What does it mean when opamp is ideal?

Q: Explain the two types of feedback system (positive and negative types)

A: In this answer we will try to explain two predominant types of feedbacks that are employed in the…

Q: 8. What is the difference between a positive clamper and a negative clamper? Explain with the aid of…

A:

Q: What is the difference between a positive clamper and a negative clamper? Explain with the aid of…

A:

Q: What are the characteristics of an ideal op amp

A: The characteristics of ideal operational amplifier are as follows; The output impedance of ideal…

Q: How can I find the Vo and Io in this op-amp circuit?

A:

Q: What will be the output voltage of this opamp circuit?

A: The voltage Vb  will be :

Q: Consider the total harmonic distortion of a closed loop system is 5%. Distortion without feedback is…

A: As per the question, it is given that Distortion of a closed loop system = 5% Distortion without…

Q: Draw the signal flow diagrams for the algebraic equations below.Before drawing signal flow…

A: Given: Algebraic equations: (a) x1=-x2-3x3+3x2=5x1-2x2+x3x3=4x1+x2-5x3+5 (b)…

Q: a. From the maximum ratings found in the datasheet of LM324A, what is the maximum power supply…

A: The given circuit is an inverting type operational amplifier. The is a phase shift of 180 between…

Q: (c) Figure Q2(c) is the shunt voltage regulator system. Characteristic of the system can be found by…

A:

Q: )what's input resistance RIN? ) what are the currents in the inputs of opamp?

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Q5/ a) Define following terms: - N, Z, P, gain margin, and phase margin Control system

A: Through these definitions we are having the basic understanding of the Control system , in this…

Q: OPAMP"Amplifiers 2-Numerical five different applications for OPAMP

A: Operation amplifier: It is a device which a can be used for both AC & DC signal amplication and…

Q: Please give me the History of Linear and non-linear applications of OP-AMPS

A: Operational Amplifier - An operational amplifier is a type of integrated circuit that can enhance…

Q: Explain the difference between feedforward concurrent and feedback control

A: Control will concentrate on events before, during, or once a method. These sorts of controls square…

Q: Answer the following questions about Schmitt Trigger:   i. What is the upper and lower threshold…

A: Solution 1.

Q: Explain the operation of Negative clamping with circuit diagram and waveforms

A: According to question we have to Explain the operation of Negative clamping with circuit diagram and…

Q: Draw the Q-Point for the given current gain in figure-1 and explain its region of operation.

A: The solution can be achieved as follows.

Q: b) Explain what is meant by the terms: input offset voltage and slew rate with reference to opamps.

A: (a) It is given that: S=5 mV/°CReference Voltage=Vref=3.3 V The maximum range of the…

Q: 1. Op-amp can be used for non-linear applications, list any four applications. 2. Draw the circuit…

A: As there are two questions and we are asked to solve one question at a time. So, please mention the…

Q: 1- Mention any two non linear applications of op-amp.

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: What is the definition of amplification? How do you go about achieving it?

A: The explanation is as follows.

Q: 7. The slew rate for an open loop op-amp configuration is 0.66V/us and the input voltage is 10 mV,.…

A: The slew rate for an open-loop op-amp configuration is 0.66 V/μsμs and the input voltage is 10 mVpk.…

Q: compare a practical op-amp to an ideal op-amp

A: An operational amplifier is an integrated circuit that can amplify weak electric signals. An…

Q: How does a Buck-Boost Converter work? Mention the application of Buck-Boost Converter

A:

Q: Ideal characteristics of op-amp

A: The ideal characteristics of the op-amp are: The open loop gain of the ideal op-amp is infinite.…

Q: define series and shunt regulator

A: Ask to define series and shunt regulator. Regulator is one which stabilizes the load voltage with…

Q: For an ideal op-Amp differentiator circuit C = 10 uF and R = 10 kohm. If a triangular wave is fed…

A: Answer :- 10000 mV or 10 V peak square signal.

Q: One way to measure the slew-rate limitation of an op amp is to apply a sine wave (or square wave) as…

A: Given  Frequency of input sine wave is f =1 MHz The peak to peak amplitude of  output wave form is…

Q: 1- Mention any two non linear applications of op- amp.

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: What type of feedback is applied to an op amp when an external component is connected between the…

A: Inverting input means when we apply some input waveform, the output obtained is 1800 out of phase.

Q: How would I sketch the input-output relationship of op-amp comparators with hysteresis?

A: Consider an inverting Op-Amp comparator circuit as shown in Figure 1.

Q: Please explain slew rate limited of an Op-Amp and illustrate it with a drawing

A: Slew Rate : The greatest rate of output voltage change per unit time is known as the slew rate. The…

Q: Explain virtual short circuit of opamp.

A: Virtual short circuit is a property of operational amplifier. It can be explained with the help of…

Q: It was not necessary to use any coupling capacitors for the circuits in the(Linear Op-Amp Circuits)…

A: In general capacitors blocks the DC signal for the filtration of ripples. Purpose of op amp is to…

Q: . What is the difference between a positive clamper and a negative clamper? Explain with the aid of…

A:

Q: 1. Given the input voltage signal and the Op-Amp circuit, Plot the Output Waveform. (Power Supply…

A:

Q: the Advantages and Disadvatages DC-TO-DC Converter.

A:

Q: 24. An op-amp circuit is called inverting op-amp circuit because (a) the input voltage signal is…

A: In an ideal open open gain is infinite    Vo = AOL (VNONI -VINV) .   VNON= voltage across non…

Q: Figure shows a block diagram of a process con- troi system. Determine the range of the gain K for…

A:

Q: What opamp is this? Explain the equations?

A: Given :   In the question student is provided a solution of a question.   Student is asking more…

Q: 23. The figure to the right shows a generic op-amp differentiator. Let R2 = 100 kN and C1 = 0.01 µF.…

A: a) The ideal differentiator circuit can be drawn as Because of the gain and internal phase shifts…

Q: An Op-amp has a slew rate of 5 V/microsec. The largest sine wave output voltage possible at a…

A: Given, An Op-amp has, Slew rate= 5 Vμs Frequency, f= 1 MHz

Q: Multiplexer below (with depicting the internal structures). Indicate the input and outp on each…

A:

Q: 7. Which type of preamplifier plays a crucial role in reducing the effect of thermal noise? (a) Low…

A: High impedance preamplifier is used in communication system to reduce the added noise

Q: In order to control a DC motor from a computer : We need a DAC such that data will flow from…

A: Here we have to control the DC motor, dc motor has sensor which sense analog signal. Computer give…

Q: In the circuit in figure, what is Voc? Zth? Rl? Pmax?

A:

Q: in feedback control systems answer the ff. To produce the desired transient response, we ____…

A: Transient Response: A system's transient response is its reaction to a change in equilibrium or…

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.