What are the properties of cast iron?

Q: A storm with I1.5 cm precipitation produced a direct runoff of 5.0 cm The duration of the rainfall…

A:

Q: Determine the importance and role of Unit Weight in the construction material utilization.

A: To determine the importance of unit weight of soil in construction material.

Q: An open tank containing oil (SG=0.8) is accelerated vertically at 3.07 s2 If the motion is upward…

A: Given data,  G = 0.8 Vertical acceleration = 3.07 m/s² Height below the surface = 1.77m To find out…

Q: Compute the current (express your answer in milli (103)) ANSWER:BIank 1

A:

Q: The Horton's infiltration equation for a basin is given by fp = 6 + 16e-2tt where fp is in mm/hr and…

A: The horton's infitration equation is fp=6+16·e-2t·tThis is in form of fp…

Q: A BEAM SECTION IS SHOWN IN THE FIGURE BELOW IS A SIMPLY SUPPORTED OVER A SPAN OF 8M. THE BEAM IS…

A: Given, f'c=28 MPaγc=23.6 kN/m3L=8 mP=350 kN

Q: Given data : Stress=33 N/mm2 Modulus of elasticity=55 N/mm2 Find strain

A: To Determine Strain

Q: Fig. P4.103 4104 Two 10-kN forces are applied to a 20 X 60-mm rectar as shown. Determine the stress…

A:

Q: Wo Wo /2 42 R2 Compute for the magnitude of the maximum flexural bending moment (kN-m] through the…

A:

Q: Problem 20.5 The origin of the secondary coordinate system shown is fixed to the center of mass G of…

A:

Q: the clay layer to reach 30% consolidation?

A:

Q: Given data : Stress=33 N/mm2 Modulus of elasticity=55 N/mm2 Find strain

A:

Q: Given data : Stress=33 N/mm2 Modulus of elasticity=55 N/mm2 Find strain

A: Given data: Stress=33 N/mm2  E=55 N/mm2

Q: Given data : Stress=33 N/mm2 Modulus of elasticity=55 N/mm2 Find strain

A:

Q: From the field notes of a closed traverse shown below, adjust the traverse. LINES BEARING DISTANCES…

A:

Q: A wood is floating in seawater (SG-1.03). Determine the volume (m) of the wood that is exposed to…

A:

Q: Determine the midspan deflection of the beam having a span of 24 m

A:

Q: Determine the amount of metal deck that needs to be purchased to construct the floor in following…

A: The given figure is shown below:

Q: Using Centroid by Composite Shapes, determine the x- and y-coordinates of the centroid of the shaded…

A:

Q: A saturated clay stratum draining both at the top and bottom undergoes 50% consolidation in 16 years…

A:

Q: 240 lb-ft 215 lb-ft 110 lb-ft (1) A (2) (3) B 36 in. 36 in. 36 in.

A:

Q: Determine the slope at point A and the deflection at point C. El = 20000Kn/m^2. Use area method.

A: Given,  There is a simply supported beam given in the question which is loaded with combination of…

Q: Car owners fill up when their tanks are exactly half full. At the present time, an average of 8.4…

A:

Q: (b) The following mix proportions for Im³ of concrete were obtained from a laboratory • Cement…

A: Assuming it is the capacity of mixers not mixtures which is 400 litre and assuming that this…

Q: Find the cross sectional dimensions of the smallest square beam that can be loaded as shown in the…

A:

Q: Find the ultimate Mu of the section of a beam with the following parameters: b = 300 mm, d = 550 mm,…

A: ultimate moment of the beam section is calculated by the formula= (Mu)= 0.156 fcu bd2

Q: A Example 1.4 The volume of atmosphere moisture is 12900 km3 and the flow rate of precipitation is…

A: Given Data: ● Volume of atmosphere moisture  (S) = 12900 km³ ●  Flow rate of Precipitation ( Q) =…

Q: Current Attempt in Progress A hollow aluminum rod (1) is connected to a hollow bronze rod (2) at…

A:

Q: Fig. P4.103 4.104 Two 10-kN forces are applied to a 20 x 60-mm rectangular bar as shown. Determine…

A:

Q: A building was constructed in stages over the last 25 years. It is desired to know the 2002…

A: Total cost of the origina building is = (100/23.9)*300000 = $1,255,000

Q: Neglecting the weight of the bar BCD which is supported by two steel cables uniform in size,…

A:

Q: A 300mm x 600mm beam is prestressed with 500kN with an eccentricity of 150mm below the neutral axis…

A:

Q: A clay layer 8 meter thick is subjected to a

A:

Q: eed in 1 hour pls, thanks! A hollow steel shaft 10 ft long must transmit a torque of 250,000 lb-in.…

A:

Q: consolidation. How many days will a 2 m thick layer of identical clay sandwiched between sand layers…

A:

Q: apacity a point

A:

Q: 1. On a 90-degree triangle weir, the measuring head of water is 600 mm. What length of Cipolletti…

A:

Q: A truck and trailer combination consists of three wheel loads: the rear axle is 4 kips, the middle…

A:

Q: Calculate the net deflection under service loads

A:

Q: a=7.2 m b=4 m a r:3m

A:

Q: 1. What is the distance (in mm) of the neutral x-axis from the indicated x-axis? (use two decimal…

A: As per the guidelines of Bartleby we are supposed to answer only first three subparts. We can assume…

Q: What must be radius of a circular curve for railway of chord length 30 m, where the degree of…

A: Given data: Chord length, L = 30 m Degree of curvature, D = 2°

Q: View Policies Current Attempt in Progress The steel pipe column shown has an outside diameter of…

A:

Q: Question 13 Classify the following soil using the U.S. Department of Agriculture textural…

A:

Q: 5.What is the moment of inertia (in mm4

A:

Q: A cylindrical tank having a base radius of 500 millimeters and a height of 2500 millimeters is…

A: To Determine 1. What is the unit weight of the liquid in the tank?  N/m^3 2. What is the density of…

Q: What must be radius of a circular curve for railway of chord length 30 m, where the degree of…

A: Given Data : Chord length = 30 m Degree of Curvature (D ) = 2° To determine: Radius (R)

Q: Question 16 Classify the following soils using the Unified soil classification system. Give the…

A: Given No. 4 = 100 No. 200 = 86 LL = 55 PL = 28

Q: Analyze the adequacy of the column to support the given load and moments. Neglect the weight of the…

A:

Q: 9.14 The soil profile for a future building construction site is shown in the following figure. The…

A: Solution- The given diagram is shown below, Given data,The proposed footing =6.0mq=200kN/m2To…

Temperature related material properties

Temperature-related properties of materials are the properties that change or show any variation with temperature variations. Various properties of materials include physical properties, mechanical properties, chemical properties, electrical properties, magnetic properties, etc. The chemical, electrical, and magnetic properties of materials are important, but the physical and mechanical properties are more important. Based on their composition and chemical bonding, materials are classified as metals, ceramics, polymers, and composites.