a throttling valve as a saturated liquid at 1400 kPa and leaves at 240…

A: The enthalpy of the refrigerant entering and leaving must be the same for the throttling process.…

Q: Question 3 In a vapour-compression refrigeration system, refrigerant - 134a enters the compressor…

A: Given, Refrigerant capacity (Q)=105kW The T-s diagram of the process is shown below, Solution Using…

Q: 2 kg of Refrigerant-134a contained in a piston-cylinder device undergoes a reversed Carnot cycle.…

A: Given: After the adiabatic compression, temperature is→T2=30°C=303.15 K Because after the adiabatic…

Q: The components of a Steam Power Plant in correct order are Evaporator, Condenser, Boiler, turbine…

A: The component of the steam power plant are in the order of Boiler-Turbine-condensor-Pump

Q: a. Sketch the process on a P-V diagram b. Determine the rate of heat transfer from Boiler ( Qcv/m…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: The COP of vapor-compression refrigeration cycles improves when the refrigerant is subcooled before…

A: The COP of a system is the useful heat supplied or removed to the work required to remove the heat…

Question

What are the four processes that make up the simple ideal vapor compression refrigeration (VCR) cycle? Make sure you mention what is physically happening during each process

Themodynamics question.

please explain briefly.Thank you

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Condensers in these refrigerators are all_______cooled.
Refrigerators currently being manufactured in the United States are using______as their refrigerant.
Referring to Problem 1.74, how many kilograms of ice can a 3-ton refrigeration unit produce in a 24-h period? The heat of fusion of water is 330 kJ/kg.
What are the approximate temperature ranges tor low-, medium-, and high-temperature refrigeration applications?
What are the two types of evaporators found in house-hold refrigerators?
The defrost cycle in a domestic refrigerator may be terminated by two methods: ___and___.
When the outside ambient air temperature is 90F, the temperature of the condensing refrigerant in a standard- efficiency unit should be approximately A. 120F. B. 130F. C. 140F. D. 150F.
Define flash gas, and explain how it applies to the net refrigeration effect of the refrigeration cycle.
you design a custom refrigeration system using 1,1,2-tetrafluoroethane (R-134a) as refrigerant.You design your ideal compression-based refrigeration cycle to operate between 2 bar and 9 bar. Before enteringthe ideal butterfly valve (delta H = 0), the refrigerant is a saturated liquid. Before entering the compressor, therefrigerant is saturated vapor. In fact, in isentropic operation, the refrigerant which leaves the compressor is alsosaturated vapor. The operation of the compressor and the evaporator is isobaric. Assuming a mass flow rate of1.5 kg / s, determine the compressor efficiency required to achieve a coefficient of performance of 6.96. Whatis ?? ̇ et ?? ̇ to this performance.
What is the COP of an ideal heat-operated refrigeration cycle that receives the energizing heat from a solar collector at a temperature of 70 °C, performs refrigeration at 15 °C, and rejects heat to atmosphere at a temperature of 40°C?
Refrigerator 1 simulates an ideal refrigerator and therefore operates on a Carnot cycle using R-134a as the refrigerant at a flow rate of 1.4 kg/sec. The condensing and evaporating temperatures are 30 °C and -10 °C, respectively. To assess the performance of Refrigerator 1, you must submit the report. of the project with the following information: d) The work generated by the turbine; e) The condenser heat rejection rate (Q H); f) The coefficient of performance of the cycle.
An ideal ammonia (R – 717) vapor-compression refrigeration cycle has an evaporator temperature of –20 C and a condenser pressure of 12 bar. Saturated vapor enters the compressor, and saturated liquid exits the condenser. The mass flow rate of the refrigerant is 3 kg/min. Determine the temperature of the superheated ammonia vapor exiting the compressor.